Page 142 of 236
9.33
NaviDrive
MULTIMEDIA AUDIO EQUIPMENT/TELEPHONE
JUKEBOX FUNCTION (10 GB)/GPS (EUROPE)
The NaviDrive is coded in such a way that it will only operate in your vehicle. If it is to be installed in another v e h i c l e , c o n t a c t a C I T R O Ë N d e a l e r f o r c o n fi g u r a t i o n o f t h e operate in your vehicle. If it is to be installed in another le. If it i
system.
For safety reasons, it is imperative that the dri ver carries out operations which require prolonged attention wh ile the vehicle is stationary. When the engine is switched off and to prevent discharging of the battery, the NaviDrive may switch off after a few minutes.
CONTENTS
Page 178 of 236
9.39
11
3 3
4 4
5 5
6 6
7 7
8 8
10
2 2
CONFIGURATION
ADJUSTING THE DATE AND TIME
Press the MENU button.
Turn the dial and select the CONFIGURATION function.
P r e s s t h e d i a l t o c o n fi r m t h e s e l e c t i o n .
Turn the dial and select the DISPLAY CONFIGURATION function. Adjust the settings one by one c o n fi r m i n g b y p r e s s i n g t h e d i a l . N e x t select the OK tab on the screen then c o n fi r m .
P r e s s t h e d i a l t o c o n fi r m t h e s e l e c t i o n .
DISPLAY CONFIGURATION
ADJUST THE DATE AND TIME
OK P r e s s t h e d i a l t o c o n fi r m t h e s e l e c t i o n .
Turn the dial and select the ADJUST THE DATE AND TIME function.
The CONFIGURATION function gives access to the colour, brightness and units settings and to voice commands.
This adjustment must be carried out whenever the battery has been disconnected.
Page 185 of 236
9.46
SOLUTION ANSWER
The environment (hills, buildings, tunnels, basement car parks...) block reception, including in RDS mode.
The aerial is absent or has been damaged (for exam ple when going through a car wash or into an underground car park).
This phenomenon is normal and does not indicate a failure of the audio equipment.
Have the aerial checked by a CITROËN dealer.
Sound cut-outs of 1 to 2 seconds in radio mode.
During this brief sound cut-out, the RDS searches for any frequency permitting better reception of the station. Deactivate the RDS function if the phenomenon is too frequent and always on the same route.
With the engine off, the audio equipment switches off after a few minutes of use.
When the engine is switched off, the audio equipme nt operating time depends on the battery charge.
The switch-off is normal: the audio equipment switches to economy mode and switches off to prevent discharging of the vehicle's battery.
The stored stations do not function (no sound, 87.5 Mhz is displayed...)
An incorrect waveband is selected. Press the BAND AST button to return to the waveband (AM, FM1, FM2, FMAST) on which the stations are stored.
Start the vehicle's engine to increase the battery charge.
The quality of reception of the radio station listened to gradually deteriorates or the stored stations do not function (no sound, 87.5 Mhz is displayed...).
The vehicle is too far from the transmitter used by the station listened to or there is no transmitter in the geographical area th rough which the vehicle is travelling.
Activate the RDS function to enable the system to check whether there is a more powerful transmitter in the geographical area.
Page 235 of 236
9 . 9 5
There is a difference in sound quality between the different audio sources (radio, CD...).
C h e c k t h a t t h e a u d i o s e t t i n g s ( V o l u m e , B a s s , Treble, Ambience, Loudness) are adapted to the sources listened to. It is advisable to set the AUDIO functions (Bass, Treble, Front-Rear B a l a n c e , L e f t - R i g h t B a l a n c e ) t o t h e m i d d l e position, select the musical ambience "None" and set the loudness correction to the "Active" position in CD mode or to the "Inactive" position in radio mode.
F o r o p t i m u m s o u n d q u a l i t y , t h e a u d i o s e t t i n g s ( V o l u m e , B a s s , T r e b l e , Ambience, Loudness) can be adapted to the different sound sources, w h i c h m a y r e s u l t i n a u d i b l e d i f f e r e n c e s w h e n c h a n g i n g s o u r c e ( r a d i o , CD...).
The CD is ejected automatically or is not played by the player.
- Check that the CD is inserted in the player the r i g h t w a y u p . - Check the condition of the CD: the CD cannot b e p l a y e d i f i t i s t o o d a m a g e d . - Check the content in the case of a recorded CD: consult the advice in the "Audio" section. - The audio equipment's CD player does not play DVDs. - Due to their quality level, certain writeable CDs will not be played by the audio system.
The CD is inserted upside down, is unplayable, doe s not contain any audio data or contains an audio format which the player cannot play.
T h e C D i s p r o t e c t e d b y a n a n t i - p i r a t i n g p r o t e c t i o n s y s t e m w h i c h i s n o t r e c o g n i s e d b y t h e a u d i o e q u i p m e n t .
T h e m e s s a g e " U S B peripheral error" is displayed on the screen.
The battery of the peripheral may not be s u f fi c i e n t l y c h a r g e d . The Bluetooth connection is cut.
R e c h a r g e t h e b a t t e r y o f t h e p e r i p h e r a l d e v i c e . T h e U S B m e m o r y s t i c k i s n o t r e c o g n i s e d . The memory stick may be corrupt. Reformat the memory stick.
QUESTION SOLUTION ANSWER
F R E Q U E N T L Y A S K E D Q U E S T I O N S
The CD player sound is poor. The CD used is scratched or of poor quality. I n s e r t g o o d q u a l i t y C D s a n d s t o r e t h e m i n suitable conditions.
T h e a u d i o e q u i p m e n t s e t t i n g s ( b a s s , t r e b l e , a m b i e n c e s ) a r e u n s u i t a b l e . S e t t h e t r e b l e o r b a s s l e v e l t o 0 , w i t h o u t s e l e c t i n g an ambience.
