4. Driving through deep water—the electrical system may be wet.
These temporary malfunctions can be corrected by filling the fuel tank
with good quality fuel, properly tightening the fuel cap or letting the
electrical system dry out. After three driving cycles without these or any
other temporary malfunctions present, the service engine soon
indicator should stay off the next time the engine is started. A driving
cycle consists of a cold engine startup followed by mixed city/highway
driving. No additional vehicle service is required.
If the service engine soon
indicator remains on, have your vehicle
serviced at the first available opportunity. Although some malfunctions
detected by the OBD-II may not have symptoms that are apparent,
continued driving with the service engine soon
indicator on can
result in increased emissions, lower fuel economy, reduced engine and
transmission smoothness, and lead to more costly repairs.
Readiness for Inspection/Maintenance (I/M) testing
Some state/provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle. Failure to pass this inspection could prevent
you from getting a vehicle registration. Your vehicle may not pass the I/M
test if the service engine soon
indicator is on or not working
properly (bulb is burned out), or if the OBD-II system has determined
that some of the emission control systems have not been properly
checked. In this case, the vehicle is considered not ready for I/M testing.
If the service engine soon
indicator is on or the bulb does not
work, the vehicle may need to be serviced. Refer to the On board
diagnostics (OBD-II) description in this chapter.
If the vehicle’s engine or transmission has just been serviced, or the
battery has recently run down or been replaced, the OBD-II system may
indicate that the vehicle is not ready for I/M testing. To determine if the
vehicle is ready for I/M testing, turn the ignition key to the on position
for 15 seconds without cranking the engine. If the service engine
soon
indicator blinks eight times, it means that the vehicle is not
ready for I/M testing; if the service engine soon
indicator stays on
solid, it means that the vehicle is ready for I/M testing.
Maintenance and Specifications
260
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
wheels ......................................226
wiper blades ............................228
Clock adjust
AM/FM .......................................20
AM/FM stereo CD .....................21
Premium AM/FM stereo
CD6/MP3 ...................................27
Clutch
fluid ..........................................262
operation while driving ..........176
recommended shift speeds ....177
Console ........................................56
Coolant
checking and adding ..............244
refill capacities ................249, 268
specifications ..........................268
Cruise control
(see Speed control) ....................59
Customer Assistance ................188
Ford Extended Service
Plan ..........................................278
Getting assistance outside the
U.S. and Canada .....................222
Getting roadside assistance ...188
Getting the service you
need .........................................218
Ordering additional owner’s
literature .................................223
Utilizing the
Mediation/Arbitration
Program ...................................221
D
Daytime running lamps
(see Lamps) ................................45
Dipstick
engine oil .................................237
Driveline universal joint and
slip yoke ....................................266Driving under special
conditions ..................178, 181, 184
sand .........................................183
snow and ice ...........................185
through water .................183, 187
E
Emergencies, roadside
jump-starting ..........................210
Emergency Flashers .................189
Emission control system ..........258
Engine ........................................272
cleaning ...................................227
coolant .....................................244
idle speed control ...................242
lubrication specifications .......268
refill capacities ........................268
service points ..................234–235
starting after a collision .........190
Engine block heater .................162
Engine oil ..................................237
checking and adding ..............237
dipstick ....................................237
filter, specifications ........240, 267
recommendations ...................240
refill capacities ........................268
specifications ..........................268
Event data recording ....................7
Exhaust fumes ..........................162
F
Fluid capacities .........................268
Fog lamps ....................................44
Four-Wheel Drive vehicles .......178
driving off road .......................180
electronic shift ........................179
indicator light .........................179
Index
282
2010 Ranger(ran)
Owners Guide, 1st Printing
USA(fus)
