4. Driving through deep water—the electrical system may be wet.
These temporary malfunctions can be corrected by filling the fuel tank
with good quality fuel, properly tightening the fuel cap or letting the
electrical system dry out. After three driving cycles without these or any
other temporary malfunctions present, the service engine soon
indicator should stay off the next time the engine is started. A driving
cycle consists of a cold engine startup followed by mixed city/highway
driving. No additional vehicle service is required.
If the service engine soon
indicator remains on, have your vehicle
serviced at the first available opportunity. Although some malfunctions
detected by the OBD-II may not have symptoms that are apparent,
continued driving with the service engine soon
indicator on can
result in increased emissions, lower fuel economy, reduced engine and
transmission smoothness, and lead to more costly repairs.
Readiness for Inspection/Maintenance (I/M) testing
Some state/provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle. Failure to pass this inspection could prevent
you from getting a vehicle registration. Your vehicle may not pass the I/M
test if the service engine soon
indicator is on or not working
properly (bulb is burned out), or if the OBD-II system has determined
that some of the emission control systems have not been properly
checked. In this case, the vehicle is considered not ready for I/M testing.
If the service engine soon
indicator is on or the bulb does not
work, the vehicle may need to be serviced. Refer to the On board
diagnostics (OBD-II) description in this chapter.
If the vehicle’s engine or transmission has just been serviced, or the
battery has recently run down or been replaced, the OBD-II system may
indicate that the vehicle is not ready for I/M testing. To determine if the
vehicle is ready for I/M testing, turn the ignition key to the on position
for 15 seconds without cranking the engine. If the service engine
soon
indicator blinks eight times, it means that the vehicle is not
ready for I/M testing; if the service engine soon
indicator stays on
solid, it means that the vehicle is ready for I/M testing.
Maintenance and Specifications
260
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
The OBD-II system is designed to check the emission control system
during normal driving. A complete check may take several days. If the
vehicle is not ready for I/M testing, the following driving cycle consisting
of mixed city and highway driving may be performed:
15 minutes of steady driving on an expressway/highway followed by
20 minutes of stop-and-go driving with at least four 30-second idle
periods.
Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature. Once started,
do not turn off the engine until the above driving cycle is complete. If
the vehicle is still not ready for I/M testing, the above driving cycle will
have to be repeated.
POWER STEERING FLUID
Check the power steering fluid. Refer to the scheduled maintenance
guide for more information.
•2.3L I4 engine
•4.0L V6 engine
1. Start the engine and let it run until it reaches normal operating
temperature (the engine coolant temperature gauge indicator will be
near the center of the normal area between H and C).
Maintenance and Specifications
261
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
2. While the engine idles, turn the steering wheel left and right several
times.
3. Turn the engine off.
4. Check the fluid level in the reservoir. It should be between the MIN
and MAX lines. Do not add fluid if the level is within this range.
5. If the fluid is low, add fluid in small amounts, until it reaches between
the MIN and MAX lines. Refer toMaintenance product specifications
and capacitiesin this chapter for the proper fluid type.
BRAKE FLUID
The fluid level will drop slowly as
the brakes wear, and will rise when
the brake components are replaced.
Fluid levels between the MIN and
MAX lines are within the normal
operating range; there is no need to
add fluid. If the fluid levels are
outside of the normal operating
range, the performance of the
system could be compromised; seek
service from your authorized dealer
immediately.
CLUTCH FLUID (IF EQUIPPED)
Check the fluid level. Refer toscheduled maintenance informationfor
the service interval schedules.
During normal operation, the fluid level in the clutch reservoir should
remain constant. If the fluid level drops, refill the fluid level to the step
in the reservoir.
Use only a DOT 3 brake fluid designed to meet Ford specifications. Refer
toMaintenance product specifications and capacitiesin this chapter.
WARNING:Carefully read cautionary information on product
label. For MEDICAL EMERGENCY INFORMATION contact a
physician or Poison Control Center immediately; on Ford-Motorcraft
products call: 1-800-959-3673 (FORD). Failure to follow these
instructions may result in personal injury.
Maintenance and Specifications
262
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
1. Clean the reservoir cap before
removal to prevent dirt and water
from entering the reservoir.
2. Remove cap and rubber
diaphragm from reservoir.
3. Add fluid until the level reaches
the step in the reservoir.
4. Reinstall rubber diaphragm and
cap onto reservoir.
TRANSMISSION FLUID
Checking automatic transmission fluid
•Refer toscheduled maintenance informationfor scheduled check
and change intervals.
•Transmission does not consume fluid.
•Check fluid when transmission is not operating properly or if you see
a leak.
•Fluid level must be checked at normal operating temperature, 20 miles
(30 km) of driving.
To check and add fluid:
1. Drive the vehicle 20 miles (30 km) to reach normal operating
temperatures.
2. If driven in hot weather, city traffic, pulling a trailer, allow
transmission to cool for 30 minutes before checking.
3. Engage parking brake, start engine.
4. Put your foot on the brake pedal and move the gearshift lever slowly
through all of the gear ranges.
5. Shift to P (Park) and leave the engine running.
6. Remove the dipstick, wipe clean with a dry lint free rag.
7. Install and fully seat the dipstick into the filler tube.
8. Remove the dipstick and inspect
the fluid level. Level should be in
the cross-hatched area.
Maintenance and Specifications
263
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
The Vehicle Identification Number (VIN) contains the following
information:
1. World manufacturer identifier
2. Brake system / Gross Vehicle
Weight Rating (GVWR) / Restraint
Devices and their location
3. Make, vehicle line, series, body
type
4. Engine type
5. Check digit
6. Model year
7. Assembly plant
8. Production sequence number
TRANSMISSION CODE DESIGNATIONS
You can find a transmission code on
the Safety Compliance Certification
Label. The following table tells you
which transmission each code
represents.
