2010 Alfa Romeo Giulietta tow

88
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
On some versions the compartments may be heated/cooled by an
air vent connected to the climate control system (operate wheel
A-fig. 55a to adjust the air flow rate to the lower compartment).
In versions with dual-zone automatic climate control system, the glove
compartment is set to the same temperature as the passenger's side.
In versions with dual zone automatic climate control system, a bot-
tle/can holder is present inside the compartment on passenger
side.
One 50 cl bottle and two slim cans can be fitted inside at the same
time. The handbook may be inserted under the bottle holder with
the longer side facing towards the front of the car.
fig. 55aA0K0185m
Do not travel with the compartments open: the
front seat occupants could be injured in case of
an accident.
FRONT ARM REST
(for versions/markets, where provided)
This is located between the front seats. To bring this to the stan-
dard position of use, push it down as shown in the figure.
There is a compartment inside the arm rest: lift the A cover
fig. 56 to access the compartment.
fig. 56A0K0166m
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:33 Pagina 88

125
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
DISPLAY INDICATIONS
(for versions/markets, where provided)
When the sensor is activated, the "Reconfigurable multifunctional
display" (for versions/markets where provided) shows the screen
illustrated in fig. 88a; the information about the presence of and
distance from the obstacle is given by the buzzer and also by a
visual indication on the instrument panel display. If there are se-
veral obstacles, the closest one is indicated.
BUZZER WARNINGS
When reverse gear is engaged a buzzer warning is automatically
activated if there is an obstacle within the range of operation.
The acoustic signal:
❍increases as the distance between the car and the obstacle de-
creases;
❍becomes continuous when the distance between the car and
the obstacle is less that 30 cm and stops immediately if the
distance increases;
❍remains constant if the distance between the vehicle and the
obstacle remains unchanged, whilst if this situation occurs for
the side sensors, the signal is interrupted after about 3 seconds,
for example, to prevent signals in the case of manoeuvres along-
side walls.
IMPORTANT The volume of the audible signal can be adjusted th-
rough the option "Warnings volume" of the "Set-Up menu".
OPERATION WITH TRAILER
Parking sensor operation is automatically turned off when the trail-
er electric cable plug is fitted into the car tow hook socket. The sen-
sors are automatically enabled again when the trailer cable plug
is removed.
The sensor must be free of mud, dirt, snow or ice
in order for the system to work. Be careful not to
scratch or damage the sensors while cleaning them.
Avoid using dry, rough or hard cloths. The sensors should
be washed using clean water with the addition of car sham-
poo if necessary. In washing stations, clean sensors quick-
ly keeping the vapour jet/high pressure washing noz-
zles at a distance of at least 10 cm from the sensors.
fig. 88aA0K0059m
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 125

135
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
PRETENSIONERS
The car is equipped with front seat belt pretensioners, which draw
back the seat belts by several centimetres in the event of a strong
frontal impact. This guarantees the perfect adherence of the seat
belts to the occupant’s bodies before the retention action begins.
It is evident that the pretensioners have operated when the belt
withdraws toward the reel.
This car is also equipped with a second pretensioner (in the kick
plate area). Its activation is signalled by the shortening of the met-
al cable.
A small amount of smoke may be produced when the pretension-
ers cut in. This smoke is not toxic and does not indicate a fire.
IMPORTANT To obtain the highest degree of protection from the ac-
tion of the pretensioner, wear the seat belt, keeping it close to
the chest and pelvis.
The pretensioner does not require any maintenance or lubrication.
Anything that modifies its original conditions invalidates its effi-
ciency. If, due to unusual natural events (floods, sea storms, etc.),
the device has been affected by water and mud, it must be re-
placed.
LOAD LIMITERS
To increase protection in case of an accident, the front seat belt
reels are equipped with a device which modulates the force act-
ing on the chest and shoulders during the belt restraining action
in the event of a frontal impact.
The pretensioner can be used only once. Once it
has activated contact Alfa Romeo Authorized Ser-
vices to have it replaced. See the label inside the
glove box to check the expiration date of the device: go
to Alfa Romeo Authorized Services when it is time to re-
place it.
Operations which lead to impacts, vibrations or lo-
calised heating (over 100°C for a maximum of six
hours) in the area around the pretensioners may
damage or deploy them. These devices are not affected
by vibrations caused by uneven road surfaces or low ob-
stacles such as kerbs, etc. Contact Alfa Romeo Authorized
Services to intervene.
131-150 Alfa Giulietta EN 4ed 27-04-2010 11:15 Pagina 135

152
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
It is advisable not to demand maximum perfor-
mance from your car (e.g. excessive acceleration,
long distances at top rpm, excessively intense brak-
ing, etc.) when it is first used.
Remember that the brake servo and electro-
mechanical power steering are not operational un-
til the engine has been started, therefore much
more effort than usual is required on the brake pedal and
steering wheel.
Never jump start the engine by pushing, towing or
driving downhill. These manoeuvres may damage
the catalytic converter.
When the engine is switched off never leave the
key in the MAR position to prevent useless cur-
rent absorption from draining the battery.
HOW TO WARM UP THE ENGINE
AFTER IT HAS JUST STARTED
Proceed as follows:
❍drive off slowly, letting the engine turn at medium speed. Do
not accelerate abruptly;
❍do not demand maximum performance for the first few kilo-
metres. Wait until the engine coolant temperature indicator
starts moving.
STOPPING THE ENGINE
Turn the ignition key to STOP while the engine is idling.
IMPORTANT After a taxing drive, before turning the engine off you
should allow it to idle to allow the temperature in the engine com-
partment to fall.
A quick burst on the accelerator before turning off
the engine serves absolutely no practical purpose;
it wastes fuel and is especially damaging to tur-
bocharged engines.
151-160 Alfa Giulietta EN 3ed 13-04-2010 11:46 Pagina 152

