2010 INFINITI G37 navigation update

HOW TO USE INFO BUTTON The display screen shows vehicle and naviga-
tion (if so equipped) information for your con-
venience.
The information shown on the screen should be
a guide to determine the condition of the ve-
hicle. See the following for details.
Vehicle information display 1. Push the INFO button on the control panel.
2. Select an item from the INFO menu.
3. After viewing or adjusting the information
on the following screens, push the BACK
button to return to the INFO menu.
See the separate Navigation System Owner’s
Manual for the following items:
● Where am I?
● Traffic Info
● Weather Info
● Map Update
● Navigation VersionModels with navigation system SAA2478
Models without navigation system SAA1511
4-8 Monitor, climate, audio, phone and voice recognition systems
 —
—
04/21/10—debbie


Bluetooth  Audio player (models with
navigation system) ● Some Bluetooth  audio devices may not be
recognized by the in-vehicle audio system.
● It is necessary to set up the wireless connec-
tion between a compatible Bluetooth  audio
device and the in-vehicle Bluetooth  module
before using the Bluetooth  audio player.
● Operating procedure of the Bluetooth  audio
player will vary depending on the device.
Make sure it is understood how to operate
an audio device before using it with this
system.
● The Bluetooth  audio player may be stopped
under the following conditions:
– Receiving a hands-free call.
– Checking the connection to the hands-
free phone.
● Do not place a Bluetooth  audio device in an
area surrounded by metal or far away from
the in-vehicle Bluetooth  module to prevent
tone quality degradation and wireless con-
nection disruption.
● While an audio device is connected through
a Bluetooth  wireless connection, the bat-
tery power of the device may discharge
quicker than usual. ● This system supports the Bluetooth  Audio
Distribution Profile (A2DP, AVRCP).
● Bluetooth  is a trademark owned by
Bluetooth SIG, Inc. and licensed to Clarion
Co., Ltd.
Music Box hard drive Recording :
● Note that data that is lost and not stored to
the hard disk drive due to system damage,
improper operation or malfunction is not
under warranty.
● Vehicle owners are not permitted to record
music without permission of the owner of
the copyright except for personal use.
● Check if the music is appropriately recorded
to the hard disk drive after recording when
the compact disc cannot be rerecorded.
● Some music cannot be recorded depending
on the disc condition due to high-speed
recording.
● Jumping sounds may be recorded when a
compact disc is recorded while driving on
rough roads and excessive vibration occurs.
● A mark indicating jumping sounds is dis-
played if jumping sounds are recorded. ● No sounds may be recorded if jumping
sounds occurs or the disc is in poor condi-
tion.
● Tracks that include Serial Copy Management
System (SCMS) are not recorded.
● If a compact disc is scratched or dirty, it may
not be recorded, jumping sounds may occur
or it may take a long time to record.
Automatic title download :
● The title information that is automatically
downloaded may differ from the actual title.
● When newly released compact discs are
recorded, their title information may not be
downloaded.
● The title information in the hard disk can be
updated. (See “Playing recorded songs”
later in this section.
Monitor, climate, audio, phone and voice recognition systems
4-51
 —
—
04/21/10—debbie


1. Radio band select button
2. DISC·AUX button 1. AUX/Satellite band select button
2. Radio band select button
3. DISC button
FM-AM-SAT RADIO WITH COMPACT
DISC (CD) PLAYER For all operation precautions, see “AUDIO OP-
ERATION PRECAUTIONS” earlier in this section.
The satellite radio mode requires an active XM
Satellite Radio subscription. The satellite radio
is not available in Alaska, Hawaii and Guam.
It may take some time to receive the activation
signal after subscribing the XM Satellite Radio. After receiving the activation signal, an avail-
able channel list will be automatically updated
in the radio. For XM, push the ignition switch
from LOCK to ACC to update the channel list.
Audio main operation Head unit :
The auto loudness circuit enhances the low and
high frequency ranges automatically in both
radio reception and CD playback.
ON·OFF/Volume control :
Push the ignition switch to the ACC or ON
position, and then push the ON·OFF button
while the system is off to turn on the last audio
source (i.e. FM or CD), which was playing im-
mediately before the system was turned off.
While the system is on, pushing the ON·OFF
button turns the system off.
Turn the VOL control knob to adjust the volume.
Adjusting tone quality and speaker balance :
To adjust Bass, Treble, Balance and Fade, push
the Audio control knob. When the display
shows the setting you want to change (Bass,
Treble, Balance and Fade), rotate the Audio
control knob to set the desired setting. For the
other setting methods, see “HOW TO USE SET-
TING BUTTON” earlier in this section.Models with navigation system SAA1533
Models without navigation system SAA2922
4-54 Monitor, climate, audio, phone and voice recognition systems
 —
—
04/21/10—debbie


