Due to legal requirements in some states/areas
or provinces, your vehicle may be required to be
in what is called the “ready condition” for an
Inspection/Maintenance (I/M) test of the emis-
sion control system.
The vehicle is set to the “ready condition” when
it is driven through certain driving patterns.
Usually, the “ready condition” can be obtained
by ordinary usage of the vehicle.
If a powertrain system component is repaired or
the battery is disconnected, the vehicle may be
reset to a “not ready condition”. Before taking
the I/M test, check the vehicle’s
inspection/maintenance test readiness condi-
tion. Push the ignition switch to the ON position
without starting the engine. If the Malfunction
Indicator Light (MIL) comes on steady for 20
seconds and then blinks for 10 seconds, the I/M
test condition is “not ready”. If the MIL does not
blink after 20 seconds, the I/M test condition is
“ready”.
If the MIL indicates the vehicle is in a “not
ready” condition, drive the vehicle through the
following pattern to set the vehicle to the
“ready condition”. If you cannot or do not want
to perform the driving pattern, an INFINITI re-
tailer can conduct it for you.WARNING
Always drive the vehicle in a safe and prudent
manner according to traffic conditions and
obey all traffic laws.
1. Start the engine. Allow the engine to idleuntil the engine coolant temperature
gauge needle points between the C and H
(normal operating temperature).
2. Accelerate the vehicle to 55 MPH (88 km/h), then quickly release the accelera-
tor pedal completely and keep it released
for at least 10 seconds.
3. Quickly depress the accelerator pedal for a moment, then drive the vehicle at a
speed of 53 to 60 MPH (86 to 96 km/h) for
at least 9 minutes.
4. Stop the vehicle. Leave the engine run- ning.
5. Accelerate the vehicle to 55 MPH (88 km/h) and maintain the speed for 2 min-
utes.
6. Repeat steps 4 and 5 at least 10 times.
7. Quickly release the accelerator pedal completely and keep it released for at
least for 1 minute. Maintain the speed for
at least 5 minutes. 8. Stop the vehicle. Place the automatic
transmission selector lever in the P (Park)
or N (Neutral) position or the manual
transmission shift lever in the N (Neutral)
position.
9. Turn the engine off.
10. Start the engine and allow the engine to idle for at least 2 hours.
11. Place the ignition switch to the OFF posi- tion and leave the vehicle for at least 90
minutes.
If step 1 through 7 is interrupted, repeat the
preceding step. Any safe driving mode is ac-
ceptable between steps. Do not stop the engine
until step 7 is completed.
READINESS FOR INSPECTION/
MAINTENANCE (I/M) TEST
9-20Technical and consumer information
—
—
10/15/09—tbrooks
10 Index
A
ABS (Anti-lock Braking System) ........5-49
Advanced air bag system ...........1-39
Air bag system Advanced air bag system .........1-39
Door-mounted curtain side-impact
supplemental air bag system .......1-44
Front passenger air bag and status
light ..................... 1-41
Front-seat mounted side-impact
supplemental air bag system .......1-44
Air bag warning labels .............1-46
Air bag warning light ..........1-46 , 2-12
Air cleaner housing filter ...........8-17
Air conditioner Air conditioner service ...........4-35
Air conditioner specification label ....9-12
Air conditioning system refrigerant and
lubricant recommendations .......4-35
Automatic climate control ........4-28
In-cabin microfilter ............4-35
Operation (See automatic climate
control) ................... 4-28
Alarm, How to stop alarm
(see vehicle security system) .........2-26
Alcohol, drugs and driving ...........5-7
Antenna .................... .4-77
Anti-lock Braking System (ABS) ........5-49Anti-lock braking system (ABS) warning
light
....................... .2-9
Appearance care Exterior appearance care ..........7-2
Interior appearance care ..........7-4
Ashtrays
(See cigarette lighter and ashtrays) .....2-39
Audible reminders .............. .2-15
Audio operation precautions .........4-36
Audio system ................. .4-36
Audio system, Steering wheel
audio controls ................ .4-75
Auto closure ................. .3-28
Autolight system ............... .2-31
Automatic Automatic adjusting function (front
windows) ................. .2-46
Automatic climate control ........4-29
Automatic transmission fluid (ATF) ....8-11
Climate control .............. 4-28
Driving
with automatic transmission . . . 5-11
Automatic door locks ..............3-5
Automatic drive positioner ..........3-39
Automatic seat positioner ...........3-39
Average fuel consumption and speed . . . .2-23
Avoiding collision and rollover .........5-5 B
Battery ..................... .8-13
Battery Battery saver system ...........2-32
Intelligent Key ............... 8-21
Variable voltage control system .....8-15
Before starting the engine ...........5-10
Bluetooth hands-free phone system
(models with navigation system) .......4-78
Booster seats ................. .1-29
Brake Anti-lock Braking System (ABS) ......5-49
Brake and clutch fluid ...........8-11
Brake system ................ 5-45
Parking brake operation ..........5-17
Brake warning light .............. .2-9
Break-in schedule .............. .5-41
Brightness control and display ON/OFF
button ...................... .4-7
Brightness control, Instrument panel . . . .2-33
Bulb check/instrument panel .........2-8
Bulb replacement .............. .8-23
C
Cabin air filter ................ .4-35
Capacities and recommended
fuel/lubricants ................. .9-2
Car phone or CB radio .............4-77
—
—
04/30/10—diane
