2010 FORD KUGA sensor

Locking and unlocking
Unlocking the vehicle
Unlock
A
Lock
B
Tailgate unlock
C
Press the unlock button once to unlock
the vehicle. See Programming the
remote control (page 27).
Press and hold the unlock button for three
seconds to unlock the vehicle and open
the windows (global opening)*.
Press the lock button once to activate
central locking and arm the alarm.
Press the lock button twice within three
seconds to activate double locking and
arm the interior sensors.
Press and hold the lock button for three
seconds to lock the vehicle and close the
windows (global closing)*.
Press the tailgate unlock button twice
within three seconds to unlock the
luggage compartment.
Press and hold the tailgate unlock button
to unlock the upper tailgate.
* only in combination with four electric
windows. Opening the luggage compartment
lid
To open the main luggage compartment
lid, press switch
A. The driver’s door must
be unlocked.
To open the upper luggage compartment
lid, press switch B. See
Locking and unlocking (page
29).
11 Quick startE71963ABC E99409BA

Automatic climate control
Windscreen
defrosting/demisting
A
Toggle mono mode on and off
B
Air conditioning OFF
C
Recirculated air
D
Air conditioning ON
E See
Automatic climate control
(page 83).
Autolamps The headlamps will come on and go off
automatically depending on the ambient
light. See
Lighting control (page 46).
Direction indicators If the lever is tapped up or down, the
direction indicators will flash three times.
See
Direction indicators (page 50).
Autowipers Move the lever up one position.
The rain sensor will continuously measure
the amount of water on the windscreen
and adjust the speed of the front wipers
automatically.
Adjust the sensitivity of the rain sensor
using the rotary control.
See
Windscreen wipers (page 41).
14 Quick startE78730EDCBA E73840 E71098 E71014B

Passive locking and unlocking requires a
valid passive key to be located within one
of the three external detection ranges.
These are located approximately one and
a half metres from the driver and front
passenger door handles and the luggage
compartment lid.
Passive key
The vehicle can be locked and unlocked
with the passive key. The passive key can
also be used as a remote control. See
Locking and unlocking
(page 29).
Locking the vehicle WARNING
The vehicle does not lock itself
automatically. If no locking button is
pressed, the vehicle will remain
unlocked. Locking buttons are located on each of
the front doors.
To activate central locking and arm the
alarm:
•
Press a locking button once.
To activate double locking, to arm the
alarm and the interior sensors:
• Press a locking button twice within
three seconds.
Note:Once activated, the vehicle will
remain locked for approximately three seconds. This is to allow you to pull a doorhandle and check if the vehicle is locked.When the delay period is over, the doorscan be opened again, provided thepassive key is within the respectivedetection range.
Luggage compartment lid
Note:
The luggage compartment lid
cannot be closed and will pop back up if the passive key is located inside theluggage compartment.
Note:If a second valid passive key is
located within the luggage compartment lid detection range, the luggagecompartment lid can be closed.
32
LocksE78276 E87384

ARMING THE ALARM
The system is armed as soon as the
vehicle is locked and acts as a deterrent
to unauthorised persons who attempt to
open the doors, bonnet or luggage
compartment, or remove the audio
system.
The alarm sounds for 30 seconds if an
unauthorised person opens a door, the
luggage compartment or the bonnet. The
hazard flasher lights will flash for five
minutes.
Any attempt to start the engine without a
valid key or to remove the audio system
sounds the alarm again.
Automatic arming delay
The 20 seconds arming delay begins
when the bonnet, luggage compartment
and all doors are closed.
Interior sensors
WARNING
This system functions correctly only
if all windows are completely closed.
In addition to this, the sensors
located in the interior lamp unit must not
be covered up. The system should not
be activated if any persons, animals or
other moving objects are inside the
vehicle. This system acts as a deterrent against
unauthorised intrusion by sensing any
movement within the vehicle. Unauthorised entry into the vehicle’s
interior will trigger the alarm in the same
way as the anti-theft system.
The sensors are located in the interior
lamp unit.
All except Britain and Ireland
The interior sensing alarm is armed
together with the double locking system.
Britain and Ireland only
The interior sensing alarm is armed
together with the central locking system.
To deactivate the interior sensors press
the switch next to the driver’s door
handle.
DISARMING THE ALARM
The system can be deactivated at any
time, even when the alarm is sounding,
by unlocking the vehicle from the outside.
The system will be deactivated if:
•
A valid passive key is located within
the detection range.
• The unlock button on the remote
control is pressed.
• A valid passive key is located within
the vehicle interior and you depress
the clutch pedal (manual transmission)
or brake pedal (automatic
transmission).
• You insert the key blade into the key
holder.
The system for the luggage compartment
lid will be deactivated if.
• A valid passive key is located within
the detection range.
• The luggage compartment lid unlock
button on the remote control is
pressed.
37
AlarmE71401

