78
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
The rear seat belts must be used as shown
in the diagram in fig. 2.
SEAT BELTS
USING THE SEAT BELTS fig. 1
The belt should be worn keeping the chest
straight and rested against the seat back.
To fasten the seat belts, take hold
the
tongue Aand insert it into the buckle B,
until hearing the locking click.
At removal, if it jams, let it rewind for a
short stretch, then pull it out again with-
out jerking.
Press button Cto release the belt. Ac-
company the belt while it is being
re-
wound to prevent twisting.
Through the reel, the belt automatically
adapts to the body of the passenger wear-
ing it, allowing freedom of movement.
The reel may lock when the car is parked
on a steep slope:
this is perfectly normal.
Furthermore, the reel mechanism locks
the belt if it is pulled and in the event of
sudden braking, collisions and on high
speed bends.
The rear seat is fitte d with inertial seat
belts with three anchor points and reel.
fig. 1F0R0150m
fig. 2F0R0088m
Never press button C-fig. 1
when travelling.
WARNING
fig. 3
A
B
F0R0151m
ADJUSTING THE FRONT SEAT
BELT HEIGHT
Always adjust the seat belt height to the
passenger’s body: this precaution may
considerably reduce the risk of injury in
the event of a collision.
Correct regulation is obtained when the
belt passes approximately half way
be-
tween the shoulder and the neck.
To adjust, move the grip A-fig. 3of the
locking mechanism either up or down and
at the same time move the ring B-fig. 3
to the most suitable of the allowed posi-
tions.
CORRECT USE
OF THE
CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
PRESS
LINEA Owner HAND BOOK RHD.pdf 78LINEA Owner HAND BOOK RHD.pdf 788/21/09 2:16:11 PM8/21/09 2:16:11 PM
USING THE MANUAL
GEARBOX
To engage the gears, press the clutch ped-
al fully and shift the gear lever into one of
the required positions (the diagram is
shown on the knob fig. 2).
IMPORTANT Reverse may only be en-
gaged when the car is at a standstill. With
the engine running, wait for at least 2 sec-
onds with the clutch pedal fully pressed
before engaging reverse to prevent dam-
age to the gears and grating.
fig. 2F0R0154m
Press the clutch pedal fully
to change gears correctly.
For this reason, there must be no ob-
stacles on the floor under the pedals:
make sure that mat are always flat
and do not interfere with the pedals.
WARNING
Do not drive with your hand
resting on the gear lever as
the force exer ted, even if
slight, could lead over time to
premature wear on the gearbox inter-
nal components.To engage reverse R from neutral position,
shift the lever right-wards and then back
fig. 2.
97
CORRECT USE
OF THE CAR
WARNING
IN AN
CAR
TECHNICAL
INDEX
DASHBOARD
SAFETY
LIGHTS AND
EMERGENCY
MAINTENANCE
SPECIFICATIONS
AND CONTROLS
DEVICES
MESSAGES
LINEA Owner HAND BOOK RHD.pdf 97LINEA Owner HAND BOOK RHD.pdf 978/21/09 2:16:14 PM8/21/09 2:16:14 PM
