2010 Alfa Romeo MiTo oil

GETTING TO KNOW YOUR CAR15
1
ON CONSTANTLY:Low engine oil pressure(red)
FLASHING:Engine oil exhausted
(Diesel versions with DPF only - red)
When the ignition key is moved to MAR, the warning
light switches on, and should go out as soon as the engine is start-
ed.
1. Low engine oil pressure
The warning light turns on and stays on constantly (in ver-
sions/markets, where applicable) along with the message on the
display when the system detects that the engine oil pressure is low.
v
If the warning light vturns on when the vehi-
cle is travelling (on certain versions together with
the message on the display) stop the engine im-
mediately and contact Alfa Romeo Authorised Service.
2. Engine oil exhausted(Diesel versions with DPF only)
When the key is turned to the MAR position, the warning light
comes on, but it must switch off after a few seconds. The warn-
ing light will flash and a specific message will appear on the dis-
play (in versions/markets, where applicable). The warning light
may flash in the following ways, depending on the version:
– for 1 minute every two hours;
– for 3 minute cycles with the warning light off for intervals of 5
seconds until oil is changed.After the initial warning, each time the engine is started up, the
warning light will continue to flash for 60 seconds in the same
mode, until the oil is changed. A specific message will appear on
the display (for versions/markets, where applicable) in addition
to the warning light.
If the warning light flashes, this does not mean that the car is de-
fective, but simply informs the driver that it is now necessary to
change the oil as a result of regular vehicle use.
Note that engine oil is exhausted faster under the following cir-
cumstances:
– use of the vehicle prevalently for city driving, requiring more
frequent regeneration of DPF
– use of the vehicle for short drives, in which the engine does not
have time to reach its regular operating temperature
– repeated interruption of the regeneration process, signalled by
the DPF warning light coming on.
Exhausted engine oil should be replaced as soon
as possible after the warning light comes on, nev-
er more than 500 km after the warning light first
comes on. Failure to change the oil within the first 500
km may result in severe damage to the engine and will
result in forfeiture of the warranty. Remember that when
the warning light flashes, it does not mean that the level
of engine oil is low, so if the light flashes you must not top
up the engine oil.
001-130 Alfa MiTo GB 2ed 23-12-2009 12:35 Pagina 15

22GETTING TO KNOW YOUR CAR
Speed limit exceeded (red)
(for versions/markets, where provided)
This warning light (for versions/markets, where pro-
vided) comes on when the vehicle speed exceeds 120
km/h.
When the vehicle exceeds the speed limit set in the Setup Menu
(e.g. 120 km/h), on some versions a message and symbol are
shown in the display and a buzzer sounds.
X
General failure (amber)
(for versions/markets, where provided)
On some versions, this warning light comes on under the
following circumstances:
External lights failure
See description of 6warning light.
Brake lights failure
See description of “brake lights failure”.
Fuel lock
This warning light comes on when the fuel cut-off inertia switch is
triggered. The display will show the dedicated message.
è
Particulate trap filter blocked
(Diesel with DPF versions) (amber)
When the ignition key is turned to MAR, the warning
light switches on but it must switch off after a few seconds.
The warning light comes on constantly to notify the driver that
the DPF system needs to eliminate captured pollutants (particu-
late) by the regeneration process. The warning light does not come
on during every DPF regeneration, but only when driving conditions
require notification of the driver. To switch the warning light off,
the car must stay in motion until regeneration has been complet-
ed. The process normally takes about 15 minutes. The optimum
conditions to end the process are achieved by keeping the car in
motion up to 60km/h with an engine speed higher than 2,000
rpm. This light coming on is not a car defect and therefore the car
does not need to go to the workshop.
A specific message will appear on the display when the warning
light comes on (for versions/markets, where provided).
h
Always drive at a speed appropriate to the traffic
conditions, the weather and speed limits. The en-
gine may be turned off while the DPF light is on;
however, repeated interruption of the regeneration process
may result in premature exhaustion of engine oil. For this
reason it is always advisable to wait for the light to go
off before turning off the engine, following the instruc-
tions appearing above. It is not advisable to complete DPF
regeneration with the vehicle stationary.
001-130 Alfa MiTo GB 2ed 23-12-2009 12:35 Pagina 22

