2010 HONDA ACCORD COUPE oil

Î Î
ÌÌ
µµÌ
Î
Maintenance Minder
309
Maintenance Main ItemsReplace engine oil Replace engine oil and oil filterInspect front and rear brakesCheck parking brake adjustmentInspect these items:Tie rod ends, steering gear box, and bootsSuspension componentsDriveshaft bootsBrake hoses and lines (including ABS/VSA)All fluid levels and condition of fluidsExhaust systemFuel lines and connections
Maintenance Sub ItemsRotate tiresReplace air cleaner element
Replace dust and pollen filter
Inspect drive belt Replace transmission fluidReplace spark plugsReplace timing belt and inspect water pump(V6 engine only)
Inspect valve clearance Replace engine coolant
:
AB
Symbol12
3 4
5
Symbol1 1
Inspect idle speed every 160,000 miles (256,000 km).
Adjust the valves during services A, B, 1, 2, or 3 only if they are noisy.
If the message ‘‘SERVICE’’ does not appear more than 12 months after the display is reset, change the engine oil every year.
Independent of the maintenance messages in the information display,replace the brake fluid every 3 years.
See information on maintenance and emissions warranty in the centercolumn on page .
NOTE:
1:
308
If you drive in dusty conditions, replace every 15,000 miles (24,000 km).
If you drive primarily in urban areas that have high concentrations of soot in the air from industry and fromdiesel-powered vehicles, replace every 15,000 miles(24,000 km).
If you drive regularly in very high temperatures (over 110°F, 43°C), or in very low temperatures (under 20°F,29°C), replace every 60,000 miles (U.S.)/100,000 km(Canada).
Maintenance Minder
——
y
y
)y
y
2010 Accord Sedan

Fluid Locations
4-cylinder models
310
ENGINE OIL FILL CAP
CLUTCH FLUID (ManualTransmission only)(Light gray cap)
AUTOMATIC TRANSMISSIONFLUID DIPSTICK(Yellow loop)
BRAKE FLUID(Black cap)
ENGINE OIL DIPSTICK (Orange handle)
POWER STEERING FLUID (Red cap)
WASHER FLUID (Blue cap)
RADIATOR CAP
ENGINE COOLANT RESERVOIR
——
y
y
)y
y
2010 Accord Sedan

Fluid Locations
V6 models
Maint enance
311
ENGINE OIL FILL CAP
BRAKE FLUID (Black cap)
AUTOMATIC TRANSMISSIONFLUID DIPSTICK(Yellow loop)
RADIATOR CAP
ENGINE OIL DIPSTICK (Orange loop)
POWER STEERING FLUID (Red cap)
WASHER FLUID (Blue cap)
ENGINE COOLANT RESERVOIR
——
y
y
)y
y
2010 Accord Sedan

Oil is a major contributor to your
engine’s perf ormance and longevity.
Always use a premium-grade 5W-20
detergent oil displaying the API
Certif ication Seal. This seal indicates
the oil is energy conserving, and that
it meets the American Petroleum
Institute’s latest requirements.
Unscrew and remove the engine oil
fill cap on top of the valve cover.
Pour in the oil slowly and caref ully so
you do not spill any. Clean up any
spills immediately. Spilled oil could
damage components in the engine
compartment.
Reinstall the engine oil f ill cap, and
tighten it securely. Wait a f ew
minutes, and recheck the oil level on
the engine oil dipstick. Do not f ill
above the upper mark; you could
damage the engine.
Recommended Engine Oil
A dding Engine Oil
312
ENGINE OIL FILL CAP
V6 models
ENGINE OIL FILL CAP
4-cylinder models
——
y
y
)y
y
2010 Accord Sedan

