2010 Alfa Romeo GT Fluids

GETTING TO KNOW YOUR CAR
89
AUTOMATIC TWO-ZONE CLIMATE CONTROL SYSTEM
(for versions/markets where applicable)
To start the system (fig. 96):
- turn the knob rings to set the required
temperatures (driver’s side - passenger’s
side).
- press the
AUTObutton.
IMPORTANTThe climate control sys-
tem makes it possible to personalise the
temperatures required on the two side
with a maximum difference of 7°C
between the driver’s side and the passen-
ger’s side.
IMPORTANTThe climate control com-
pressor can only work with the engine run-
ning and external temperature not very
low. With low external tem-
perature the climate con-
trol compressor is unable
to work. It is therefore inadvisable
to use the inside air recirculation
function vwith low outside tem-
perature as windows may mist
over quickly.
For further details about the system and
how to make the best use of it, read the
instructions given in pages that follow.
A0A0203b
fig. 96
The coolant used for the
climate control system is
R134a which meets cur-
rent regulations and does not harm
the environment in the event of ac-
cidental spillage.
Absolutely avoid the use of oth-
er fluids which are incompatible
with the system components.

CAR MAINTENANCE
It is however wise to remember that Pro-
grammed Maintenance does not complete-
ly cover all the car’s requirements: also in
the initial period before the 20,000 km ser-
vice coupon and later, between one coupon
and another, ordinary care is still necessary
such as for example routinely checking and
topping up the level of fluids, checking the
tyre pressure, etc...
IMPORTANTThe Programmed Mainte-
nance coupons are specified by the Manu-
facturer. The failure to have them carried out
may invalidate the warranty.
The Programmed Maintenance service is
carried out by all Alfa Romeo Authorised Ser-
vices, at pre-established times.If during each operation, in addition to the
ones programmed, the need arises for fur-
ther replacements or repairs, these may be
carried out only with the explicit agreement
of the customer.
IMPORTANTYou are advised to contact
Alfa Romeo Authorised Services in the event
of any minor operating faults, without wait-
ing for the next service coupon.SCHEDULED
SERVICING
Correct maintenance is determined in en-
suring long car life under the best conditions.
This is why Alfa Romeo has programmed
a series of checks and maintenance opera-
tions every 20,000 km.
IMPORTANTOn versions fitted with re-
configurable multifunction display, at 2000
km from the maintenance deadline, the dis-
play will show “REFER TO SERVICE MANU-
AL” which is shown again turning the igni-
tion key to MAR, every 200 km. For fur-
ther details, see “Service” in the “Recon-
figurable multifunction display”.
C C
A A
R R
M M
A A
I I
N N
T T
E E
N N
A A
N N
C C
E E
216

CAR MAINTENANCE
221
Car maintenance should be
entrusted to Alfa Romeo
Authorised Services. For
routine and minor maintenance op-
erations you wish to carry out
yourself, always make sure you
have the proper equipment, genuine
Alfa Romeo spares and the neces-
sary fluids; do not however carry
out these operations if you have no
experience.IMPORTANT
Pollen filter
If the car is used frequently in dusty or
heavily polluted environments it is advisable
to replace the filtering element more fre-
quently; in particular it should be replaced if
a reduction of the amount of air admitted to
the passenger compartment is noted. IMPORTANT
Battery
It is advisable to check the battery charge,
preferably at the onset of winter, to prevent
the possibility of the electrolyte freezing.
This check should be carried out more fre-
quently if the car is used mainly for short
trips, or if it is fitted with accessories that
permanently absorb electricity even with the
ignition key removed, especially in the case
of after market accessories.
If the car is used in hot climates or partic-
ularly harsh conditions it is wise to check the
level of the battery fluid (electrolyte) more
frequently than specified in the Scheduled
Maintenance Programme.

CAR MAINTENANCE
222
fig. 1 - 1.8 T. SPARK version
A0A0736b
A0A0681b
CHECKING LEVELS
Never smoke while work-
ing in the engine compart-
ment; gas and inflammable
vapours may be present, with the
risk of fire.
When topping up take
care not to confuse the var-
ious types of fluids: they
are incompatible with one anoth-
er and could seriously damage the
car.
fig. 2 - 2.0 JTS version 1Engine oil - 2Battery - 3Brake fluid -
4Windscreen/rear window/headlight
washer fluid - 5Engine coolant - 6Power
steering fluid - 7Selespeed transmission oil
(2.0 JTS Selespeed versions)

CAR MAINTENANCE
226
The cooling system is
pressurised. If necessary,
replace the cap only with
another genuine one, otherwise
system efficiency could be compro-
mised. Do not remove the reservoir
cap when the engine is hot: you
risk scalding yourself.
The cooling system uses
PARAFLU UP antifreeze.
Do not add fluid having dif-
ferent specifications from that al-
ready existing. PARAFLU UP can-
not be mixed with other types of
fluids. Should other fluids be
added, do not start the engine and
contact Alfa Romeo Authorized
Services as soon as possible.ENGINE COOLANT FLUID
(fig. 10)
Do not remove the cap
when the engine is hot:
danger of burns.
The level of the coolant in the header tank
(reservoir) should be checked with the en-
gine cold and the car on a level surface and
it should be between the MINandMAX
marks on the tank.
fig. 10
A0A0240b
If the level is low, loosen the header tank
cap (A) and slowly pour a mixture of 50%
distilled water and 50% PARAFLU UP FL
Seleniathrough the filler neck until near-
ing the MAXmark.
The antifreeze mixture of 50% PARAFLU
UPand 50% distilled water guarantees pro-
tection down to –35 °C.

