Possible cause:
Coolant level too low.
Checking coolant level (72).
If the coolant level is too low:
Topping up coolant (73).
Possible cause:
Radiator fan defective.
If the radiator fan does not starteven though the coolant-temper-ature warning light shows:
Have the fault rectified asquickly as possible by aspecialist workshop, preferablyan authorised BMW Motorraddealer.
Possible cause:
Insufficient cooling.
If possible, ride in the part-loadrange to cool down the engine.
In traffic jams, switch off theengine, but leave the ignitionswitched on so that the radiat-or fan continues to operate.
If the coolant temperature isfrequently too high, have thefault rectified as soon as pos-sible by a specialist workshop,preferably an authorised BMWMotorrad dealer.
ABS warnings
Mode of presentation
ABS warnings are indicated byABS warning light1.
The detailed descriptions start onpage (54), and you will findan overview listing the possiblewarnings on the next page.
3
23
zStatus indicators
Wait until the warning light forthe coolant temperature stopsflashing.
The idle actuator is posi-tioned after you switch onthe ignition. The coolant-tem-perature warning light flashesif the idle actuator has not cor-rectly positioned before the pre-ride check completes. In orderto avoid subsequent problems,wait for this process to completebefore proceeding.
Press starter button2.
If ambient temperatures arevery low, you might find itnecessary to open the throttleslightly when starting the engine.At ambient temperatures below0 °C, disengage the clutch afterswitching on the ignition.
If the engine fails to starteven though the starterturns, insufficient battery voltagemight be causing the problem.Recharge the battery before youstart the engine, or use jumpleads and a donor battery tostart.
The engine starts.
Consult the troubleshootingchart below if the engine re-fuses to start. (106)
ABS self-diagnosis
BMW Motorrad ABS performsself-diagnosis to ensure its op-erability. Self-diagnosis is per-formed automatically when youswitch on the ignition. The mo-
torcycle has to move forward afew metres for the wheel sensorsto be tested.
Phase 1
Test of the diagnosis-compat-ible system components withthe motorcycle at a standstill.
ABS warning light flashes.
Phase 2
Test of the wheel sensors asthe motorcycle pulls away fromrest.
ABS warning light flashes.
ABS self-diagnosiscompleted
The ABS warning light goesout.
5
45
zRiding
Coolant temperatureWarning, 22
DDampingAdjuster, rear, 13
Adjusting, 36
Dimensions, 117
EElectricsTechnical data, 114
Emergency off switch (killswitch), 17, 32
EngineStarting, 17, 44
Technical data, 109
Engine oilChecking fill level, 66
Filler neck, 11
Oil dipstick, 11
Technical data, 110
Topping up, 68
Engine oil pressureWarning, 22
Equipment, 6
FFrameTechnical data, 116
Front-wheel stand, 83
FuelFiller neck, 13
Refuelling, 49
Technical data, 110
Warning, 22
Fuses, 14
GGeneral viewscentre handlebar fitting, 18
Instrument panel, 15
Left handlebar fitting, 16
Left side, 11
Right handlebar fitting, 17
Right side, 13
Telltale lights, 20
Underneath the seat, 14
Grip heatingControl, 17
Operation, 33
HHandlebar fitting, centreOverview, 18
Handlebar fitting, leftOverview, 16
Handlebar fitting, rightOverview, 17
Hazard warning flashersControl, 18
Operation, 31
HeadlightBeam throw, 37
Driving on right/driving onleft, 37
Headlight flasher, 16, 31
High-beam headlightSwitch, 16
Switching on, 31
Telltale light, 20
Horn, 16
IIdleTelltale light, 20
12
130
zIndex