WINDSCREEN WIPERS
Single wipe
A
Intermittent wipe or autowipers
B
Normal wipe
C
High speed wipe
D
Intermittent wipe Long wipe interval
A
Intermittent wipe
B
Short wipe interval
C Automatic wiper system
Some models without autowipers are
fitted with a speed-dependent front
screen wiper system.
When the vehicle is slowed to walking
speed or is brought to a standstill, the
wiper speed will automatically switch to
the next lower wiper speed setting.
When the vehicle speed is increased, the
wiper speed will return to the
manually-chosen setting.
Moving the wiper lever when the system
is operating will switch off the system.
If the vehicle is again slowed to walking
speed or is brought to a standstill, the
system is reactivated.
AUTOWIPERS
CAUTIONS
Do not switch autowipers on in dry
weather conditions. The rain sensor
is very sensitive and the wipers may
operate if dirt, mist or flies hit the
windscreen. Replace the wiper blades as soon as
they begin to leave bands of water
and smears. If you do not replace
them, the rain sensor will continue to
detect water on the windscreen and the
wipers will operate, even though the
majority of the windscreen is dry. Fully defrost the windscreen in icy
conditions before you switch
autowipers on.
Switch autowipers off before you
enter a car wash.
41
Wipers and washersE71012ABCD E71013CAB

Low sensitivity
A
OnB
High sensitivity
C
If you switch autowipers on, the wipers
will not cycle until water is detected on
the windscreen. The rain sensor will then
continuously measure the amount of
water on the windscreen and adjust the
speed of the wipers automatically.
Adjust the sensitivity of the rain sensor
using the rotary control. With low
sensitivity, the wipers will operate when
the sensor detects a lot of water on the
windscreen. With high sensitivity, the
wipers will operate if the sensor detects
a small amount of water on the
windscreen.
WINDSCREEN WASHERS WARNING
Do not operate the washer for more
than 10 seconds at a time, and
never when the reservoir is empty.
While the button at the end of the lever is
pressed the washer will work in
conjunction with the wipers.
After releasing the button, the wipers
operate for a short time.
REAR WINDOW WIPER AND
WASHERS
Intermittent wipe
Pull the lever towards the steering wheel.
Reverse gear wipe
The rear wiper will be activated
automatically when selecting reverse gear
if:
•
the rear wiper is not already switched
on,
• the wiper lever is in position
A,B, C
or Dand
• the front wiper is operating (when set
to position
B).
The rear wiper will follow the front wiper
interval (at intermittent or normal speed).
42
Wipers and washersE71013CAB E71016 E71017

3. Gently press the bulb into the bulb
holder, turn it anti-clockwise and
remove it.
Central high mounted brake
lamp
Note:The LED board is not a serviceable
item, please consult your dealer if this fails.
Number plate lamp 1. Carefully release the spring clip.
2. Remove the lamp.
3. Remove the bulb. Interior lamp
Vehicles without interior sensors
1. Carefully prise out the lamp.
2. Turn the bulb holder anti-clockwise
and remove it.
3. Remove the bulb.
Vehicles with interior sensors 1. Carefully prise out the lens.
2. Remove the lens.
3. Remove the bulb.
56
LightingE99413 E72789321 E99452231 E7278723

Reading lamps
Vehicles without interior sensors
1. Carefully prise out the lamp.
2. Turn the bulb holder anti-clockwise
and remove it.
3. Remove the bulb.
Vehicles with interior sensors 1. Carefully prise out the lamp.
2. Turn the bulb holder anti-clockwise
and remove it. 3. Remove the bulb.
Vanity mirror lamp
1. Carefully prise out the lamp.
2. Remove the bulb.
57
LightingE99453231 E72786221 E739393 E72785