2010 CHRYSLER TOWN AND COUNTRY radio

Using HomeLink
To operate, press and release the programmed
HomeLinkbutton. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.,). The handheld transmitter of the device may also be
used at any time.
Reprogramming a Single HomeLink Button
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button until
the indicator light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button, proceed with Program-
ming HomeLink Step 2 and follow all remaining steps.
Gate Operator/Canadian Programming
Canadian radio frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of trans-
mission – which may not be long enough for HomeLink
to pick up the signal during programming. Similar to this
Canadian law, some U.S. gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink” Step 3, with the following:
3. Continue to press and hold the HomeLink button,
while you press and release (“cycle”), your handheld
transmitter every two seconds until HomeLink has
196 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

UNDERSTANDING YOUR INSTRUMENT PANEL
CONTENTS
Instrument Panel Features ............... 231
 Instrument Cluster .................... 232
 Instrument Cluster Descriptions ........... 233
 Compass Mini-Trip Computer (CMTC) —
If Equipped .......................... 247
▫ CMTC Reset Buttons .................. 247
▫ Compass/Temperature Display .......... 249
 Electronic Vehicle Information Center (EVIC) —
If Equipped .......................... 250 ▫
Electronic Vehicle Information Center (EVIC)
Displays ........................... 252
▫ Trip Functions ...................... 254
▫ Compass Display / ECO (Fuel Saver Mode)
— If Equipped ...................... 256
▫ Personal Settings
(Customer-Programmable Features) ....... 258
 Media Center 730N/430 (RER/RBZ) —
AM/FM Stereo Radio And CD/DVD/HDD/
NAV — If Equipped .................... 263
4

▫Operating Instructions — Voice Command
System (VR) — If Equipped ............. 263
▫ Operating Instructions — Uconnect™ Phone
— If Equipped ...................... 263
▫ Clock Setting Procedure — RBZ Radio ..... 263
▫ Clock Setting Procedure — RER Radio ..... 265
 Media Center 130 (RES) — AM/FM Stereo
Radio With CD Player (MP3 AUX Jack) ....... 267
▫ Operating Instructions — Radio Mode ..... 268
▫ Operation Instructions — CD Mode For CD
And MP3 Audio Play ................. 271
▫ Notes On Playing MP3 Files ............ 273
▫ Operation Instructions - Auxiliary Mode .... 276
Media Center 130 (RES/RSC) — AM/FM
Stereo Radio With CD Player (MP3 AUX Jack)
And Sirius Radio ...................... 276
▫ Operating Instructions — Radio Mode ..... 277
▫ Operation Instructions — CD Mode For CD
And MP3 Audio Play ................. 282
▫ Notes On Playing MP3 Files ............ 284
▫ List Button (CD Mode For MP3 Play) ...... 287
▫ Info Button (CD Mode For MP3 Play) ...... 287
 Universal Consumer Interface (UCI) 0.5 —
If Equipped .......................... 289
▫ Connecting The iPod ................. 289
▫ Using This Feature ................... 290
▫ Controlling The iPod Using Radio
Buttons ........................... 290
228 UNDERSTANDING YOUR INSTRUMENT PANEL

▫Play Mode ......................... 290
▫ List Or Browse Mode ................. 292
 Uconnect™ Multimedia (Satellite Radio) —
If Equipped (REN/RER/RBZ/RES Radios
Only) ............................... 294
▫ System Activation .................... 294
▫ Electronic Serial Number/Sirius
Identification Number (ESN/SID) ......... 294
▫ Selecting Uconnect™ Multimedia (Satellite)
Mode ............................. 295
▫ Satellite Antenna ..................... 295
▫ Reception Quality .................... 295
▫ Operating Instructions - Uconnect™
Multimedia (Satellite) Mode ............. 296▫
Operating Instructions - Uconnect™ Phone
(If Equipped) ....................... 298
 Uconnect™ Multimedia (Sirius Backseat TV™)
— If Equipped ........................ 298
 Video Entertainment System (VES)™ —
If Equipped .......................... 298
 Remote Sound System Controls —
If Equipped .......................... 300
▫ Radio Operation ..................... 301
▫ CD Player ......................... 301
 CD/DVD Disc Maintenance .............. 302
 Radio Operation And Cellular Phones ....... 302
 Climate Controls ...................... 303
▫ Manual Heating And Air Conditioning
System — If Equipped ................. 303
4
UNDERSTANDING YOUR INSTRUMENT PANEL 229

