2010 HONDA CIVIC SEDAN transmission

[x] Cancel search: transmission

Page 301 of 387

HONDA CIVIC SEDAN 2010  Owners Manual (in English) Check the f luid level with the engine
at normal operating temperature.If the level is below the lower
mark, add f luid into the dipstick
hole to bring it to the level
between the upper and lower
mark

Page 302 of 387

HONDA CIVIC SEDAN 2010  Owners Manual (in English) If Honda MTF is not available, you
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Certif ication Seal that says ‘‘FOR
GASOLINE ENGINES’’ as a
temporary replacement. However,

Page 303 of 387

HONDA CIVIC SEDAN 2010  Owners Manual (in English) The f luid level should be between
theMINandMAXmarksontheside
of the reservoir. If the level is at or
below the MIN mark, your brake
system needs attention. Have the
brake system inspected f or leaks

Page 304 of 387

HONDA CIVIC SEDAN 2010  Owners Manual (in English) Manual Transmission onlyAll models except Si and Canadian DX-G
with manual transmission
The f luid level should be between
theMINandMAXmarksontheside
of the reservoir. If it is not, add
brake f luid t

Page 318 of 387

HONDA CIVIC SEDAN 2010  Owners Manual (in English) If you check air pressures when the
tires are hot (driven f or several
miles/kilometers), you will see
readings 4 to 6 psi (30 to 40 kPa, 0.3
to 0.4 kgf/cm ) higher than the cold
readings.Thisisnormal

Page 323 of 387

HONDA CIVIC SEDAN 2010  Owners Manual (in English) Wheels:See page f or inf ormation about
DOT Tire Quality Grading, and page
f or tire size and labeling
inf ormation.
Tires: (DX, Canadian DX-G)
(Si)
(Si) (DX, Canadian DX-G with
automatic transmission

Page 327 of 387

HONDA CIVIC SEDAN 2010  Owners Manual (in English) Fill the f uel tank.Block the rear wheels.
If the vehicle is to be stored f or a
longer period, it should be
supported on jackstands so the
tires are of f the ground.
If you need to park your vehicle

Page 330 of 387

HONDA CIVIC SEDAN 2010  Owners Manual (in English) Turn on the hazard warning lights,
and turn the ignition switch to the
LOCK (0) position. Have all
passengers get out of the vehicle
while you change the tire. Park the vehicle on f irm, level, and
no