2010 JEEP COMMANDER wipers

▫Four-Way Passenger’s Power Seat
— If Equipped ....................... 88
▫ Head Restraints ...................... 89
▫ Front Heated Seats — If Equipped ......... 90
▫ Rear Heated Seats — If Equipped .......... 91
▫ 40/20/40 Second Row Folding Seat ........ 93
▫ 50/50 Third Row Folding Seat
— If Equipped ....................... 97
 Driver Memory Seat — If Equipped ......... 98
▫ Setting Memory Positions And Linking
Remote Keyless Entry Transmitter To
Memory ............................ 99
▫ Memory Position Recall ................ 100
▫ To Disable a RKE Transmitter Linked To
Memory ........................... 101 ▫
Easy Entry/Exit Seat .................. 102
 To Open And Close The Hood ............ 103
 Lights ............................. 104
▫ Multifunction Lever .................. 104
▫ Headlights And Parking Lights .......... 105
▫ Automatic Headlight System
— If Equipped ...................... 105
▫ Headlights On Automatically With Wipers . . 106
▫ Smartbeam™ — If Equipped ............ 106
▫ Automatic Headlight Leveling — HID
Headlights Only ..................... 107
▫ Daytime Running Lights — If Equipped .... 108
▫ Fog Lights — If Equipped .............. 108
▫ Instrument Panel And Interior Lights ...... 109
78 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

▫Battery Saver Feature — Exterior/Interior
Lights ............................ 110
▫ Lights-On Reminder .................. 110
▫ Turn Signals ........................ 110
▫ Lane Change Assist ....................111
▫ High/Low Beam Switch ................111
▫ Flash-To-Pass ........................111
▫ Headlight Off Delay ...................111
▫ Interior Lights .......................111
▫ Courtesy/Reading Lights ...............111
 Windshield Wipers And Washers .......... 112
▫ Windshield Wiper Operation ............ 113
▫ Windshield Washer Operation ........... 113▫
Mist ............................. 114
▫ Intermittent Wiper System .............. 114
▫ Rain Sensing Wipers — If Equipped ....... 115
 Tilt/Telescoping Steering Column .......... 117
 Adjustable Pedals — If Equipped .......... 117
 Electronic Speed Control — If Equipped ..... 119
▫ To Activate ......................... 120
▫ To Set a Desired Speed ................ 120
▫ To Deactivate ....................... 121
▫ To Resume Speed .................... 121
▫ To Vary The Speed Setting .............. 121
▫ To Accelerate For Passing .............. 121
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 79

This system performs two functions. With the engine
running and the multifunction lever in the AUTO posi-
tion, the headlights will turn on and off based on the
surrounding light levels.
Headlights On Automatically With Wipers
If your vehicle is equipped with Automatic Headlights it
also has this customer-programmable feature. When
your headlights are in the AUTO position, and the engine
is running, they will automatically turn on when the
wiper system is on. Refer to “Headlamps On with
Wipers” under “Electronic Vehicle Information (EVIC) —
Customer-Programmable Features” in Section 4.
If your vehicle is equipped with a “Rain Sensitive Wiper
System,” and it is activated, the headlights will automati-
cally turn on after the wipers complete five wipe cycles
within approximately one minute, and they will turn offapproximately four minutes after the wipers completely
stop. Refer to “Windshield Wipers and Washers” in this
section for more information.
NOTE:
When your headlights come on during the
daytime, the instrument panel lights will automatically
dim to the lower nighttime intensity. Refer to “Instru-
ment Panel and Interior Lights” below for setting the
instrument panel lights to full daytime intensity.
SmartBeam™ — If Equipped
The SmartBeam™ system provides increased forward
lighting at night by automating high beam control
through the use of a digital camera mounted on the
inside rearview mirror. This camera detects vehicle spe-
cific light and automatically switches from high beams to
low beams until the approaching vehicle is out of view.
106 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

by pressing the front recessed area of the lens. To turn
these lights off, press the recessed area of the lens a
second time.WINDSHIELD WIPERS AND WASHERS
The windshield wiper/washer control lever is located on
the right side of the steering column. The front wipers are
operated by rotating a switch, located on the end of the
lever. For information on the rear wiper/washer, refer to
“Rear Window Features” in this section.
Courtesy/Reading Lights
Windshield Wiper/Washer Switch
112 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Windshield Wiper Operation
Rotate the end of the lever upward to the LO position for
low-speed wiper operation.
Rotate the end of the lever upward to the HI position for
high-speed wiper operation.CAUTION!
Always remove any buildup of snow that prevents
the windshield wiper blades from returning to the
“park” position. If the windshield wiper switch is
turned off, and the blades cannot return to the “park”
position, damage to the wiper motor may occur.
Windshield Washer Operation
To use the washer, pull the lever toward you and hold
while spray is desired. If the lever is pulled while in the
delay range, the wiper will operate for several seconds
after the lever is released, and then resume the intermit-
tent interval previously selected.
If the lever is pulled while in the off position, the wipers
will operate for several wipe cycles, then turn off.
Front Wiper Control
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 113

WARNING!
Sudden loss of visibility through the windshield
could lead to an accident. You might not see other
vehicles or other obstacles. To avoid sudden icing of
the windshield during freezing weather, warm the
windshield with the defroster before and during
windshield washer use.
Mist
Use the Mist feature when weather conditions make
occasional usage of the wipers necessary. Pull down and
release the control lever for a single wiping cycle.
Intermittent Wiper System
Use one of the five intermittent wiper speeds when
weather conditions make a single wiping cycle, with a
variable pause between cycles, desirable. Turn the end of
the lever to one of the five delay positions for the desired
Mist Control
114 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

delay interval. The delay can be regulated from a maxi-
mum of approximately 18 seconds between cycles, to a
cycle every 1/2 second.
NOTE:The wiper delay times depend on vehicle speed.
If the vehicle is moving less than 10 mph (16 km/h),
delay times will be doubled.Rain Sensing Wipers — If Equipped
This feature senses moisture on the windshield and
automatically activates the wipers for the driver. The
feature is especially useful for road splash or overspray
from the windshield washers of the vehicle ahead. Rotate
the end of the multifunction lever to one of five settings
to activate this feature.
The sensitivity of the system can be adjusted with the
multifunction lever. Wiper delay position 1 is the least
sensitive, and wiper delay position 5 is the most sensi-
tive. Setting 3 should be used for normal rain conditions.
Settings 1 and 2 can be used if the driver desires less
wiper sensitivity. Settings 4 and 5 can be used if the
driver desires more sensitivity. Place the wiper switch in
the OFF position when not using the system.
NOTE:
•The Rain Sensing feature will not operate when the
wiper switch is in the low or high-speed position.
Front Wiper Control
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 115

Rotate the switch upward to the “On” position to
activate the rear wiper.
NOTE: The rear wiper operates in an intermittent mode
only. Rotate the switch upward to the “washer” position
to activate that rear washer. The washer pump will
continue to operate as long as the lever or ring is
engaged. Upon release, the wipers will cycle two times
before returning to the set position.
If the rear wiper is operating when the ignition is turned
OFF, the wiper will automatically return to the “park”
position if power accessory delay is active. Power acces-
sory delay can be cancelled by opening the door; if this
happens, the rear wiper will stop at its current position
and will not go to “park”.
If the liftgate flipper glass is open, connection to the rear
window wiper is interrupted preventing activation of the
rear wiper blade. When the liftgate flipper glass is closed,
the rear wiper switch, or the ignition switch, needs to be
turned OFF and ON to restart the rear wiper.
Rear Wiper/Washer Control
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 149