40GETTING TO KNOW YOUR CAR
Ser vice (Scheduled ser vicing)
This function allows you to view information on car servicing de-
pending on kilometres travelled or daily intervals.
With the Service function it is also possible to view the interval
(in kilometres or miles) before the next engine oil change is due.
This information can be consulted as follows:
– briefly press MENU ESC: the display shows service requirements
in km or mi according to the previous setting (see paragraph “Dis-
tance unit of measurement”);
– briefly press the MENU ESC button to go back to the menu screen
or hold the button down to go back to the standard screen.IMPORTANT The “Planned Maintenance Programme” requires the
vehicle to be serviced every 30,000 km (for petrol versions), or
every 35,000 km (for diesel versions). This message is displayed
automatically when the key is turned to MAR, from 2,000 km
(or equivalent value in miles) from the mileage when the next ser-
vice is due and is re-displayed every 200 km (or equivalent value
in miles). The indications will appear more frequently when there
are less than 200 km left. The indication will appear in kilome-
tres or miles according to the unit of measurement settings. When
the next scheduled service operation is approaching, the message
“Service” will appear on the display followed by the number of
kilometres or miles left, when the key is turned to MAR. Go to an
Alfa Romeo Authorised Service where the “Scheduled Service” op-
erations will be performed and the message will be reset.
001-130 Alfa MiTo GB 2ed 23-12-2009 12:35 Pagina 40

92GETTING TO KNOW YOUR CAR
ELECTRIC SUNROOF
(for versions/markets, where provided)
The extensively glazed sun roof comprises a moving glass panel
and a sun blind. The glazed panel, when closed, allows light from
the outside to enter and makes it possible to see the outside from
the passenger compartment.
When it opens the front glass panel slides towards the outside of
the roof.
OPERATION
The sun roof is operated by pressing buttons A and B-fig. 53 located
on the trim next to the middle courtesy light.
The sun roof can only be operated with the ignition key in the MAR
position.
Roof opening
Pressing button A-fig. 53 allows two opening modes for the front glass
panel.
Automatic
If button A-fig. 53 is pressed for a while, the front glass panel is raised
from completely closed to the spoiler position. If the button is pressed
again, the panel starts to slide backwards until it is completely open.
After the initial opening command the glass panel can be stopped in
intermediate positions by pressing the button again.
Manual
If button A-fig. 53 is pressed briefly, the front glass panel moves from
the completely closed position and stops in the position where the but-
ton is released. In this case the panel opens by pressing the actual
button.
This function makes it possible to place the front panel in intermedi-
ate positions in relation to those produced through automatic open-
ing.
fig. 53A0J0329m
The sun roof must stay closed if a transverse roof
rack is fitted.
001-130 Alfa MiTo GB 2ed 23-12-2009 12:36 Pagina 92

GETTING TO KNOW YOUR CAR93
1
Sun blind
The brightness in the passenger compartment can be adjusted by
using a sun blind.
Curtain opening:press the button A - fig. 54 to release the
curtain and then grasp the handle B and make it slide towards
the back.
Curtain closing:grasp the handle B and make the curtain slide to
the front, making sure it is locked.
Roof closing
Pressing button B-fig. 53 allows two closing modes for the front
glass panel.
Automatic
With the roof completely open, press button B-fig. 53 for a while:
the front glass panel will assume the spoiler position.
If the button is then pressed, the panel will start to slide forward
until it is completely closed.
After the initial opening command, the glass panel can be stopped
in intermediate positions by pressing the button again.
Manual
If button B-fig. 53 is pressed briefly, the front glass panel moves
from the completely open position and stops in the position where
the button is released. In this case the panel closes by pressing
the actual button.
This function makes it possible to place the front glass panel in in-
termediate positions in relation to those produced through auto-
matic closing.
When leaving the car, always remove the key from
the ignition device to avoid the risk of injury due
to accidental operation of the sun roof; it presents
a risk to those left on board: improper use of the roof can
be dangerous. Before operation, always check that no-
one is at risk of being injured by the moving sun roof or
by objects getting caught and dragged by it.
Do not open the sun roof in the presence of snow
or ice: it may be damaged.
fig. 53A0J0157m
001-130 Alfa MiTo GB 2ed 23-12-2009 12:36 Pagina 93