Honda Motor Oil is the pref erred
5W-20 lubricant f or your vehicle. It is
highly recommended that you use
Honda Motor Oil in your vehicle f or
optimum engine protection. Make
sure the API Certif ication Seal says
‘‘For Gasoline Engines.’’
Your vehicle does not require any oil
additives. Additives may adversely
af f ect the engine or transmission
perf ormance and durability.
The oil viscosity or weight is
provided on the container’s label.
5W-20 oil is f ormulated f or year-
round protection of your vehicle to
improve cold weather starting and
f uel economy.
You may use a synthetic motor oil if
it meets the same requirements
given f or a conventional motor oil: it
displays the API Certif ication Seal,
and it is the proper weight. You must
f ollow the oil and f ilter change
intervals shown on the information
display.
Synthetic Oil
Engine Oil A dditives
A dding Engine Oil
Maint enance
313
API CERTIFICATION SEAL
Ambient Temperature
——
y

y
)y
y
2010 Accord Sedan

Remove the oil f ilter and let the
remaining oil drain. A special
wrench (available from your
dealer) is required.
Open the hood, and remove the
engine oil f ill cap. Remove the oil
drain bolt and washer f rom the
bottom of the engine. Drain the oil
into an appropriate container.
Always change the oil and f ilter
according to the maintenance
messages shown on the inf ormation
display. The oil and f ilter collect
contaminants that can damage your
engine if they are not removed
regularly.
Run the engine until it reaches
normal operating temperature,
then shut it off.
Make sure the oil f ilter gasket is
not stuck to the contacting surface
of the engine. If it is, remove it
bef ore installing a new oil f ilter.
Changing the oil and f ilter requires
special tools and access f rom
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lif t f or this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
technician.
3.2.
1.
Changing the Engine Oil and Filter
314
OIL DRAIN BOLT
WASHER
OIL DRAIN BOLT
WASHER
V6 models4-cylinder models
——
y
y
)y
y
2010 Accord Sedan

Install a new oil f ilter according to
the instructions that come with it.
Refill the engine with the recom-
mended oil.
Engine oil change capacity
(including f ilter):
Let the engine run f or several
minutes, then check the drain bolt
and oil f ilter f or leaks.
Turn of f the engine, let it sit f or
several minutes, then check the oil
level on the dipstick. If necessary,
add more oil.
Make sure to clean of f any dirt
and dust on the contacting surf ace
of a new oil f ilter.
Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to:
Reinstall the engine oil f ill cap.
Start the engine. The oil pressure
indicator should go out within 5
seconds. If it does not, turn of f the
engine, and check your work.
4.
5.
6.
7.
8.
9.
V6 models
4-cylinder models
Changing the Engine Oil and Filter
Maint enance
315
V6 models
OIL FILTEROIL FILTER
4-cylinder models
4.2 US qt (4.0)
29 lbf·ft (39 N·m , 4.0 kgf·m)
4.5 US qt (4.3)
Improper disposal of engine oil can be
harmf ul to the environment. If you
change your own oil, please dispose of
the used oil properly. Put it in a sealed
container and take it to a recycling
center. Do not discard it in a trash bin
or dump it on the ground.
——
y

y
)yy
2010 Accord Sedan

Check the f luid level with the
transmission at normal operating
temperature and the vehicle sitting
on level ground.
Reinstall the under cover and put the
holding clips back in place. Make
sure the under cover is installed
under the edge of the f ront bumper.
If Honda MTF is not available, you
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Certif ication Seal that says ‘‘FOR
GASOLINE ENGINES’’ as a
temporary replacement. However,
motor oil does not contain the proper
additives, and continued use can
cause stif f er shif ting. Replace as
soon as it is convenient.
The transmission should be drained
and ref illed with new f luid according
to the maintenance minder (see page
).
If you are not sure how to check and
add f luid, contact your dealer.
Remove the transmission f iller bolt,
and caref ully f eel inside the bolt hole
with your f inger.
The f luid level should be up to the
edge of the bolt hole. If it is not, add
Honda Manual Transmission Fluid
(MTF) until it starts to run out of the
hole. Reinstall the f iller bolt, and
tighten it securely.
To check the transmission f luid level,
remove the under cover holding clips
with a flat-tip screwdriver, then
remove the under cover caref ully.
303
4-cylinder models
T ransmission Fluid
Manual Transmission
Maint enance
321
Correct level
FILLER BOLT
CLIPUNDER COVER
——
y
y
)yy
2010 Accord Sedan