2010 JEEP GRAND CHEROKEE tires

[x] Cancel search: tires

Page 306 of 466

JEEP GRAND CHEROKEE 2010 WK / 3.G Owners Manual The TPMS will continue to warn the driver of low tire
pressure as long as the condition exists, and will not turn
off until the tire pressure is at or above recommended
cold tire pressure. Once the lo

Page 307 of 466

JEEP GRAND CHEROKEE 2010 WK / 3.G Owners Manual CAUTION!
•The TPMS has been optimized for the original
equipment tires and wheels. TPMS pressures have
been established for the tire size equipped on your
vehicle. Undesirable system operation or se

Page 308 of 466

JEEP GRAND CHEROKEE 2010 WK / 3.G Owners Manual •Seasonal temperature changes will affect tire pressure,
and the TPMS will monitor the actual tire pressure in
the tire.
Base System
The Tire Pressure Monitor System (TPMS) uses wireless
technology

Page 309 of 466

JEEP GRAND CHEROKEE 2010 WK / 3.G Owners Manual pressures have been received. The vehicle may need to be
driven for up to 20 minutes above 15 mph (24 km/h) to
receive this information.
The Tire Pressure Monitoring Telltale Light will flash on
and o

Page 310 of 466

JEEP GRAND CHEROKEE 2010 WK / 3.G Owners Manual Tire Pressure Monitoring Telltale Light as long as none
of the road tires are below the low pressure warning
threshold.
•If your vehicle is not equipped with a matching
full-size spare wheel and tir

Page 311 of 466

JEEP GRAND CHEROKEE 2010 WK / 3.G Owners Manual NOTE:It is particularly important, for you to regularly
check the tire pressure in all of your tires and to maintain
the proper pressure.
The Tire Pressure Monitor System (TPMS) consists of the
follow

Page 313 of 466

JEEP GRAND CHEROKEE 2010 WK / 3.G Owners Manual NOTE:Your system can be set to display pressure units
in PSI, kPa, or BAR.
If the ignition switch is cycled, this sequence will repeat,
providing the system fault still exists. If the system fault
no

Page 314 of 466

JEEP GRAND CHEROKEE 2010 WK / 3.G Owners Manual case, theCHECK TPM SYSTEM message is then fol-
lowed by a graphic display, with pressure values still
shown. This indicates the pressure values are still being
received from the TPM Sensors. However