● First generation iPod nano  (version 1.3.1 or
later)
● Second generation iPod nano  (version 1.1.3
or later)
● Third generation iPod nano  (version 1.1 or
later)
● Fourth generation iPod nano  (version 1.0.2
or later)
Models without navigation system :
● Fifth generation iPod  (firmware version 1.3)
● First generation iPod Classic  (firmware ver-
sion 1.1.2 PC)
● Second generation iPod Classic  (firmware
version 2.0 PC)
● First generation iPod touch  (firmware ver-
sion 2.1)
● Second generation iPod touch  (firmware
version 2.1.1)
● First generation iPod nano  (firmware ver-
sion 1.3.1)
● Second generation iPod nano  (firmware
version 1.1.3)
● Third generation iPod nano  (firmware ver-
sion 1.1 PC)
Make sure that the iPod  version is updated. Audio main operation Push the ignition switch to the ACC or ON
position. Then, push the DISC·AUX or DISC
button repeatedly to switch to the iPod  mode.
If the system has been turned off while the
iPod  was playing, pushing the ON·OFF button
will start the iPod  .
or PLAY :
When the DISC·AUX or AUX button is pushed
with the system off and the iPod  connected,
the system will turn on. If another audio source
is playing and the iPod  is connected, push the
DISC·AUX or AUX button repeatedly until the
center display changes to the iPod  mode.
Interface :
The interface for iPod  operation shown on the
vehicle center display is similar to the iPod 
interface. Use the INFINITI controller and the
ENTER or BACK button to play the iPod  with
your favorite settings.
The following items can be chosen from the
menu list screen. For further information about
each item, see the iPod  Owner’s Manual.
● Now Playing
● Playlists
● Artists ● Albums
● Songs
● Podcasts
● Genres
● Composers
● Audiobooks
● Shuffle Songs
The following touch-panel buttons shown on
the screen are also available:
● : returns to the previous screen.
●
: plays/pauses the music selected.
Next/Previous Track and
Fast Forward/Rewind :
When the or button is pushed for
more than 1.5 seconds while the iPod  is play-
ing, the iPod  will play while fast forwarding or
rewinding. When the button is released, the
iPod  will return to the normal play speed.
When the or button is pushed for
less than 1.5 seconds while the iPod  is play-
ing, the next track or the beginning of the
current track on the iPod  will be played.
The INFINITI controller can also be used to
select tracks when the iPod  is playing.
4-72 Monitor, climate, audio, phone and voice recognition systems
 —
—
04/21/10—debbie


● Edit Name
Edit the name of the Playlist using the
keypad displayed on the screen. (See “HOW
TO USE INFINITI CONTROLLER” earlier in this
section.)
● Delete Songs
Delete tracks in the Playlist by selecting from
the displayed song list.
Play Mode (models with navigation system) :
Choose the preferred play mode from the fol-
lowing items.
● Normal
● 1 Album Repeat
● 1 Track Repeat
● 1 Playlist Random
● 1 Artist Random
● 1 Album Random
● 1 All Track Random
● 1 All Random Edit Music Information :
Displays the following information about the
Music Box hard drive to edit if necessary.
● Edit Information of Current Song (models
with navigation system)
Edit the “Track”, “Artist” and “Genre” infor-
mation of the current track using the keypad
displayed on the screen. (See “HOW TO USE
TOUCH SCREEN (models with navigation sys-
tem)” earlier in this section.)
Edit the “Mode” information by selecting
from the list.
● Edit Information by Album (models with navi-
gation system)
Edit the displayed name and of a selected
album and the track information in the al-
bum.
● Update Gracenote from USB Device (models
with navigation system)/Transfer Titles from
USB (models without navigation system)
Update the in-vehicle Gracenote Database
using a USB memory. Search the title from a
information acquired on the Internet.
Visit www.InfinitiUSA.com/music-update/
for details. ● Transfer Missing Titles to USB
Transfer the information of an album re-
corded without titles to a USB memory.
Visit www.InfinitiUSA.com/music-update/
for details.
● Update Gracenote from HDD
Search the title using the database in the
hard disk.
4-78 Monitor, climate, audio, phone and voice recognition systems
 —
—
04/21/10—debbie