94GETTING TO KNOW YOUR CAR
ROOF CLOSING SAFETY DEVICES
(anti-crush function)
The anti-crush safety system, which conforms to Directive
2000/4/CE, is activated during the horizontal and vertical clos-
ing stage of the panel after an obstacle is encountered (e.g. fin-
ger, hand):
❍during the horizontal closing movement it is activated for the
entire travel and after an obstacle is encountered at the front
of the glass panel the movement is reversed;
❍during the vertical closing movement it is activated and after
an obstacle is encountered at the back of the glass panel the
movement is reversed until the spoiler position is reached.
The possibility of crushing from inside the passenger compartment
in the side areas of the panel is prevented through the adoption
of side guards that deny access to the risk areas.
IMPORTANT The anti-crush safety system is deactivated by press-
ing button B-fig. 53 continuously.
MAINTENANCE/EMERGENCY
In case of emergency or maintenance the roof can be moved man-
ually when there is no power supply (opening/closing of the front
glass panel) by carrying out the following operations:
❍remove the protective cap A-fig. 55 located in the middle of
the roof;
❍take the Allen key B supplied which can be found together with
the on board documentation;
❍introduce the key into housing C and turn it:
– clockwise, to open the roof;
– anti-clockwise, to close the roof.
fig. 55A0J0328m
001-130 Alfa MiTo GB 2ed 23-12-2009 12:36 Pagina 94

102GETTING TO KNOW YOUR CAR
Repositioning the rear seat
Move the seat belts making sure that they are correctly extended
with no coils.
Lift up the backrests and push them back until a click is heard for
both mechanisms. Make sure that red strip on levers A-fig. 65. is
no longer visible; if it is, this indicates that the backrest has not
engaged.
Reposition the head restraints into their housings.
❍raise backrest levers A-fig. 65 and fold the required cushion for-
ward (when lever A is raised this is indicated by a red strip).
fig. 64A0J0083mfig. 65A0J0082m
001-130 Alfa MiTo GB 2ed 23-12-2009 12:36 Pagina 102

STARTING UP AND DRIVING159
3
Roof rack/ski rack
Remove the roof rack or the ski rack from the roof after use. These
accessories decrease aerodynamic penetration of the car and have
a negative effect on fuel consumption. It is better to use a trailer,
particularly for transporting bulky objects.
Electric devices
Use electric devices only for the amount of time needed. The heat-
ed rear windscreen, additional headlights, windscreen wipers and
heater fan require a considerable amount of energy; increasing the
current uptake increases fuel consumption (by up to +25% in an
urban cycle).
Climate control
Using the climate control system increases fuel consumption: use
the air vents when outdoor temperature permits.
Spoilers
The use of non-certified spoilers may adversely affect air drag and
fuel consumption.
DRIVING STYLE
Starting
Do not warm the engine up with the car at a standstill and do not
use excessive engine speeds: the engine warms up very slowly in
these conditions, increasing fuel consumption and emissions. It is
advisable to start off immediately and slowly, keeping the engine
speed down: the engine will warm up much faster this way.
Unnecessary actions
Avoid revving up when starting at traffic lights or before stopping
the engine. The latter action, like double-declutching, is unneces-
sary and causes increased fuel consumption and pollution.
Gear selection
When traffic and road conditions allow, use a high gear. Using a
low gear for faster acceleration will increase fuel consumption. In
the same way improper use of a high gear increases consump-
tion, emissions and engine wear.
Top speed
Fuel consumption considerably increases as speed increases. Keep
your speed as even as possible, avoiding unnecessary braking
and acceleration which cause excessive fuel consumption and in-
creased emissions.
153-162 Alfa MiTo GB 2ed:153-162 23-12-2009 12:37 Pagina 159