167
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
FUEL RESERVE (amber)
Turning the key to the MAR position illuminates
the warning light, but it will switch off after a few
seconds.
The warning light turns on when about 7 litres of fuel are
left in the tank.
IMPORTANT The warning light will blink to indicate a sys-
tem failure. If this happens, go to a Fiat Dealership to have
the system checked.
Warning light “indicates a failure of warn-
ing light ¬. This condition is indicated by
intermittent blinking of warning light “for longer
than 4 seconds. In this case, warning light ¬may
not be indicating that there is a fault in the restraint
systems. Before driving off, contact a Fiat Dealer-
ship to have the system checked immediately.
WARNING
ç
ABS SYSTEM FAULT (amber)
Turning the key to the MAR position illuminates
the warning light, but it will switch off after a few
seconds.
The warning light comes on when the system is either not
working properly or not available. Under these circum-
stances, the braking system will work as normal but without
the extra performance offered by the ABS system. Drive
carefully and go to a Fiat Dealership as soon as possible.
On some versions the display shows the associated message.
>
GLOW PLUG PREHEATING
(Multijet versions – amber)
GLOW PLUG PREHEATING FAULT
(Multijet versions – amber)
Glow plugs
This warning light comes on when the key is turned to
MAR. It will go out as soon as the glow plugs have reached
a preset temperature. Start the engine as soon as the
warning light goes out.
IMPORTANT When it is particularly warm outside, the
warning light stays on for an extremely short time.
Glow plug preheating fault
The warning light flashes if there is a fault in the preheat-
ing system. Go to a Fiat Dealership as soon as possible.
A specific message is displayed on certain versions.
m
161-174 PUNTO FL EN 4ed 18-01-2010 12:27 Pagina 167
168
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
EXTERIOR LIGHTS FAILURE
(amber)
(for versions/markets where provided)
The warning light comes on (on some versions) when
a failure is detected in one of the following lights:
– sidelights/taillights
– brake lights
– rear fog lights
– direction indicators
– number plate lights
- daytime running lights.
A specific message is displayed on some versions.
W
The presence of water in the fuel supply
circuit may cause severe damage to the in-
jection system and irregular engine oper-
ation. If warning light
ccomes on (with a message
on the display on some versions), go to a Fiat Deal-
ership as soon as possible to have the system bled.
Water may have entered the tank if this appears
immediately after refuelling: if this happens, switch
the engine off immediately and contact a Fiat Deal-
ership.
FIAT CODE VEHICLE PROTECTION
SYSTEM FAULT
(amber)
(for versions/markets where provided)
The warning light may come on (and a message on
the multifunction display may appear on certain versions)
to indicate that there is a fault in the Fiat Code system
or, if applicable, the alarm system; in this case, contact a
Fiat Dealership as soon as possible.Y
WATER IN DIESEL FILTER
(Multijet versions – amber)
When the ignition key is moved to MAR posi-
tion, the warnintg light turns on but should go off
after a few seconds.
The warning light turns on when there is water in the
diesel filter.
A specific message is displayed on certain versions.
c
161-174 PUNTO FL EN 4ed 18-01-2010 12:27 Pagina 168
170
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
DPF (PARTICULATE FILTER)
CLEANING IN PROGRESS
(only Multijet with DPF – amber)
When the ignition key is moved to MAR position,
the warnintg light turns on but should go off after a few
seconds. The warning light stays on constantly to notify
the driver that the DPF system needs to eliminate cap-
tured pollutants (particulate) by the regeneration process.
The warning light does not come on during every DPF
regeneration, but only when driving conditions require no-
tification to the driver. The warning light will go off if the
vehicle stays in motion until regeneration has been com-
pleted. The process normally takes about 15 minutes. Op-
timal conditions for completing the process are achieved
by travelling at 60 km/h with engine revs above 2000 rpm.