INSTRUMENT PANEL FEATURES
1 — Air Vents5 — Analog Clock 9 — DVD – If Equipped 13 — Switch Bank
2 — Instrument Cluster 6 — Upper Glove Compartment 10 — Cup Holders 14 — Ignition Switch
3 — Shift Lever 7 — Lower Glove Compart-
ment11 — Storage Bin
15 — Dimmer Switch
4 — Radio 8 — Climate Controls12 — Power Supply – 12V 16 — Headlight Switch
4
UNDERSTANDING YOUR INSTRUMENT PANEL 231

26. Compass Mini-Trip Computer (CMTC) or Electronic
Vehicle Information Center (EVIC) Display — If
Equipped
Compass Mini-Trip Computer (CMTC) Display — If
Equipped
On vehicles equipped with Compass Mini-Trip Com-
puter (CMTC), the display provides the outside tempera-
ture, one of eight compass headings to indicate the
direction the vehicle is facing, and the current radio
station. For further information refer to “Compass Mini-
Trip Computer”.
Electronic Vehicle Information Center (EVIC) Display
— If Equipped
The Electronic Vehicle Information Center (EVIC) fea-
tures a driver-interactive display that is located in the
instrument cluster. For further information refer to “Elec-
tronic Vehicle Information (EVIC)”.27. Compass Mini-Trip Computer (CMTC) Display
Button
Press the left reset button to scroll through sub-menus
(i.e., Outside Temperature, Trip Functions: AVG Fuel
Economy, DTE, Elapsed Time, and Units). Press and hold
the reset button for approximately two seconds, to reset
the display shown.
28. Fuel Door Reminder
The arrow in this symbol is a reminder that the
Fuel Filler Door is located on the left side of the
vehicle.
246 UNDERSTANDING YOUR INSTRUMENT PANEL

COMPASS MINI-TRIP COMPUTER (CMTC) — IF
EQUIPPED
NOTE:
•The compass on your vehicle is self-calibrating, elimi-
nating the need to manually calibrate the compass.
•If the vehicle is equipped with a Chrysler ™ gps
(Navigation Radio), the NAV system will provide the
compass direction, and the variance and calibration
menus will be unavailable. The compass will perform
accurately, based on GPS signals instead of the Earth’s
magnetic field.
The Compass Mini-Trip Computer is located in the
instrument cluster and features a driver-interactive dis-
play (displays information on outside temperature, com-
pass direction, and trip information). NOTE:
The system will display the last known outside
temperature when starting the vehicle and may need to
be driven several minutes before the updated tempera-
ture is displayed. Engine temperature can also affect the
displayed temperature, therefore temperature readings
are not updated when the vehicle is not moving.CMTC Reset Buttons
CMTC Reset Button
Press the left reset button located on the instrument
cluster to scroll through sub menus (i.e., Trip Functions:
AVG Fuel Economy, DTE, Elapsed Time, and Units).
To reset the display shown, turn the ignition switch to the
ON position, then press and hold the reset button for
approximately two seconds.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 247

Auto UNLK On Exit
When ON is selected, all doors will unlock when the
vehicle is stopped and the transmission is in the PARK or
NEUTRAL position and the driver’s door is opened. To
make your selection, press and release the RESET button
until ON or OFF appears.
RKE Unlock
WhenDriver Door 1st Press is selected, only the driver’s
door will unlock on the first press of the Remote Keyless
Entry (RKE) transmitter UNLOCK button. When Driver
Door 1st Press is selected, you must press the RKE
transmitter UNLOCK button twice, to unlock the passen-
ger’s doors. When All Doors 1st Press is selected, all of
the doors will unlock on the first press of the RKE
transmitter UNLOCK button. To make your selection,
press and release the RESET button until “Driver Door
1st Press” or “All Doors 1st Press” appears.
RKE Linked To Memory
When this feature is selected the memory seat, mirror,
and radio settings will return to the memory set position
when the RKE transmitter UNLOCK button is pressed. If
this feature is not selected then the memory seat, mirror,
and radio settings can only return to the memory set
position using the door mounted switch. Pressing the
RESET button when in this display will select Ye sor
No.
Flash Lamp Lock
When ON is selected, the front and rear turn signals will
flash when the doors are locked or unlocked with the
RKE transmitter. This feature may be selected with or
without the sound horn on lock feature selected. To make
your selection, press and release the RESET button until
ON or OFF appears.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 259