2010 CITROEN C4 PICASSO stop start

Downloaded from www.Manualslib.com manuals search engine I
41
MONITORING


Warning lamp



is on



Cause



Action/Observations






Maximum
coolant
temperature


fi xed red. The temperature of the
cooling system is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down
before topping up the level, if necessary.
If the problem persists, contact a
CITROËN dealer or qualifi ed workshop.




Battery
charge


fi xed. The battery charging circuit
has a fault (dirty or loose
terminals, slack or cut
alternator belt, ...). The warning lamp should go off when the
engine is started.
If it does not go off, contact a CITROËN
dealer or a qualifi ed workshop.





Door(s) open


fi xed if the speed
is below 6 mph
(10 km/h).
A door, the boot or the rear
screen is still open. Close the door or boot.
fi xed and
accompanied by
an audible signal
if the speed is
above 6 mph
(10 km/h).




Seat belts
not fastened/
unfastened


fi xed. The driver and/or the front/
rear passenger has not
fastened or has unfastened
their seat belt.
Pull the strap then insert the tongue in the buckle.
The illuminated dots represent the passengers
that have not fastened/unfastened their seat belt.
They come on:


- fi xed for 30 about seconds on starting
the vehicle,

- fi xed from 0 to 12 mph (0 to 20 km/h)
when driving,

- fl ashing above 12 mph (20 km/h),
accompanied by an audible signal for
about 120 seconds.

Downloaded from www.Manualslib.com manuals search engine II
54
MULTIFUNCTION SCREENS




TRIP COMPUTER

System which provides current infor-
mation concerning the route travelled
(range, fuel consumption, …) in the
multifunction screen.

Monochrome screen C

MyWay or NaviDrive colour
screen

Display of information

Trip zero reset


)
Press the button, located at the
end of the wiper stalk
, to display
the various trip computer infor-
mation groups in succession:


- the current information
group with:


●
range,

●
current fuel consump-
tion,

●
distance remaining to
be travelled/Stop &
Start time counter,

- the trip "1"
group with:


●
distance travelled,

●
average fuel con-
sumption,

●
average speed,
for the fi rst trip.
- the trip "2"
group with:


●

the distance travelled,


●
the average fuel con-
sumption,

●
the average speed,
for the second trip.





)
When the trip required is dis-
played, press the control for
more than two seconds.
Trips "1"
and "2"
are independent
but their use is identical.
For example, trip "1"
can be used for
daily fi gures and trip "2"
for monthly
fi gures.

Downloaded from www.Manualslib.com manuals search engine II
55
MULTIFUNCTION SCREENS





A few definitions…


Range
(miles or km)
This value may vary following a
change in the style of driving or
the relief, resulting in a signifi cant
change in the current fuel con-
sumption.
When the range falls below 20 miles
(30 km), dashes are displayed. After
fi lling with at least 5 litres of fuel,
the range is recalculated and is dis-
played when it exceeds 60 miles
(100 km).
If dashes are displayed continu-
ously while driving in place of the
digits, contact a CITROËN dealer
or a qualifi ed workshop. This indicates the distance which
can still be travelled with the fuel re-
maining in the tank in relation to the
average fuel consumption over the
last few miles (kilometres) travelled.
Current fuel consumption
(mpg or l/100 km or km/l)

Average fuel
consumption
(mpg or l/100 km or km/l)
This is the average fuel
consumption since the last trip com-
puter zero reset.

Average speed
(mph or km/h)
This is the average speed calculated
since the last trip computer zero reset
(ignition on).
Distance travelled
(miles or km)
This indicates the distance travelled
since the last trip computer zero reset.



Distance remaining to
destination
(miles or km)
This is the distance remaining to be
travelled to the fi nal destination. It
is either calculated instantly by the
navigation system, if guidance is ac-
tivated, or entered by the user.
If the distance is not entered, dashes
are displayed in place of the digits.
This function is only displayed from
20 mph (30 km/h). This is the average fuel consump-
tion during the last few seconds.
If your vehicle is fi tted with Stop &
Start, a time counter calculates the
time spent in STOP mode during a
journey.
It resets to zero every time the igni-
tion is switched on with the key.