If this light comes on, it does not mean the car is defec-
tive, so there is no need to take it to a garage. A specific
message will appear on the display when the warning light
comes on (for versions/markets, where provided).
h
Always drive at a speed appropriate to the
traffic conditions, the weather and speed
limits. The engine may be turned off while the
DPF light is on; however, repeated interruption of
the regeneration process may result in premature
degradation of engine oil. For this reason it is al-
ways advisable to wait for the light to go off be-
fore turning off the engine, following the instruc-
tions appearing above. It is not a good idea to
complete DPF regeneration with the vehicle sta-
tionary.
WARNINGSpeed limit exceeded
(for versions/markets where provided)
The display shows the associated message when the car
exceeds the set speed limit (see “Multifunction display”
in the “Dashboard and controls” section).
161-174 PUNTO FL EN 4ed 18-01-2010 12:27 Pagina 170
171
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTSBRAKE PADS WORN
(amber)
(for versions/markets where provided)
The warning light comes on if the front brake pads
are worn; in this case, have them changed as soon as pos-
sible. A specific message is displayed on certain versions.
d
HILL HOLDER FAULT
(amber)
(for versions/markets where provided)
When the ignition key is moved to MAR position,
the warnintg light turns on but should go off after a few
seconds.
The warning light turns on to indicate a Hill Holder sys-
tem fault. In this case, contact a Fiat Dealership as soon
as possible. On certain versions, warning light
áturns
on as an alternative. A specific message is displayed on cer-
tain versions.
*
SIDELIGHTS/TAILLIGHTS
AND DIPPED BEAM HEADLIGHTS
(green)
FOLLOW ME HOME (green)
Sidelights/taillights and dipped beam headlights
The light comes on when the sidelights/taillights or dipped
beams are turned on.
Follow Me Home
The light will turn when this device is active (see “Follow
Me Home” in the “Dashboard and controls” section). The
display will show the associated message.
3
ESP SYSTEM FAULT
(amber)
When the ignition key is moved to MAR posi-
tion, the warnintg light turns on but should go off
after a few seconds.
ESP-ASR system failure
If the warning light does not go off or stays on together
with the LED on the ASR button when travelling, contact
a Fiat Dealership. A specific message is displayed on cer-
tain versions.
NBThe warning light flashing while driving indicates that
the ESP system is active.
á
161-174 PUNTO FL EN 4ed 18-01-2010 12:27 Pagina 171
172
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
IMPORTANT Do not continue driving with one or more
flat tyres as handling may be compromised. Stop the car,
avoiding harsh braking or steering manoeuvres. Replace
the wheel immediately with the small spare wheel (for ver-
sions/markets where provided) or carry out a repair us-
ing the dedicated kit (see “Changing a wheel” in the “In
an emergency” section) and contact a Fiat Dealership as
soon as possible.
Tyre pressure unsuitable for speed
Should you need to travel at a speed higher than 160 km/h,
inflate the tyres to the pressures specified in “Tyre pres-
sures”.
If the TPMS system (for versions/markets where provid-
ed) detects that the pressure of one or more tyres is un-
suitable for the current speed, the warning light will turn
on (together with the message on the display) (see “Tyre
pressure low” in this section) and it will stay on until the
car slows down to a speed below the preset threshold.
IMPORTANT In this case, slow down immediately because
tyre overheating could damage tyre performance and dura-
bility beyond repair, and may even make the tyre explode. CHECK TYRE PRESSURE
(amber)
TYRE PRESSURE LOW (amber)
TYRE PRESSURE UNSUITABLE FOR
SPEED
(amber)
(for versions/markets where provided)
When the ignition key is moved to MAR position, the
warnintg light turns on but should go off after a few sec-
onds.
Check tyre pressures
The warning light turns on to indicate the flat tyre. Should
two or more tyres be flat, the display will show the indi-
cations corresponding to each tyre in sequence.
Restore correct tyre pressures as soon as possible (see
“Cold tyre pressures” in the “Technical specifications” sec-
tion).
