Page 73 of 554

WARNING!
Improper installation of a child restraint to the
LATCH anchorages can lead to failure of an infant or
child restraint. The child could be badly injured or
killed. Follow the manufacturer’s directions exactly
when installing an infant or child restraint.
Installing Child Restraints Using the Vehicle Seat
Belt
The seat belts in the passenger seating positions are
equipped with an Automatic Locking Retractor to secure
a Child Restraint System (CRS). These types of seat belts
are designed to keep the lap portion of the seat belt tight
around the child restraint so that it is not necessary to use
a locking clip. The ALR will make a ratcheting noise if
you extract the entire belt from the retractor and then
allow the belt to retract into the retractor. For additional
information on ALR, refer to “Automatic Locking Mode”description under “Seat Belts in Passenger Seating Posi-
tions” section. The chart below defines the seating posi-
tions with an Automatic Locking Retractor (ALR) or a
cinching latch plate.
Left Center Right
CRS Lock CRS Lock CRS Lock
First Row ALR
Second Row ALR ALR ALR Third Row
Installing a Child Restraint with an ALR:
1. To install a child restraint with ALR, first, pull enough
of the seat belt webbing from the retractor to route it
through the belt path of the child restraint. Slide the latch
plate into the buckle until you hear a “click.” Next,
extract all the seat belt webbing out of the retractor and
then allow the belt to retract into the retractor. As the belt
retracts, you will hear a ratcheting sound. This indicates
the safety belt is now in the Automatic Locking mode.
72 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Page 74 of 554
2. Finally, pull on any excess webbing to tighten the lap
portion around the child restraint. Any seat belt system
will loosen with time, so check the belt occasionally, and
pull it tight if necessary.
To attach a Child Restraint tether strap:Route the tether strap over the seatback and attach the
hook to the tether anchor located on the back of the seat.
For the outboard seating positions, route the tether under
the head rest, and attach the hook to the tether anchor
located on the back of the seat.
Tether Strap Mounting (Two-Door Models)
Tether Strap Mounting (Four-Door Models)
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 73
Page 75 of 554

WARNING!
An incorrectly anchored tether strap could lead to
increased head motion and possible injury to the
child. Use only the anchor positions directly behind
the child seat to secure a child restraint top tether
strap.
Vehicles With Rear Web Buckles That May Need
To Be Twisted
•
In the rear seat, you may have trouble tightening the
lap/shoulder belt on the child restraint because the
buckle or latch plate is too close to the belt path
opening on the restraint. Disconnect the latch plate
from the buckle and twist the short buckle-end belt
several times to shorten it. Insert the latch plate into
the buckle with the release button facing out.
•If the belt still can’t be tightened, or if pulling and
pushing on the restraint loosens the belt, disconnect
the latch plate from the buckle, turn the buckle
around, and insert the latch plate into the buckle
again. If you still can’t make the child restraint secure,
try a different seating position.
Transporting Pets
Airbags deploying in the front seat could harm your pet.
An unrestrained pet will be thrown about and possibly
injured, or injure a passenger during panic braking or in
a collision.
Pets should be restrained in the rear seat in pet harnesses
or pet carriers that are secured by seat belts.
74 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Page 136 of 554

To Raise the Rear Seat
Raise the seatback and lock it into place. If interference
from the cargo area prevents the seatback from fully
locking, you will have difficulty returning the seat to its
proper position.
NOTE:If the rear seatback is not fully latched, the
center shoulder belt will not be able to be extended for
use. If you cannot extend the center shoulder belt, make
sure your seatback is fully latched.
WARNING!
Be certain that the seatback is securely locked into
position. If the seatback in not securely locked into
position the seat will not provide the proper stability
for child seats and/or passengers. An improperly
latched seat could cause serious injury.
TO OPEN AND CLOSE THE HOOD
Release both the hood latches.
Raise the hood and locate the safety latch, located in the
middle of the hood opening. Push the latch to the left side
of the vehicle, to open the hood. You may have to push
down slightly on the hood before pushing the safety
latch. Insert the support rod into the slot on the hood.
Hood Latch
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 135
Page 167 of 554
Lift the Freedom bag into the vehicle with the hooks and
straps facing the back of the rear seat. Attach the clips at
the bottom of the bag to the child restraint anchorages,
located at the base of the rear seat.Wrap the upper strap around the rear head restraints and
loop the strap through the buckle. Pull on the strap to
tighten the Freedom bag securely against the rear seat.
166 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 332 of 554

