Page 100 of 345
92
DIRECTIONAL LIGHTING
When the dipped or main beam head-
lamps are on, this function enables the
light beams to provide improved lighting
of the side of the road when cornering.
The use of this function, from approxi-
mately 12 mph (20 km/h) and associ-
ated with the xenon headlamps only,
considerably improves the quality of
your lighting when cornering.
with directional lighting
without directional lighting
Programming
Operating fault
The function is activated or
deactivated via the multi-
f u n c t i o n s c r e e n c o n fi g u r a -
tion menu.
If a fault occurs, this warn-
i n g l a m p fl a s h e s i n t h e i n s t r u -
ment panel, accompanied by
a message in the multifunction
screen.
Consult a PEUGEOT dealer.
AUTOMATIC ADJUSTMENT OF THE XENON HEADLAMPS
If a malfunction occurs, do not
touch the xenon bulbs. Con-
sult a PEUGEOT dealer.
In order to avoid causing a nuisance to
other road users, this system corrects
the height of the xenon headlamps beam
automatically and when stationary, in re-
lation to the load in the vehicle.
If a malfunction occurs, this warn-
ing lamp is displayed on the in-
strument panel, accompanied by
an audible signal and a message
on the multifunction screen.
The system then places your headlamps
in the lowest position.
When stationary or moving
at very low speed or when
reverse gear is engaged, the
function is inactive.
The status of the function remains
in the memory when the ignition is
switched off.
Page 128 of 345
FITTINGS
111
The hooks permit the securing of shop-
ping bags.
Hooks
To connect a 12 V accessory (max
power: 120 W), remove the cap and
connect an appropriate adaptor.
Turn the key to the ignition position.
12 V accessory socket
Raise the concertina board to gain
access to the storage box.
D e p e n d i n g o n t h e c o n fi g u r a t i o n , t h i s
has areas for storing:
- a box of spare bulbs,
- a fi r s t a i d k i t ,
- a tyre repair kit,
- two warning triangles,
- ... Storage box (5 seat version)
Page 134 of 345
FITTINGS
111
The hooks permit the securing of shop-
ping bags.
Hooks
To connect a 12 V accessory (max
power: 120 W), remove the cap and
connect an appropriate adaptor.
Turn the key to the ignition position.
12 V accessory socket
Raise the concertina board to gain
access to the storage box.
D e p e n d i n g o n t h e c o n fi g u r a t i o n , t h i s
has areas for storing:
- a box of spare bulbs,
- a fi r s t a i d k i t ,
- a tyre repair kit,
- two warning triangles,
- ... Storage box (5 seat version)
Page 218 of 345
PRACTICAL INFORMATION
184
Risk of electrocution
Xenon bulbs (D1S-35W) must
be replaced by a PEUGEOT
dealer.
CHANGING A BULB
Model with halogen headlamps
1. Direction indicators
(HP24 amber-24W).
2. Dipped beam headlamps
(H7-55W).
3. Main beam headlamps (H7-55W).
4. Daytime running lamps
(HP24-24W).
5. Foglamps (PS24-24W).
6. Sidelamps (W5-5W).
1. Direction indicators
(HP24 amber-24W).
2. Dipped/main beam directional
headlamps (D1S-35W).
3. Daytime running lamps/
sidelamps (P21/5W).
4. Foglamps (PS24-24W).
Model with xenon and dir
ectional
headlamps T h e h e a d l a m p s a r e fi t t e d w i t h
polycarbonate glass with a
protective coating:
do not clean them using a dry
or abrasive cloth, nor with a
detergent or solvent product,
use a sponge and soapy water,
when using a high pressure
washer on persistent marks, do
not direct at the lamps or their
outlines for too long, so as not to
damage their protective coating
and seals.
Front lamps
Do not touch the bulb directly with
y o u r fi n g e r s , u s e l i n t - f r e e c l o t h s .
Changing a bulb should only be
done after the headlamp has been
switched off for a few minutes (risk of
serious burns).
It is imperative to use only anti-ultra-
violet (UV) type bulbs in order not to
damage the headlamp.
Always replace a failed bulb with a
new bulb with the same type and
s p e c i fi c a t i o n .
Page 219 of 345
PRACTICAL INFORMATION
Changing main beam headlamp and
sidelamp bulbs Changing dipped beam headlamp bulbs
(models with halogen headlamps)
Remove the protective plastic cover
by pulling on the tab.
Disconnect the bulb connector.
Extract the bulb by pulling and
change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n r e -
verse order.
Remove the protective plastic cover
by pulling on the tab.
Disconnect the bulb connector.
Remove the bulb by pulling and
change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n r e -
verse order.
Changing direction indicator and
daytime running lamp bulbs (models
with halogen headlamps)
Consult a PEUGEOT dealer.
Page 220 of 345
PRACTICAL INFORMATION
186
Changing sidelamp and daytime
running lamp bulbs (models with
xenon headlamps)
Remove the protective plastic cover
by pulling on the tab.
Disconnect the bulb connector.
Remove the bulb by pulling and
change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order. Changing foglamp bulbs
You can also contact a
PEUGEOT dealer to have
these bulbs changed. Consult a PEUGEOT dealer.
Insert a screwdriver towards the
centre of the repeater between the
repeater and the base of the mirror.
Tilt the screwdriver to extract the re-
peater and remove it.
Disconnect the repeater connector.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n r e -
verse order.
Contact a PEUGEOT dealer to obtain
replacement repeaters.
Changing integrated direction
indicator side repeaters
Changing direction
indicator bulbs
Changing dipped beam
and main beam headlamp
bulbs (models with xenon
headlamps)
D1S xenon bulbs must be changed
by a PEUGEOT dealer as there is a
risk of electrocution.
It is recommended that the D1S bulbs
are changed at the same time when
one of them fails.
Consult a PEUGEOT dealer.
Page 221 of 345
PRACTICAL INFORMATION
187
Rear lamps
1. Direction indicators
(PY21W-21W).
2. Brake lamps
(P21W-21W).
3. Sidelamps
(
LEDs
).
4. Reversing lamp
(P21W).
5. Foglamp
(P21W). Changing brake lamp and direction
indicator bulbs
Press the four tabs and remove the
bulb holder.
R e m o v e t h e t w o l a m p u n i t fi x i n g
nuts.
Pull the lamp rearwards (a positioning
lug retains the lamp).
Disconnect the lamp connector.
Turn the bulb a quarter of a turn and
change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n r e -
verse order.
Page 222 of 345
PRACTICAL INFORMATION
188
Changing the third brake lamp bulb
Changing foglamp or reversing
lamp bulbs
Reach under the bumper.
Turn the bulb a quarter of a turn and
change it.
Open the boot and remove the upper
seal.
Unscrew the two nuts.
Press the threaded pins while sup-
porting the lamp from the outside.
Disconnect the connector and re-
move the screenwash pipe.
Press the pairs of clips A then B
then C to detach and gain access to
the bulb holder.
Changing sidelamps (LEDs)
For the replacement of this type of LED
lamp, contact a PEUGEOT dealer.
Insert a thin screwdriver into one of
the outer holes of the lens.
Push it outwards to unclip.
Remove the lens.
Pull the bulb out and change it.
Changing the number plate lamp
bulbs (W5-5W)