Stop & Start time counter
(minutes/seconds or hours/
minutes)

Downloaded from www.Manualslib.com manuals search engine III
59
COMFORT

6. Demisting/defrosting the
rear screen
This function operates only if the en-
gine is running.


)
Press button 6
to activate/de-
activate the electric demisting/
defrosting of the rear screen and
door mirrors. The warning lamp
comes on.


7. Rapid demisting/defrosting
of front and rear windows
and door mirrors


)
Press button 7
. The warning
lamp comes on.
This function simultaneously acti-
vates:


- front demisting/defrosting,

- optimum fl ow of air,

- intake of exterior air,

- demisting/defrosting of door mir-
rors and heated rear screen,

- air conditioning, if necessary.
To stop the function, press button 7

again.


8. Adjustment of the fan air
temperature
This control is for adjusting the tem-
perature of the air in the passenger
compartment. It can be used in cold
weather as well as in hot weather,
provided the air conditioning is ac-
tive.
The adjustment of the temperature
is continuous and progressive start-
ing from left to right.


Adjustment of temperature



)
Press button 9
to take control of
the temperature. The warning
lamp comes on.

)
Rotate button 10
to adjust your
temperature.
The adjustment of the temperature
is continuous and progressive start-
ing from left to right. The demisting/defrosting
switches off automatically
to prevent excessive con-
sumption of power.

B. PASSENGER'S CONTROL
PA N E L

Downloaded from www.Manualslib.com manuals search engine III
63
COMFORT

9. Rapid demisting/defrosting
of the front and rear
windows


- Press button 9
. The warning
lamp comes on.
This function gives a rapid
demisting/defrosting of the
vehicle simultaneously with:


- front demisting/defrosting at op-
timum temperature,

- optimum air fl ow,

- intake of exterior air,

- demisting/defrosting of the door
mirrors and rear screen,

- air conditioning, if necessary.
Press button 9
again or " AUTO"

to stop the function. Demisting/
defrosting of the door mirrors and
rear screen remains activated.


10. Air conditioning



)
Press button 10
to activate the
air conditioning.
The A/C
warning lamp comes on.
B. PASSENGER CONTROL PANELS

11. Front passenger

The front passenger can adjust their
temperature control independently
at any time by pressing buttons +

and -
.
The front passenger con-
trols the adjustment of their
own temperature.
The temperature setting for
the passenger is aligned
with that for the driver.


12. Rear passengers (right/left)

By default, in AUTO

position, the adjust-
ment of the air fl ow is
aligned on the front
ventilation.


)
Rotate the button
to decrease or in-
crease the air fl ow.

You can adjust the air fl ow only if this
is enabled by the driver (see button 6

of the driver’s control panel).







With Stop & Start, when demist-
ing has been activated, the STOP
mode is not available.

Downloaded from www.Manualslib.com manuals search engine IV
81
ACCESS
STARTING

1. "S": Steering lock

To unlock the steering, gently move
the steering wheel while turning the
key, without forcing it.


2. "M": Ignition on

Depending on the version of your
vehicle, the orange and red warn-
ing lamps should also come on for
a short time.


3. "D": Starter

Release the key as soon the engine
has started.
If the fi rst attempt fails, switch off the
ignition. Wait ten seconds then oper-
ate the starter again.


Steering lock


1. "

S":
After removing the key, turn
the steering wheel to lock the
steering. The key can only be
removed in position S
.

2. "M":
Ignition switched on, the
steering is unlocked (by turning
the key to position M
, move
the steering wheel gently if
necessary).

3. "D":
Starter position.


Key left in position "M"
audible warning
If you forget to remove the key from
the ignition, the ignition is switched
off automatically after one hour.
To switch the ignition back on, turn
the key to position S
then back to
position M
.

