Page 8 of 352
Downloaded from www.Manualslib.com manuals search engine 6
FAMILIARISATION
A.
Central locking
B.
Unlocking
C.
Remote operation of lighting
D.
Key release/storage
Press control A
, located on the switch
panel to the left of the dashboard. The
fuel fl ap automatically opens up fully.
Insert the pump nozzle so as to push in
the metal fl ap B
.
Push the fuel fi ller fl ap to close it.
After switching off the ignition, con-
trol A
is only active for a few minutes.
If necessary, switch on the ignition
again to reactivate it.
Bonnet stay:
Unclip the stay and insert
it into the notch.
78
Bonnet opening/closing
To release the bonnet, pull the lever
located under the dashboard towards
you. Then operate the safety catch at
the front of the bonnet,
174
92
Selective opening
Using the multifunction screen, you can
choose from the following options for
opening your vehicle with the remote
control:
- either all of the doors and the tail-
gate,
- or the driver’s door with a fi rst press,
then all of the other doors with a
second press.
To close:
move the stay back to
its initial position, lower the bon-
net, then allow it to slam shut at
the end of its travel.
OPENING
Remote control key
Fuel tank
Capacity: approximately 60 litres.
Page 13 of 352
Downloaded from www.Manualslib.com manuals search engine 11
FAMILIARISATION
8.
Controls:
- Trip mileage recorder reset
button
- Lighting rheostat
9.
Warning lamps display (with the
MyWay or NaviDrive multifunction
screen)
10.
Electric parking brake
11 .
Instrument panel
12.
Hazard warning lamps
13.
Switch panels:
- Emergency or assistance
- Lane departure warning system
14.
ESP deactivation button
15.
Steering lock - Ignition switch
16.
Multifunction screen steering
mounted controls
17.
Horn
1.
Controls:
- Lighting
- Direction indicators
- Front and rear foglamps
2.
Paddles for automatic gearbox or
6-speed electronic gearbox system
3.
Cruise control and speed limiter
steering mounted controls
4.
Direction indicator warning lamps
5.
Audio and telematics system
steering mounted controls
6.
Gear lever for automatic gearbox or
6-speed electronic gearbox system
7.
Controls:
- Windscreen wipe
- Screenwash
- Rear screen wipe
- Trip computer
INSTRUMENTS AND CONTROLS
18.
Optional function controls
(on steering wheel)
19.
Fusebox access cover
20.
Controls:
- Fuel fi ller fl ap
- Front and rear parking sensors
- Stop & Start
- Volumetric alarm deactivation
- Headlamp adjustment
21.
Bonnet release
22.
Mirror controls
Page 16 of 352
Downloaded from www.Manualslib.com manuals search engine 14
FAMILIARISATION
Adjusting the steering wheel
The steering wheel can be adjusted for
height and reach.
Release the steering wheel by pulling
lever A
towards you.
Adjust the position of the steering
wheel then lock it pushing the lever fully
back.
77
It automatically and progressively
changes between day use and night
use. This operates with the ignition switched on.
From the driver’s seat, select the door
mirror by moving control 1
to the left or
right, then adjust the door mirror as re-
quired in four directions using control 2
.
Demisting-defrosting of the door mirrors
is linked to that of the rear screen.
105
76
For safety reasons, these adjust-
ments must not be carried out whilst
driving.
This additional mirror 1
allows you to
monitor the rear passengers. It can be
tilted to eliminate dazzle.
Door mirror foldback
When the vehicle is parked, the door
mirrors can be folded back either man-
ually or automatically.
SITTING COMFORTABLY
Automatic photochromic rear
view mirror
Door mirror adjustment
77
Child surveillance mirror
Page 17 of 352
Downloaded from www.Manualslib.com manuals search engine 15
FAMILIARISATION
Front seats
Head restraint
Backrest angle
Seat height adjustment
Lumbar support
Forwards-backwards
adjustment
Armrest
Electric adjustments
Manual adjustments
68
Heated seat control
(lo-
cated on the inside of the
front seats)
67
1.
Adjustment of seat height, angle
and forwards-backwards position
2.
Adjustment of backrest angle and
lumbar support
3.
Driver: storing driving positions
The seats can also be adjusted on a
temporary basis:
- on opening one of the front doors,
- after switching on the ignition.
