2010 CITROEN C ZERO brake

8
Practical information
103
Changing a direction indicator bulb
) Turn the bulb holder to the left and
pull it out. ) Pull the bulb out and replace it.
To r efit, carry out these operations in reverse order.
Access to bulbs
)Remove the two screws. )Disengage the lamp unit by pulling it
towards you.

Changing a brake/sidelamp bulb

All work on the LED lamps must be carried out
by a CITROËN dealer or a qualified workshop.


Changing a reversing lamp bulb
)
Turn the bulb holder to the left and pull it out.)
Pull the bulb out and replace it.
To r efit, carry out these operations in reverseorder.

Practical information
104
Changing a foglamp bulb (W21W - 21W)
)Remove the cover.)Turn the bulb holder to the left andpull it out. )Pull the bulb out and replace it.
To r e f i t , c a r r
y out these operations in reverse order.

Changing the third brake lamp(W5W - 5W)
)
Remove the two screws. )
Remove the bulb holder.)
Pull the bulb out and replace it.
To r efit, carry out these operations in reverse
order.


Changing a number plate lamp
bulb (W5W - 5W)
)Push the cover inwards.)Turn the bulb holder and pull it out.)Pull the bulb out and replace it.
To r efit, carry out these operations in reverse
order.

i
Practical information
108
Fuse N°RatingFunctions
1- Not used.
230 A Internal fuse.
340 A Electric motor.
440 A
Radiator fan.
5
40 A Electric windows.
6
30 A
Vacuum pump.
715 A
Main battery ECU.
815 A
Third brake lamp.
915 A
Front foglamps.
1015 A
Water pump.
Front compartment fuses
The fusebox is placed in the front compar tment
under the heating system reservoir. Only these
fuses can be replaced.

The replacement of fuses for other units (vacuum pump and battery accessories) requires the involvement of a CITROËNdealer or a qualified workshop.

i !
!
Practical information
110





Towing the vehicle
Procedure for having your vehicle towed using fixed mechanical equipment.


To w i ng your vehicle

The towing eye is welded to the body below
the front bumper.) Install the towing bar. )
Start your vehicle ("Ready" lamp on).)
Put the drive selector in position N . )
Release the parking brake.)
Switch on the hazard warning lamps onyour vehicle.)
Have your vehicle towed for no more than 20 miles (30 km) without exceeding a speed of 20 mph (30 km/h)
.


When towing the vehicle with the four wheels on the ground, always use a towing bar.
When towing with only two wheels onthe ground, use professional lifting equipment.


Failure to follow these instructions may cause damage to braking components and the electric motor.









Changing
a wiper blade
Removing a front or rear
wiper blade
)Raise the corresponding wiper arm.)Remove the wiper blade, sliding it towards
the outside.
Fitting a front or rear wiper
blade
)Put the new wiper blade in place and
secure it. )Fold down the wiper arm carefully.



To w i ng another vehicle

Your vehicle cannot be used in any circumstances to tow another vehicle.

9
!
Checks
115
Screenwash fluid reservoir. 2.Heater fluid reservoir.3.Brake fluid reservoir.4.
Ancillaries battery.
5. Fusebox.












Front compartment

To avoid damaging electricalcomponents, the use of a high pressure jet washer in the front compartment is strictly prohibited.

9
!
Checks
117


























Checking levels Check all of these levels regularly and top them up if necessary, unless other wise indicated.
If a level drops significantly, have the corresponding system checked by a CITROËN dealer or a qualified workshop.


Never do anything in the compar tmentswhen the "Ready" lamp is on or whenyour vehicle is being charged. Take care when carrying out checks in the front and rear compartments assome parts of the compartments canbe very hot (risk of burns): wait at leastone hour after stopping the motor or the end of the charging procedure beforecarrying out any work.

Brake fluid level
The brake fluid level should be
between the "MIN" and "MA X"
marks. If it is not, check the brakepad wear.
Changing the fl uid
Refer to the ser vicing booklet for details ofthe inter val for this operation.
Fluid specifi cation
The brake fluid must conform to the
manufacturer's recommendations and meetthe DOT4 standard.

Front compartment

Heatin
g system fluid level


Changing the fl uid

The fluid does not have to be changed.


Fluid specifi cation

The fluid must conform to the manufacturer's
recommendations. Th
e level of this fluid should be between the "L"MIN and "F" MA X marks.


Screenwash fluid level

Top up the level when necessary.


Fluid specifi cation

For optimum cleaning and to avoid freezing,
this fluid must not be topped up or replaced
with plain water.

9
i
Checks
119










Checks
Unless other wise indicated, check these components in accordance with the ser vicing booklet.
Other wise, have them checked by a CITROËN dealer or a qualified workshop.


Passenger compartment filter

Refer to the ser vicing booklet for
details of the replacement inter vals
f
or this filter.
Depending on the environment (e.g. dusty atmosphere) and the use of the
vehicle (e.g. city driving), replace it twice as often if necessar y.y A dirty passenger compartment filter may have
an adverse effect on the performance of the air conditioning system and generate undesirableodours.
Brake wear depends on the style
o
f driving, par ticularly in the case
of vehicles used in town, over shor t
distances. It ma
y be necessary tohave the condition of the brakes checked, evenbetween vehicle services.
Unless there is a leak in the circuit, a drop in
the brake fluid level indicates that the brake
pads are worn.
Brake pads
Only use products recommended by CITROËN or products of equivalent quality and specifications. In order to optimise the operationof units as impor tant as the braking system, CITROËN selects and offers very specific products.
Parking brake

If a loss of effectiveness of thissystem is noticed, the parking brakemust be checked, even between two services.
This system must be checked by a CITROËN
dealer or a qualified workshop.
Brake disc/drum wear
For information on checking the
brake disc or drum wear, contact
a CITROËN dealer or a qualified
workshop.

.
Visual search
151
Exterior
Remote control key 31- 32- opening/closing - central locking - anti-theft protection Starting - Stopping the vehicle 52
Lighting 56-58 Headlamp height adjustment 58 Changing bulbs 97-102- front lamps - foglamps- daytime running lamps - direction indicator repeaters
Wipers 59Changing a wiper blade 110
Door mirrors 42
Doors 35 - opening/closing Electric windows 34
Charging flaps 37 Charging the main battery 80-85- normal - fast

Accessories 111

ABS, EBFD, ASR, ESP 70 -72Tyre pressures 123Changing a wheel 94-96
Boot 36- opening/closing


Changing bulbs 102-104- rear lamps - 3rd brake lamp- number plate lamps - foglamp

To w i ng 11 0