STARTING PROCEDURES
Before starting your vehicle, adjust your seat, adjust both
inside and outside mirrors, and fasten your seat belts.
WARNING!
Never leave children in the vehicle alone. Leaving
unintended children in a vehicle is dangerous for a
number of reasons. The child or others could be
seriously or fatally injured. The child could operate
power windows, other controls or move the vehicle.
Manual Transmission – If Equipped
Apply the parking brake, place the shift lever in NEU-
TRAL, and press the clutch pedal before starting the
vehicle. This vehicle is equipped with a clutch interlock-
ing ignition system. It will not start unless the clutch
pedal is pressed to the floor.Four-Wheel Drive Models Only
In 4L mode, this vehicle will start regardless of whether
or not the clutch pedal is pressed to the floor. This feature
enhances off-road performance by allowing the vehicle to
start when in 4L without having to press the clutch pedal.
The “4WD Indicator Light” will illuminate when the
transfer case has been shifted into this mode.
Automatic Transmission – If Equipped
Start the vehicle with the shift lever in the PARK position
(vehicle can also be started in NEUTRAL). Apply the
brake before shifting to any driving range.
Normal Starting
NOTE:
Normal starting of either a cold or a warm
engine is obtained without pumping or pressing the
accelerator pedal.
5
STARTING AND OPERATING 331
Page 538 of 554

Axle Lock.......................... 350,351
Battery ............................... 463
Keyless Transmitter Replacement (RKE) ....... 23
Belts, Seat ............................ 39,77
Body Mechanism Lubrication ............... 466
Brake Assist System ...................... 374
Brake Assist Warning Light ................. 259
Brake Control System, Electronic ............. 373
Brake System ........................... 476
Anti-Lock (ABS) .................... 371,373
Master Cylinder ....................... 476
Parking ............................. 369
Warning Light ........................ 248
Brake/Transmission Interlock ............... 340
Break-In Recommendations, New Vehicle ........ 75
Bulb Replacement ..................... 497,498
Bulbs, Light ............................ 79 Capacities, Fluid
........................ 501
Caps, Filler Fuel ............................... 416
Power Steering ........................ 368
Car Washes ............................ 483
Carbon Monoxide Warning ...............76,415
Cargo Light ............................ 140
Cargo (Vehicle Loading) ................... 418
Cellular Phone ........................ 88,317
Center High Mounted Stop Light ............ 500
Certification Label ....................... 418
Changing A Flat Tire ..................... 442
Chart, Tire Sizing ........................ 389
Check Engine Light (Malfunction Indicator
Light) ............................. 257,457
Checking Your Vehicle For Safety ............. 75
Checks, Safety ........................... 75
Child Restraint .................... 61,62,69,72
10
INDEX 537
Page 539 of 554

Child Restraint Tether Anchors.............67,69
Child Seat .............................. 66
Climate Control ......................... 317
Clock ..................... 269,283,285,288,297
Compact Disc (CD) Maintenance ............. 316
Compass .............................. 261
Compass Calibration ..................... 264
Computer, Trip/Travel .................260,261
Console .............................. 153
Console, Floor .......................... 153
Contract, Service ........................ 529
Cooling System ......................... 470
Adding Coolant (Antifreeze) .............. 472
Coolant Capacity ...................... 501
Coolant Level ......................... 474
Disposal of Used Coolant ................ 474
Drain, Flush, and Refill .................. 471
Inspection ........................... 470
Points to Remember .................... 475 Pressure Cap
......................... 473
Selection of Coolant (Antifreeze) .........471,501
Corrosion Protection ..................... 482
Cruise Light ........................... 251
Cupholders ............................ 152
Customer Assistance ..................... 527
Data Recorder, Event ...................... 60
Daytime Running Lights ................... 139
Dealer Service .......................... 458
Defroster, Rear Window ................... 239
Defroster, Windshield .............77,318,319,321
Delay (Intermittent) Wipers ................. 143
Diagnostic System, Onboard ................ 456
Dimmer Switch, Headlight ................. 138
Dipsticks Oil (Engine) .......................... 460
Power Steering ........................ 368
Disabled Vehicle Towing ................... 451
538 INDEX