2010 FORD F150 ignition

2. Poor fuel quality or water in the fuel—the engine may misfire or run
poorly.
3. The fuel fill inlet may not have been properly closed. SeeEasy Fuel™
“no cap” fuel systemin this chapter.
4. Driving through deep water—the electrical system may be wet.
These temporary malfunctions can be corrected by filling the fuel tank
with good quality fuel, properly closing the fuel fill inlet or letting the
electrical system dry out. After three driving cycles without these or any
other temporary malfunctions present, the service engine soon
indicator should stay off the next time the engine is started. A driving
cycle consists of a cold engine startup followed by mixed city/highway
driving. No additional vehicle service is required.
If the service engine soon
indicator remains on, have your vehicle
serviced at the first available opportunity. Although some malfunctions
detected by the OBD-II may not have symptoms that are apparent,
continued driving with the service engine soon
indicator on can
result in increased emissions, lower fuel economy, reduced engine and
transmission smoothness, and lead to more costly repairs.
Readiness for Inspection/Maintenance (I/M) testing
Some state/provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle. Failure to pass this inspection could prevent
you from getting a vehicle registration. Your vehicle may not pass the I/M
test if the service engine soon
indicator is on or not working
properly (bulb is burned out), or if the OBD-II system has determined
that some of the emission control systems have not been properly
checked. In this case, the vehicle is considered not ready for I/M testing.
If the service engine soon
indicator is on or the bulb does not
work, the vehicle may need to be serviced. Refer to the On board
diagnostics (OBD-II) description in this chapter.
If the vehicle’s engine or transmission has just been serviced, or the
battery has recently run down or been replaced, the OBD-II system may
indicate that the vehicle is not ready for I/M testing. To determine if the
vehicle is ready for I/M testing, turn the ignition key to the on position
for 15 seconds without cranking the engine. If the service engine
soon
indicator blinks eight times, it means that the vehicle is not
ready for I/M testing; if the service engine soon
indicator stays on
solid, it means that the vehicle is ready for I/M testing.
Maintenance and Specifications
391
2010 F-150(f12)
Owners Guide, 1st Printing
USA(fus)

ENGINE DATA
Engine4.6L 2V V8
engine4.6L 3V V8
engine5.4L V8 engine
Cubic inches 281 281 330
Fuel87 octane 87 octane 87 octane or
Ethanol (E85)
Firing order 1-3-7-2-6-5-4-8 1-3-7-2-6-5-4-8 1-3-7-2-6-5-4-8
Ignition system Coil on plug Coil on plug Coil on plug
Spark plug gap0.052–0.056 inch
(1.32–1.42mm)0.039–0.043 inch
(1.0–1.1mm)0.039–0.043 inch
(1.0–1.1mm)
Compression
ratio9.4:1 9.8:1 9.8:1
Maintenance and Specifications
404
2010 F-150(f12)
Owners Guide, 1st Printing
USA(fus)

Heating
heating and air conditioning
system .....................59, 62, 64, 67
Homelink wireless control
system ........................................104
Hood ..........................................364
I
Ignition .......................271, 404–405
Illuminated visor mirror .............87
Infant seats
(see Safety seats) .....................204
Inspection/maintenance (I/M)
testing ........................................391
Instrument panel
cleaning ...........................357–358
cluster ........................................12
J
Jack ............................................330
positioning ...............................330
storage .....................................330
Jump-starting your vehicle ......338
K
Keyless entry system
autolock ...................................127
keypad .....................................136
locking and unlocking doors ..137
programming entry code .......137
Keys ...........................126, 139–140
positions of the ignition .........271
L
Lamps
autolamp system .......................72bulb replacement
specifications chart ..................79
daytime running light ...............74
fog lamps ...................................73
headlamps .................................72
headlamps, flash to pass ..........73
interior lamps .....................76–77
replacing bulbs ...................79, 83
LATCH anchors .........................212
Lights, warning and indicator ....12
anti-lock brakes (ABS) ..........278
Limited-slip axle .......................286
Load limits .................................249
Loading instructions .................256
Locks
autolock ...................................127
childproof ................................130
doors ........................................126
Lubricant specifications ...........400
Lug nuts ....................................337
Lumbar support, seats .....152–153
M
Message center .....................22, 30
english/metric button .........26, 35
system check button ................35
warning messages ...............26, 35
Mirrors ...................................93–94
automatic dimming rearview
mirror ........................................93
fold away ...................................95
heated ......................62, 64, 67, 95
programmable memory ..........132
side view mirrors (power) .......94
signal .........................................96
Moon roof ..................................103
Motorcraft
parts ..............362, 399
Index
416
2010 F-150(f12)
Owners Guide, 1st Printing
USA(fus)