Tyre pressure low
The warning light on the panel comes on when the pres-
sure of one or more tyres falls below a preset level. In this
way, the TPMS system warns the driver that one or more
tyres may be dangerously flat and probably punctured.
n
161-174 PUNTO FL EN 4ed 18-01-2010 12:27 Pagina 172
173
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
RIGHT-HAND DIRECTION
INDICATOR (green – intermittent)
The light (arrow) comes on when the direction
indicator control lever is moved upwards or, to-
gether with the left-hand arrow, when the hazard warn-
ing light button is pressed.
D
DUALDRIVE ELECTRIC POWER
STEERING ON (green)
(for versions/markets where provided)
The word “CITY” appears on the display when the
Dualdrive electric power steering system is activated by
pressing the relevant control button. If the button is
pressed again the word CITY goes out. A specific message
is displayed on certain versions.
CITY
CRUISE CONTROL (green)
(for versions/markets where provided)
When the ignition key is moved to MAR posi-
tion, the warnintg light turns on but should go off
after a few seconds.
The warning light is lit up on the display by rotating the
Cruise Control twist switch to ON. A specific message
is displayed on certain versions.
Ü
Strong radio-frequency noises could hin-
der the regular operation of the TPMS
system. This condition will be indicated by a mes-
sage (where provided). The message will disap-
pear automatically as soon as the interference
ceases to disturb the system.
WARNING
FOG LIGHTS (green)
The light comes on when the front fog lights are
turned on.
5
LEFT-HAND DIRECTION
INDICATOR (green – intermittent)
The light (arrow) comes on when the direction
indicator control lever is moved downwards or,
together with the right-hand arrow, when the hazard
warning light button is pressed.
F
161-174 PUNTO FL EN 4ed 18-01-2010 12:27 Pagina 173
199
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
Never replace a blown fuse with metal
wires or other materials.
Should the fuse blow again, contact a Fi-
at Dealership.
WARNING
Never replace a fuse with one that has
a higher amperage: FIRE HAZARD.
WARNING
If a general protection fuse (MEGA-FUSE,
MIDI-FUSE, MAXI-FUSE) is activated,
contact a Fiat Dealership.
WARNING
Remove the key from the ignition and
switch off or disable all devices before re-
placing a fuse.
WARNING
If a general protection fuse for safety sys-
tems (air bag system, braking system),
power unit systems (engine system, transmission
system) or steering system is triggered, contact a
Fiat Dealership.
WARNING
175-210 PUNTO FL EN 4ed 20-01-2010 15:09 Pagina 199
233
INTERIOR
Check regularly that water is not trapped under the mats
(due to drops from shoes, umbrellas, etc.), as this could
cause the sheet metal to rust.
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
Detergents cause water pollution. The ve-
hicle should be washed only in areas
equipped for collecting and purifying the
liquids used in the washing process.
Windows
Use specific detergents to clean the windows.
Also use clean cloths to avoid scratching the glass or al-
tering the transparency.
IMPORTANT Wipe the rear window gently with a cloth
in the direction of the filaments to avoid damaging the heat-
ing device.
Engine compartment
Wash the engine compartment thoroughly at the end of
every winter. Be careful not to direct the jet of water on-
to electronic control units. Adequately protect the up-
per air vents to prevent damage to the windscreen wiper
motor. Have this operation performed at a specialised
workshop.
IMPORTANT The washing should take place with the en-
gine cold and the ignition key in the STOP position. After
the wash, make sure that the various protective devices
(e.g. rubber caps and guards) have not been removed or
damaged.
Front headlights
IMPORTANT Never use aromatic substances (e.g. petrol)
or ketenes (e.g. acetone) for cleaning the plastic lenses of the
front headlights.
Never use flammable products, such as
petroleum ether or modified petrol, to
clean inside the car. The electrostatic charges
which are generated by rubbing during cleaning
may cause a fire.
WARNING
Do not keep aerosol cans in the vehicle:
these could explode. Aerosol cans must
not be exposed to temperatures exceeding 50°C.
When the vehicle is exposed to sunlight, the tem-
perature inside can greatly exceed this value.
WARNING
211-234 PUNTO FL EN 4ed 18-01-2010 12:28 Pagina 233