CAR MAINTENANCE
227
Oil consumption is very
low; if topping up again is
needed shortly afterwards,
have the system checked for pos-
sible leaks by Alfa Romeo Autho-
rised Services.Do not allow the power
steering fluid to touch hot
parts of the engine: it is in-
flammable.
fig. 12
A0A0217b
fig. 11
A0A0400b
BRAKE AND HYDRAULIC
CLUTCH FLUID
(fig. 12)
Check that the fluid level in the reservoir
is at maximum. Top up with the brake fluid
specified in the table “Fluids and lubricants”
(see section “Technical specifications").
NOTEClean accurately the tank cap A
and the surrounding surface. When opening
the cap take the utmost care to prevent im-
purities entering the tank. When topping up,
always use a funnel with built-in filter with
mesh equal to or lower than 0.12 mm.
IMPORTANTFor this operation it is
however recommended to contact Alfa
Romeo Authorised Services.
POWER STEERING FLUID
(fig. 11)
Check that the level of the oil in the reser-
voir is at maximum.
This operation should be carried out with
the car on a level surface and the engine
switched off and cold.
Check that the level reaches the MAX
mark on the reservoir or coincides with the
upper notch (maximum level) on the dip-
stick (A) integral with the reservoir cap.If the oil level in the reservoir is below the
specified one, top up only with one of the
products listed in the “Fluids and lubricants”
table in the “Technical specifications” chap-
ter proceeding as follows:
– Start the engine and wait for the oil lev-
el in the reservoir to stabilise.
– With the engine running, turn the steer-
ing wheel lock to lock a few times.
– Top up to the MAXlevel notch, then
refit the cap.

CAR MAINTENANCE
228
Do not travel with the
windscreen washer reser-
voir empty: the action of
the windscreen washer is funda-
mental for improving vision.
To avoid damaging the
pump motor, do not use the
windscreen/rearscreen
washers when the reservoir is
empty.
Some commercial addi-
tives for windscreen wash-
ers are inflammable. The
engine compartment contains hot
components which may set it on
fire.
IMPORTANTBrake and hydraulic clutch
fluid is hygroscopic (i.e. it absorbs moisture).
For this reason, if the car is mainly used in
areas with a high degree of atmospheric hu-
midity, the fluid should be replaced at more
frequent intervals than specified in the
Scheduled Maintenance Programme.
WINDSCREEN/REARSCREEN
HEADLIGHT WASHER FLUID
(fig. 13)
Open the cap (A) and check the level in
the reservoir.
If necessary top up using a mixture of wa-
ter and TUTELA PROFESSIONAL SC
35fluid as follows:
– 30% of TUTELA PROFESSIONAL
SC 35and 70% water in summer; Brake and clutch fluid is
poisonous and highly cor-
rosive. In the event of ac-
cidental contact, wash the parts
concerned immediately with neu-
tral soap and water, then rinse
thoroughly. See a doctor at once if
the fluid is swallowed.
Theπsymbol on the con-
tainer indicates synthetic
brake fluid, distinguishing
it from the mineral kind. Using min-
eral fluids irreversibly damages the
special braking system rubber
seals.
fig. 13
A0A0242b
– 50% of TUTELA PROFESSIONAL
SC 35and 50% water in winter;
– in the case of temperatures below
–20°C use TUTELA PROFESSIONAL
SC 35fluid neat. Make sure that the high-
ly corrosive brake fluid
does not drip onto the
paintwork. If it does, wash it off
immediately with water.

TECHNICAL SPECIFICATIONS
251
Weight empty (including fluids, 90% fuel
in the tank and no optional) kg
Payload (*) including
driver kg
Max permissible
weights (**):
– front axle kg
– rear axle kg
– total kg
Towable weights:
– braked trailer kg
– trailer without brake kg
Maximum load on ball
(braked trailer) kg
WEIGHTS
(*) With special equipment (trailer towing device, etc.) the loadless weight increases, thereby reducing the payload, with regard to the maximum permissi-
ble loads.
(**) Loads not to be exceeded. It is the driver’s responsibility to place goods in the boot and/or on the loading surface in accordance with the maximum
permissible loads.
JTD16V
1320
520
990
980
1885
1300
400
60
3.2V6
1410
520
1040
980
1930
1400
400
60
2.0 JTS
1320
520
980
980
1840
1300
400
60
1.8 T. SPARK
1290
520
980
980
1810
1300
400
60