Description Code
Five-speed automatic (5R44E/5R55E) D
Five-speed manual (HD) J
Five-speed manual (R1) R
Maintenance and Specifications
275
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
A
ABS (see Brakes) .....................164
AdvanceTrac ..............................167
Air cleaner filter ...............266–267
Airbag supplemental restraint
system ....................................90, 98
and child safety seats ..............92
description ..........................90, 98
disposal ....................................100
driver airbag ..................90, 93, 99
indicator light ...................98, 100
operation .......................90, 93, 99
passenger airbag ...........90, 93, 99
side airbag .................................98
Ambulance packages ....................7
Antifreeze
(see Engine coolant) ................244
Anti-lock brake system
(see Brakes) ......................164–165
Anti-theft system ........................66
Audio system
(see Radio) ......................19, 21, 26
Automatic transmission ............174
driving an automatic
overdrive .................................174
fluid, refill capacities ..............268
fluid, specification ..................268
Auxiliary input jack (Line in) ....32
Auxiliary power point .................56
Axle
lubricant specifications ..........268
refill capacities ........................268
B
Battery .......................................242
acid, treating emergencies .....242jumping a disabled battery ....210
maintenance-free ....................242
replacement, specifications ...267
servicing ..................................242
Belt-Minder...............................85
Booster seats .............................114
Brakes ........................................164
anti-lock ...........................164–165
anti-lock brake system (ABS)
warning light ...........................165
fluid, checking and adding ....262
fluid, refill capacities ..............268
fluid, specifications .................268
lubricant specifications ..........268
parking ....................................166
shift interlock ..........................173
Bulbs ............................................48
C
Capacities for refilling fluids ....268
Cell phone use ..............................9
Changing a tire .........................201
Child safety seats ......................105
attaching with tether straps ..110
in front seat ............................106
in rear seat ......................106, 109
LATCH .....................................110
recommendations ...................103
Child safety seats - booster
seats ...........................................114
Cleaning your vehicle
engine compartment ..............227
instrument panel ....................229
interior .....................................230
plastic parts ............................228
safety belts ..............................230
washing ....................................225
waxing .....................................226
Index
281
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
wheels ......................................226
wiper blades ............................228
Clock adjust
AM/FM .......................................20
AM/FM stereo CD .....................21
Premium AM/FM stereo
CD6/MP3 ...................................27
Clutch
fluid ..........................................262
operation while driving ..........176
recommended shift speeds ....177
Console ........................................56
Coolant
checking and adding ..............244
refill capacities ................249, 268
specifications ..........................268
Cruise control
(see Speed control) ....................59
Customer Assistance ................188
Ford Extended Service
Plan ..........................................278
Getting assistance outside the
U.S. and Canada .....................222
Getting roadside assistance ...188
Getting the service you
need .........................................218
Ordering additional owner’s
literature .................................223
Utilizing the
Mediation/Arbitration
Program ...................................221
D
Daytime running lamps
(see Lamps) ................................45
Dipstick
engine oil .................................237
Driveline universal joint and
slip yoke ....................................266Driving under special
conditions ..................178, 181, 184
sand .........................................183
snow and ice ...........................185
through water .................183, 187
E
Emergencies, roadside
jump-starting ..........................210
Emergency Flashers .................189
Emission control system ..........258
Engine ........................................272
cleaning ...................................227
coolant .....................................244
idle speed control ...................242
lubrication specifications .......268
refill capacities ........................268
service points ..................234–235
starting after a collision .........190
Engine block heater .................162
Engine oil ..................................237
checking and adding ..............237
dipstick ....................................237
filter, specifications ........240, 267
recommendations ...................240
refill capacities ........................268
specifications ..........................268
Event data recording ....................7
Exhaust fumes ..........................162
F
Fluid capacities .........................268
Fog lamps ....................................44
Four-Wheel Drive vehicles .......178
driving off road .......................180
electronic shift ........................179
indicator light .........................179
Index
282
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
instrument panel, dimming .....45
interior lamps .....................48, 50
replacing bulbs .........................50
LATCH anchors .........................110
Lights, warning and indicator ....12
anti-lock brakes (ABS) ..........165
Load limits .................................140
Loading instructions .................147
Locks
doors ..........................................62
Lubricant specifications ...........268
Lug nuts ....................................210
M
Manual transmission .................176
fluid capacities ........................268
lubricant specifications ..........268
reverse .....................................177
Mirrors .........................................58
fold away ...................................59
side view mirrors
(power) ...............................58–59
Motorcraftparts ......231, 250, 267
O
Octane rating ............................254
Oil (see Engine oil) ..................237
P
Parking brake ............................166
Parts
(see Motorcraftparts) ...........267
Passenger Occupant
Classification Sensor ...................76Power distribution box
(see Fuses) ...............................194
Power door locks ........................62
Power mirrors .......................58–59
Power point .................................56
Power steering ..........................171
fluid, checking and adding ....261
fluid, refill capacity ................268
fluid, specifications .................268
Power Windows ...........................57
Preparing to drive your
vehicle ........................................172
R
Radio ................................19, 21, 26
Recommendations for
attaching safety restraints for
children ......................................103
Relays ........................................190
Remote entry system .................62
illuminated entry ......................65
locking/unlocking doors ...........63
panic alarm ...............................63
replacing the batteries .............64
Roadside assistance ..................188
S
Safety Belt Maintenance ..........117
Safety belts (see Safety
restraints) ............ 75, 78–79, 81–83
Safety Canopy .......................98–99
Safety defects, reporting ..........224
Safety restraints .. 75, 78–79, 81–83
Belt-Minder.............................85
extension assembly ..................84
Index
284
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)