SITTING COMFORTABLY
Page 27 of 352
Downloaded from www.Manualslib.com manuals search engine 25
FAMILIARISATION
166
Electric parking brake
Before leaving the vehicle, check
that the electric parking brake warn-
ing lamp P
(red) is on fi xed (not
fl ashing).
If you leave the vehicle with the en-
gine running, apply the parking brake
manually.
Never leave a child alone inside the
vehicle with the ignition on, as they
could release the parking brake.
Parking space sensor
You can activate this function by press-
ing button A
.
Once the space has been measured, the
system displays the following messages:
< 12 mph (20 km/h)
Parking possible
Parking diffi cult
Parking not advised
This device combines:
- automatic functions: Automatic ap-
plication when the engine stops and
automatic release on use of the ac-
celerator (automatic operation by
default);
- manual use: Manual application/re-
lease of parking brake is possible
by operating control lever A
.
Hill start assist
To aid starting on a gradient, your ve-
hicle is equipped with a system which
keeps it immobilised for about 2 seconds,
the approximate time it takes to move
your foot from the brake pedal to the
accelerator pedal.
146
DRIVING
139
Do not drive if the parking brake
warning lamp and the P
indicator on
the lever A
are on. When in automatic mode, it remains
possible to apply or release the parking
brake at any time:
)
To apply it, pull on the lever A
.
)
To release it, pull then release lever A
.
Page 28 of 352
Downloaded from www.Manualslib.com manuals search engine 26
FAMILIARISATION
6-speed electronic gearbox system
R
Reverse
N
Neutral
A
Automatic mode
M
Manual mode
Using control paddles 1 "+"
and 2 "-"
:
- gear changing in manual mode,
- temporary manual operation in au-
tomatic mode.
P
Park
R
Reverse
N
Neutral
D
Automatic mode
M
Sequential mode
Using control paddles 1 "+"
and 2 "-"
:
- gear changing in sequential mode,
- temporary manual operation in au-
tomatic mode.
Starting
)
Check that the gear lever 3
is in
neutral (position N
).
)
Press fi rmly on the brake pedal and
turn the ignition key.
149
Starting
)
Check that the gear lever 3
is in po-
sition P
or N
and turn the ignition
key.
To exit position P
, press on the brake
pedal before moving the gear lever.
156
DRIVING
Automatic gearbox
Page 29 of 352
Downloaded from www.Manualslib.com manuals search engine 27
FAMILIARISATION
DRIVING
Stop & Start
Engine going into STOP mode
The "ECO"
warning lamp comes
on in the instrument panel and
the engine goes into stand-by:
- with the 6-speed electronic gear-
box system
; at speeds below
4 mph (6 km/h), press the brake
pedal or put the gear lever into neu-
tral (position N) .
In certain circumstances the STOP
mode may not be available; the "ECO"
warning lamp fl ashes for a few seconds
then goes off.
153
The "ECO"
warning lamp goes
off and the engine restarts:
- with the gear lever in position A
or
M
, release the brake pedal,
- or with the gear lever in position N
and the brake pedal released,
change to position A
or M
,
- or select reverse gear.
In certain condition, START mode may
be invoked automatically; the "ECO"
warning lamp fl ashes then goes off.
154
Deactivation/Reactivation
You can deactivate the system at any
time by pressing the "ECO OFF"
button;
the button's warning lamp comes on.
The system is reactivated autom-
photoatically every time you start the
engine with the key.
Before refuelling or doing any-
thing under the bonnet, you
must switch off the ignition
with the key.
154
Going into engine START mode
Page 30 of 352
Downloaded from www.Manualslib.com manuals search engine 28
FAMILIARISATION
DRIVING
Ignition switch
●
S: Steering lock
To release the steering lock, oper-
ate the steering slightly while turn-
ing the key, but without forcing.
●
M: On, running position
●
D: Starter
Release the key as soon as the en-
gine starts. Do not operate the start-
er when the engine is running.
81
1.
Cruise control mode On/Off.
2.
Programming a speed/Reducing
the programmed value.
3.
Cruise control On/Off.
4.
Programming a speed/Increasing
the programmed value.
In order to be programmed or activated,
the vehicle speed must be higher than
25 mph (40 km/h), with at least fourth
gear engaged on a manual gearbox
(second gear for the 6-speed electronic
gearbox system or automatic gearbox).
Cruise control
164
1.
Limiter mode On/Off.
2.
Decrease the programmed value.
3.
Speed limiter On/Off.
4.
Increase the programmed value.
Speed limiter
162
