Page 265 of 286
3. Fluid level should be at the
bottom of the opening.
4. Add enough fluid through the
filler opening so that the fluid level
is at the bottom of the opening.
5. Install and tighten the fill plug
securely.
Use only fluid that meets Ford specifications. Refer to theMaintenance
product specifications and capacitiessection in this chapter.
TRANSFER CASE FLUID (IF EQUIPPED)
1. Clean the filler plug.
2. Remove the filler plug and
inspect the fluid level.
3. Add only enough fluid through
the filler opening so that the fluid
level is at the bottom of the
opening.
Use only fluid that meets Ford specifications. Refer to theMaintenance
product specifications and capacitiessection in this chapter.
Maintenance and Specifications
265
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
Page 266 of 286

DRIVELINE UNIVERSAL JOINT AND SLIP YOKE
Your vehicle is equipped with universal joints that do not require
lubrication. If the original universal joints are replaced with universal
joints equipped with grease fittings, periodic lubrication will be
necessary.
AIR FILTER
Refer toscheduled maintenance informationfor the appropriate
intervals for changing the air filter element.
When changing the air filter element, use only the air filter element
listed. Refer toMotorcraftpart numbersin this chapter.
WARNING:To reduce the risk of vehicle damage and/or
personal burn injuries do not start your engine with the air
cleaner removed and do not remove it while the engine is running.
1. Loosen the clamp that secures the air inlet tube to the engine air filter
cover and disconnect the tube from the cover (for V6 only).
2. Release the clamps that secure the air filter housing cover.
3. Carefully separate the two halves
of the air filter housing.
4. Remove the air filter element from the air filter housing.
5. Wipe the air filter housing and cover clean to remove any dirt or
debris and to ensure good sealing.
Maintenance and Specifications
266
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
Page 267 of 286

6. Install a new air filter element. Be
careful not to crimp the filter
element edges between the air filter
housing and cover. This could cause
filter damage and allow unfiltered
air to enter the engine if not
properly seated.
7. Replace the air filter housing cover and secure the clamps.
8. Replace the air inlet tube and secure the clamp.
Note:Failure to use the correct air filter element may result in severe
engine damage. The customer warranty may be void for any damage to
the engine if the correct air filter element is not used.
MOTORCRAFT PART NUMBERS
Component 2.3L I4 engine 4.0L V6 engine
Air filter element FA-1744 FA-1744
Fuel filter FG-1036 FG-1036
Battery BXT-59 BXT-59
Oil filter FL-910 FL-820S
Spark plugs
1
1
For spark plug replacement, see your authorized dealer. Refer to
scheduled maintenance informationfor the appropriate intervals for
changing the spark plugs.
Replace the spark plugs with ones that meet Ford material and
design specifications for your vehicle, such as Motorcraftor
equivalent replacement parts. The customer warranty may be
void for any damage to the engine if such spark plugs are not
used.
Maintenance and Specifications
267
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
Page 277 of 286

Lifestyle
Ash cup / smoker’s package
Bed products
Cargo organization and management
Trailer hitches, wiring harnesses and accessories
TripTunes™ Advanced portable audio connection
Peace of mind
Keyless entry keypad
Remote start
Vehicle security systems
Wheel locks
For maximum vehicle performance, keep the following information in
mind when adding accessories or equipment to your vehicle:
•When adding accessories, equipment, passengers and luggage to your
vehicle, do not exceed the total weight capacity of the vehicle or of
the front or rear axle (GVWR or GAWR as indicated on the Safety
Compliance Certification label). Consult your authorized dealer for
specific weight information.
•The Federal Communications Commission (FCC) and Canadian Radio
Telecommunications Commission (CRTC) regulate the use of mobile
communications systems — such as two-way radios, telephones and
theft alarms - that are equipped with radio transmitters. Any such
equipment installed in your vehicle should comply with FCC or CRTC
regulations and should be installed only by a qualified service
technician.
•Mobile communications systems may harm the operation of your
vehicle, particularly if they are not properly designed for automotive
use.
•To avoid interference with other vehicle functions, such as anti-lock
braking systems, amateur radio users who install radios and antennas
onto their vehicle should not locate the Amateur Radio Antennas in
the area of the driver’s side hood.
•Electrical or electronic accessories or components that are added to
the vehicle by the authorized dealer or the owner may adversely affect
battery performance and durability.
Accessories
277
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
Page 285 of 286

for adults .......................79, 81–82
for children .............................101
lap belt ......................................80
Occupant Classification
Sensor ........................................76
safety belt maintenance .........117
warning light and chime ....84–85
Safety restraints - LATCH
anchors ......................................110
Safety seats for children ..........105
Safety Compliance
Certification Label ....................274
Satellite Radio Information ........38
Seats ............................................69
child safety seats ....................105
SecuriLock passive anti-theft
system ..........................................66
Servicing your vehicle ..............232
Setting the clock
AM/FM stereo ...........................20
AM/FM stereo CD .....................21
Premium AM/FM stereo
CD6/MP3 ...................................27
Snowplowing .................................7
Spark plugs,
specifications .....................267, 272
Special notice
ambulance conversions ..............7
utility-type vehicles ....................6
Specification chart,
lubricants ...................................268
Speed control ..............................59
Starting your vehicle ........159–161
jump starting ..........................210
Steering wheel
tilting .........................................56
T
Tilt steering wheel ......................56Tire Pressure Monitoring
System (TPMS)
Tires, Wheels and Loading ....135
Tires ...........................120–121, 201
alignment ................................128
care ..........................................125
changing ..........................201, 206
checking the pressure ............125
inflating ...................................122
label .........................................134
replacing ..................................126
rotating ....................................129
safety practices .......................128
sidewall information ...............130
snow tires and chains ............140
spare tire .................................201
terminology .............................122
tire grades ...............................121
treadwear ........................121, 125
Towing .......................................147
recreational towing .................157
trailer towing ..........................147
wrecker ....................................216
Transfer case
fluid checking .........................265
Transmission
automatic operation ...............174
brake-shift interlock (BSI) ....173
fluid, checking and adding
(manual) .................................264
fluid, refill capacities ..............268
lubricant specifications ..........268
manual operation ....................176
Turn signal ..................................48
V
Vehicle Identification Number
(VIN) ..........................................274
Vehicle loading ..........................140
Index
285
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)