2010 Lexus GX460 ECU

672
4-3. Do-it-yourself maintenance
GX460_CANADA (OM60F29U)
CAUTION
■Replacing light bulbs
●Turn off the headlights. Do not attempt to replace the bulb immediately after turn-
ing off the headlights.
The bulbs become very hot and may cause burns.
●Do not touch the glass portion of the light bulb with bare hands. Hold the bulb by
the plastic or metal portion.
If the bulb is scratched or dropped it may blow out or crack.
●Fully install light bulbs and any parts used to secure them. Failing to do so may
result in heat damage, fire, or water entering the headlight unit. This may damage
the headlights or cause condensation to build up on the lens.
■High-intensity discharge (HID) headlights
●Contact your Lexus dealer before replacing high-intensity discharge headlights
(including light bulbs).
●Do not touch the high-intensity discharge headlight’s high voltage socket when
the headlights are turned on.
An extremely high voltage of 20000 V will be discharged and could result in
death or serious injury by electric shock.
●Do not attempt to repair or disassemble light bulbs, connectors, electric circuits
or component parts.
Doing so may result in serious injury due to electric shock.
■To prevent damage or fire
●Make sure bulbs are fully seated and locked.
●Check the wattage of the bulb before installing to prevent heat damage.
GX460_CANADA.book Page 672 Thursday, February 4, 2010 11:54 AM

676
5-1. Essential information
GX460_CANADA (OM60F29U)
Emergency towingIf a tow truck is not available in an emergency, your vehicle may be tem-
porarily towed using a cable or chain secured to the emergency towing
hooks. This should only attempted on hard surfaced roads for short dis-
tances at low speeds.
A driver must be in the vehicle to steer and operate the brakes. The vehi-
cle’s wheels, drive train, axles, steer ing and brakes must be in good condi-
tion.
To w i n g h o o k
GX460_CANADA.book Page 676 Thursday, February 4, 2010 11:54 AM

692
5-2. Steps to take in an emergency
GX460_CANADA (OM60F29U)
■SRS warning light
This warning light system monitors the airbag sensor assembly, front airbag sensors,
side and curtain shield airbag sensors, rear side and curtain shield airbag sensors,
floor sensor, driver’s seat belt buckle switch, front passenger occupant classification
system, “AIR BAG ON” indicator light, “AIR BAG OFF” indicator light, front pas-
senger’s seat belt buckle switch, seat belt pretensioner assemblies, inflators, inter-
connecting wiring and power sources. (→P. 1 2 1 )
■Front passenger detection sensor and passenger seat belt reminder
●If luggage is placed on the front passenger seat, the front passenger detection
sensor may cause the warning light to flash, even if a passenger is not sitting in
the seat.
●If a cushion is placed on the seat, the sensor may not detect a passenger, and the
warning light may not operate properly.
■If the malfunction indicator lamp comes on while driving
First check the following:
●Is your vehicle low on gas?
If it is, refuel the vehicle immediately.
●Is the fuel tank cap loose?
If it is, tighten it securely.
The light will go off after taking several driving trips.
If the light does not go off even after several trips, contact your Lexus dealer as soon
as possible.
GX460_CANADA.book Page 692 Thursday, February 4, 2010 11:54 AM

714
5-2. Steps to take in an emergency
GX460_CANADA (OM60F29U)
Sounds
once
(Flashes)
• When the doors were unlocked
with the
mechanical key
and then the
“ENGINE
START STOP”
switch was
pressed, the
electronic key
could not be
detected in the
vehicle.
• The electronic
key could not be
detected in the
vehicle even
after the
“ENGINE
START STOP”
switch was
pressed two
consecutive
times.
Touch the elec-
tronic key to the
“ENGINE START
STOP” switch
while depressing
the brake pedal.
InteriorbuzzerExterior buzzerWarning messageDetailsCorrection
procedure
GX460_CANADA.book Page 714 Thursday, February 4, 2010 11:54 AM

5
When trouble arises
723
5-2. Steps to take in an emergency
GX460_CANADA (OM60F29U)
Taking out the spare tireRemove the spare tire carrier lid
using a flathead screwdriver.
Loosen each bolt, and assemble
the jack handle extension as
shown. Be sure to tighten each bolt
securely. (→P. 7 3 0 )
Insert the jack handle extension
into the lowering socket. Lower
Raise
Place a rag under the jack handle
extension to protect the bumper.
STEP1
STEP2
STEP3
GX460_CANADA.book Page 723 Thursday, February 4, 2010 11:54 AM

5
When trouble arises
727
5-2. Steps to take in an emergency
GX460_CANADA (OM60F29U)Loosen each bolt, and assemble
the jack handle extension as
shown. Be sure to tighten each bolt
securely. (
→P. 7 3 0 )
Raise the vehicle until the tire is
slightly raised off the ground.
Remove all the wheel nuts and the
tire.
When resting the tire on the
ground, place the tire so that the
wheel design faces up to avoid
scratching the wheel surface.
STEP5
STEP6
STEP7
GX460_CANADA.book Page 727 Thursday, February 4, 2010 11:54 AM

5
When trouble arises
729
5-2. Steps to take in an emergency
GX460_CANADA (OM60F29U)Firmly tighten each nut two or
three times in the order shown in
the illustration.
Tightening torque:
83 ft•lbf (112 N•m, 11.4 kgf•m)
Reinstall the wheel ornament.
Stowing the flat/spare tire, jack and tools
Lay down the tire with the outer
side facing up, and install the hold-
ing bracket.
Raise the tire.
Pull the tire towards the rear of the vehicle when raising. After
raising, visually check that the tire is not interfering with suspen-
sion components.
Stow the tools and jack securely, and replace all covers.
STEP4
STEP5
STEP1
STEP5STEP2
STEP5STEP3
GX460_CANADA.book Page 729 Thursday, February 4, 2010 11:54 AM

5
When trouble arises
731
5-2. Steps to take in an emergency
GX460_CANADA (OM60F29U)
CAUTION
■Using the tire jack
Improper use of the tire jack may lead to death or injuries due to the vehicle sud-
denly falling off the jack.
●Do not use the tire jack for any purpose other than replacing tires or installing and
removing tire chains.
●Only use the tire jack that comes with this vehicle for replacing a flat tire.
Do not use it on other vehicles, and do not use other tire jacks for replacing tires
on this vehicle.
●Always check that the tire jack is securely set to the jack point.
●Be sure to turn off the rear height control air suspension and stop the engine.
●Do not raise the vehicle while someone is in it.
●When raising the vehicle, do not put an object on or under the jack.
●Do not raise the vehicle to a height greater than that required to replace the tire.
●Use a jack stand if it is necessary to get under the vehicle.
●Do not put any part of your body under the vehicle supported by a jack.
●Do not start or run the engine while your vehicle is supported by the jack.
Take particular care when lowering the vehicle to ensure that no one working on or
near the vehicle may be injured.
■Using the jack handle
Tighten all the jack handle bolts securely using a Phillips-head screwdriver, to pre-
vent the extension parts from coming apart unexpectedly.
GX460_CANADA.book Page 731 Thursday, February 4, 2010 11:54 AM