154
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
USING THE GEARBOX
To engage the gears, press the clutch pedal down fully and shift
the gear lever into the required position (a diagram is shown
on the knob fig. 111).
To engage 6th gear, operate the lever by pressing it towards the
right in order to avoid engaging 4th gear by mistake. Similar ac-
tion to pass from sixth to fifth gear.
To engage reverse gear (R) from the neutral position, lift up ring
A-fig. 111 and simultaneously move the lever to the left and then
forwards.
IMPORTANT Reverse may be engaged only when the car is at a
standstill.
fig. 111A0K0082m
Press the clutch pedal fully to change gears cor-
rectly. Therefore, the floor area under the pedals
must be clear: ensure that any rubber mats are flat
and do not interfere with the pedals.
Do not drive with your hand resting on the gear
lever, because this pressure, even if light, can wear
out the inner components of the gearbox over
time.
151-160 Alfa Giulietta EN 3ed 13-04-2010 11:46 Pagina 154

157
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
TOWING TRAILERS
IMPORTANT
The car must be provided with a type-approved tow hook and ad-
equate electric system to tow caravans or trailers. Installation must
be carried out by a specialist.
Install any specific and/or additional rear-view mirrors in accor-
dance with the highway code of the country in which you are trav-
elling.
Remember that when towing a trailer, steep hills are harder to climb,
braking distances increase and overtaking takes longer depending
on the overall weight.
Engage a low gear when driving downhill, rather than constantly
using the brake.
The weight of the trailer reduces the load capacity of the car by the
same amount. Consi
der the weight at full load, including acces-
sories and luggage, to make sure you do not exceed the maximum
towable weight (shown in the registration document).
Respect the speed limits specific to each country for vehicles tow-
ing trailers. In any event do not exceed 100 km/h.
INSTALLING A TOW HOOK
Contact Alfa Romeo Authorized Services to install a tow hook.
The ABS with which the car is equipped will not con-
trol the braking system of the trailer. Take extra
care when travelling on slippery roads.
Never modify the braking system of the car to con-
trol the trailer brake. The trailer braking system
must be fully independent from the hydraulic sys-
tem of the car.
151-160 Alfa Giulietta EN 3ed 13-04-2010 11:46 Pagina 157

162
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
The space-saver spare wheel is vehicle-specific:
do not use it on vehicles of other model and do not
use space-saver spare wheels from other models
on your car. The space-saver spare wheel must only be
used in an emergency. Never use it longer than strictly
necessary and never exceed 80 km/h. On the space-saver
spare wheel there is a label, summarizing the main warn-
ings about the space-saver spare wheel usage restrictions.
Never remove or cover the label. Never apply any hub
cap to the space-saver spare wheel.
CHANGING A TYRE
GENERAL INSTRUCTIONS
The car is equipped with an “Automatic Fix&Go Kit“: see “Auto-
matic Fix&Go Kit” for how to use this device.
Alternatively to the “Automatic Fix&Go Kit” the car may be
equipped with a space-saver spare wheel: see the instructions on
the following pages for changing the tyre.
Use your hazard lights, warning triangle, etc. to
show that your car is stationary in compliance with
regulations. Passengers should get out of the car,
particularly if it is heavily loaded, and wait for the wheel
to be changed away from the traffic. In the event of a
wheel change on a slope or on unsurfaced roads, chock
the wheels.
BUMP STARTING
Never start the engine by pushing, towing or driving downhill.
161-198 Alfa Giulietta EN 4ed 5-05-2010 9:04 Pagina 162

168
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
REFITTING THE WHEEL
Following the procedure previously described, raise the car and
remove the space-saver spare wheel.
Proceed as follows:
❍make sure the contact surfaces between standard wheel and
hub are clean so that the fastening bolts will not come loose;
❍for versions with steel rims: fixed the wheel hub onto the rim;
❍fit the hub cap by aligning the crescent hole with the bolt you
have fitted, then insert the other 4 bolts;
❍tighten the retaining bolts using wrench A-fig. 115;
❍lower the car and remove the jack;
❍use wrench A-fig. 115 to fully tighten the bolts, following the
sequence shown in fig. 118;
When you have finished:
❍stow the space-saver spare wheel in the compartment provid-
ed in the boot;
❍insert the jack and the other tools in the container;
❍arrange the container and tools on the space-saver spare wheel;
❍reposition the boot mat correctly.
Subwoofer and “Automatic Fix&Go Kit”
Locating the Automatic Fix&Go Kit:
❍open the boot, pull tab A-fig. 113 and lift up the mat;
❍take the “Automatic Fix&Go Kit” located on the left side of the
boot (fig. 121);
❍inflate the wheel (see “Automatic Fix&Go Kit”).
IMPORTANT If you need to remove the subwoofer follow the indi-
cations shown on the adhesive label fig. 121 over the subwoofer
itself to reposition it correctly.
fig. 121A0K0178m
161-198 Alfa Giulietta EN 4ed 5-05-2010 9:04 Pagina 168