2
Exterior Lamps
ControlTurn Signal Lever/
Driver Information
Center ControlsInstrument
Cluster
Tilt/Telescopic
Steering Wheel
Lever Cruise
Control
ButtonsWindshield
Wipers Lever
Hood Release
Lever Storage/Fuse
Panel Access
Instrument Panel
Safety Belt
Reminder
Check Engine
Low Tire Pressure
Brake System
Warning
Antilock Brake
System WarningCharging System
Oil Pressure
Airbag Readiness
Security
Fog Lamps
Cruise Control On/Set
Traction Control OffStabiliTrak/Traction
Control Off
StabiliTrak/Traction
Control Warning
Lights On
Audio Steering
Wheel Controls
Symbols
5
Keyless Access StartF
Start
With the vehicle in Park or Neutral, press the brake pedal and then press and hold the
START/STOPbutton to start the engine.
Note: The transmitter must be in the vehicle to turn on the ignition. If the transmitter battery is weak,
insert the transmitter into the slot beneath the removable cupholder tray in the center console to
enable the engine to start.
Stop
Shift to Park and press theSTART/STOP button to turn off the engine. Power to the audio
system will be active until the driver’s door is opened, and power to the windows and
sunroof will be active until either front door is opened.
Accessory
With the engine off, press the START/STOPbutton once to place the ignition system in
the accessory position.
See Driving and Operating in your Owner Manual.
Adaptive Remote StartF
During a remote start, the vehicle’s automatic climate control system will operate at the
same setting as when the vehicle was last turned off and, based on outside temperature,
the windshield defroster and/or rear defogger will turn on.
Starting the Vehicle
1. Aim the keyless access transmitter at the vehicle. (Transmitter range depends on
operating conditions.)
2. Press and release the Lockbutton on the transmitter.
3. Immediately press and hold the Remote Start button for at least two seconds.
When the vehicle starts, the parking lamps will light and remain on while the engine is
running. The engine will continue running for 10 minutes.
4. Repeat these steps for a 10-minute time extension. Remote start can be extended
only once.
After a remote start, the ignition must be turned to the On position by pressing the START
button before driving.
Canceling a Remote Start
• Press and hold the Remote Start button until the parking lamps turn off.
Note: Several conditions will cause the Adaptive Remote Start feature not to operate, such as if the
hood or doors are not closed.
See Keys, Doors and Windows in your Owner Manual.
