Page 5 of 257

Warning lampis onCauseAction/Obser vations
Diesel engine pre-heating fixed. The ignition switch is at the 2nd position (ignition on). Wait until the warning lamp goes off before star ting. The period of illumination of the warning lamp is determined by the climatic conditions (up to about thir ty seconds in extreme climatic conditions). If the engine does not star t, switch the ignition off and
then on, wait until the warning lamp goes off again, then star t the engine.
Parking brake fixed. The parking brake is applied or not properly released. Release the parking brake to switch off the warning lamp, keeping your foot on the brake pedal. Obser ve the safety. For fur ther information on the parking brake, refer t o the "Driving" section.
Stop & Star t
fixed. The Stop & Star t system has put the engine in STOP mode at a vehicle stop (traffic lights, traffic jam, or other...).
The warning lamp goes off and the engine restar ts automatically in START mode, as soon as you want to move off.
flashes for a few seconds, then goes
off.
STOP mode is temporarily unavailable.
or START mode is invoked automatically.
Refer to "Driving - § Stop & Star t" for special cases with STOP mode and START mode.
Page 32 of 257

Ventilation
Air intake
The air circulating in the passenger compartment is filtered and originates either from the outside via the grille located at the base of the windscreen or from the inside in air recirculation mode.
Air treatment
The incoming air follows various routes depending on the controls selected by the driver: - direct arrival in the passenger compar tment (air intake), - passage through a heating circuit (heating), - passage through a cooling circuit (air conditioning). The temperature control enables you to obtain the level of comfor t required by mixing the air of the various circuits. The air distribution control enables you to diffuse the air in the passenger compar tment combining several air vents. The air flow control enables you to increase or reduce the speed of the ventilation blower.
Control panel
The controls of this system are grouped together on control panel A on the centre console. Depending on the model, the functions offered are: - the level of comfor t required, - air flow, - air distribution, - demisting-defrosting, - manual or digital air conditioning controls.
Air distribution
1. Windscreen demisting-defrosting vents. 2. Front side window demisting-defrosting vents. 3. Side adjustable air vents. 4. Central adjustable air vents. 5. Air outlets to the front footwells. 6. Air outlets to the rear footwells.
Page 34 of 257
Heating/Ventilation
Manual control panel Electric control panel
Page 44 of 257

It is possible to adjust one or more functions manually while leaving the other functions in automatic mode.
The "AUTO" symbol switches off. To return to automatic mode, press the "AUTO"button.
M a n u a l o v e r r i d e
4. Air conditioning on/off
For maximum cooling or heating of the cabin, it is possible to go beyond the minimum 14 or maximum 28 values. Press the blue button 2 until "LO"is displayed or the red button 2until "HI" is displayed.
Press this button to switch off the air conditioning. Stopping the air conditioning may cause some problems (humidity, misting). Automatic operation of the air conditioning is resumed when the button is pressed again. The symbol "A /C" is displayed.
5. Air intake/Air recirculation
Press this button for recirculation of the interior air. The air recirculation symbol 5 is displayed.
Air recirculation enables the passenger compar tment to be isolated from exterior odours and smoke. Press this button again or press the "AUTO"button to resume automatic management of the intake of air. The air recirculation symbol 5goes off.
Avoid prolonged recirculation of interior air (risk of condensation or deterioration of the air quality).
Switching to manual mode may not be suitable (temperature, humidity, odour, condensation) and does not provide optimum comfor t.
Page 46 of 257