Do not run the engine in an en-
closed space or where there is
insuffi cient ventilation
.

You must always to keep the
engine running when moving in
order to retain braking and steer-
ing power assistance .

Never remove the ignition key
before the vehicle has come to a
complete stop.



Vehicles equipped with a
turbocharger
Never stop the engine without having
allowed it to run for a few seconds at
idle, this being the time required for
the turbocharger to return to a normal
speed.
Flicking the accelerator at the mo-
ment of switching off the ignition
could cause serious damage.

A heavy object (key fob...), attached
to the key and weighing down on
its shaft in the ignition switch, could
cause a malfunction. Never turn the key to this position
when the engine is running.

Downloaded from www.Manualslib.com manuals search engine IV
83
ACCESS














Lost keys

Visit a CITROËN dealer with the ve-
hicle's registration document, your
personal identifi cation documents
and if possible the key code label.
The CITROËN dealer will be able to
fi nd the key code and the transpon-
der code required to order a new
key.


Remote control

The high frequency remote control is
a sensitive system; do not operate it
while it is in your pocket as there is a
possibility that it may unlock the ve-
hicle, without you being aware of it.
Do not repeatedly press the buttons
of your remote control out of range
and out of sight of your vehicle. You
run the risk of stopping it from work-
ing and the remote control would
have to be reinitialised.
The remote control does not operate
when the key is in the ignition switch,
even when the ignition is switched
off, except for reinitialisation.


Locking the vehicle

Driving with the doors locked may
make access to the passenger com-
partment by the emergency services
more diffi cult in an emergency.
As a safety precaution (with children
on board), remove the key from the
ignition switch when you leave the
vehicle, even for a short time.


Anti-theft protection

Do not make any modifi cations to
the electronic engine immobiliser
system; this could cause malfunc-
tions.


When purchasing a second-
hand vehicle
Have the pairing of all of the keys
in your possession checked by a
CITROËN dealer, to ensure that
only your keys can be used to open
and start the vehicle.







Do not throw the remote
control batteries away, they
contain metals which are
harmful to the environment.
Take them to an approved collection
point.

Downloaded from www.Manualslib.com manuals search engine IV
92
ACCESS
FUEL TANK

Capacity of the tank: approxi-
mately 60 litres.



Low fuel level

When the low fuel level is
reached, this warning lamp
on the instrument panel
comes on, accompanied by
an audible warning and a message
on the multifunction screen.
When it fi rst comes on, about 7 litres

of fuel remain in the tank.
Until suffi cient fuel has been
added, this warning lamp appears
every time the ignition is switched
on, accompanied by an audible
warning and a message. Depending
on version, this audible warning
and message are repeated with
increasing frequency as the fuel
level drops towards " 0
".
Refuel as soon as possible to avoid
running out. A label on the inside of the fuel fi ller
fl ap reminds you of the type of fuel
to use, depending on your engine
type.
Additions of fuel must be of at least
5 litres to be registered by the fuel
gauge.

Refuelling


If you are fi lling your tank to
the top, do not persist after the
3rd cut-off; this could cause
malfunctions.






With Stop & Start, never refuel with
the system in STOP mode; you
must switch off the ignition with the
key. Opening the fi ller cap may result in
an inrush of air. This is entirely nor-
mal and results from the sealing of
the fuel system.


)
Press control switch A
, situated
on the switch panel on the left of
the dashboard, until the fuel fl ap
opens.
This control switch remains ac-
tive for a few minutes after
switching of the ignition. If nec-
essary, switch the ignition on
again to reactivate it.

)
Take care to select the pump
that delivers the correct type of
fuel for your vehicle.

)
Introduce the nozzle so as to push
in the metal non-return fl ap B.

)
Make sure that the nozzle is
pushed in as far as possible
before starting to refuel (risk of
blowback).

)
Maintain this position throughout
the refuelling operation.

)
Push the fuel fl ap to close it.