2010.5 Citroen DS4 boot

 To connect a 12 V accessory (max power: 120 W), remove the cap and connect an appropriate adaptor.  Turn the key to the ignition on position.
12 V accessory socket
This is a removable lamp, fitted in the boot wall, which can be used to light the boot or as a torch.
For the boot lamp function, refer to the "Visibility - § Boot lamp" section.
Torch
Operation
This torch operates with NiMH type rechargeable bateries.
It has an battery life of approximately 45 minutes and charges while you are driving.
Obser ve the polarities when fitting the rechargeable batteries. Never replace the rechargeable batteries with normal batteries.

155Fittings
Use
 Extract the torch from its location pulling it upwards.
 Press the switch, located on the back, to switch the torch on or off.  Unfold the suppor t, located on the back, to set down and raise the torch; for example, when changing a wheel.
Storing
 Put the torch back in place in its location star ting with the lower par t.
If you have forgotten to switch off the torch, this switches it off automatically.
Storage box
 Raise the boot carpet for access to the storage box. This has areas for the storage a box of spare bulbs, a first aid kit, two warning triangles... It also contains the vehicle tools, the temporary puncture repair kit...
It the torch is not engaged correctly, it may not charge and may not come on when the boot is opened.

 To connect a 12 V accessory (max power: 120 W), remove the cap and connect an appropriate adaptor.  Turn the key to the ignition on position.
12 V accessory socket
This is a removable lamp, fitted in the boot wall, which can be used to light the boot or as a torch.
For the boot lamp function, refer to the "Visibility - § Boot lamp" section.
Torch
Operation
This torch operates with NiMH type rechargeable bateries.
It has an battery life of approximately 45 minutes and charges while you are driving.
Obser ve the polarities when fitting the rechargeable batteries. Never replace the rechargeable batteries with normal batteries.

155Fittings
Use
 Extract the torch from its location pulling it upwards.
 Press the switch, located on the back, to switch the torch on or off.  Unfold the suppor t, located on the back, to set down and raise the torch; for example, when changing a wheel.
Storing
 Put the torch back in place in its location star ting with the lower par t.
If you have forgotten to switch off the torch, this switches it off automatically.
Storage box
 Raise the boot carpet for access to the storage box. This has areas for the storage a box of spare bulbs, a first aid kit, two warning triangles... It also contains the vehicle tools, the temporary puncture repair kit...
It the torch is not engaged correctly, it may not charge and may not come on when the boot is opened.

In the event of the electric parking brake malfunctioning or the battery running flat, an emergency manual device can release the parking brake.  Immobilise the vehicle (or keep it stationary, if the brake pedal is pressed), with the engine running, by engaging first gear (manual gearbox) or position M or R(6 -speed electronic gearbox system).
Emergency release
 Switch off the engine but leave the ignition on. If it is not possible to immobilise the vehicle, do not operate the control and contact a CITROËN dealer or a qualified workshop without delay.  Fetch the two vehicle blocks B and the release device C , located under the boot carpet.
 Immobilise the vehicle by placing the blocks in front or behind the two front wheels, opposite to the direction of the slope.  Remove the storage box under the boot carpet for access to the emergency release device.

Driving
 Pierce the protective cover D on the tube Ewith the release device.  Place the release device in the tube.  Turn the release device clockwise . For safety reasons , it is essential to continue turning the device until it reaches its stop. The parking brake is released.  Remove the release device and store it with the blocks in the toolbox under the boot carpet.
For safety reasons, after this operation it is essential to contact a CITROËN dealer or a qualified workshop without delay to replace the protective cover. Following an emergency unlocking, immobilisation of the vehicle is no longer assured once the manual emergency release has been deployed
and the manual control does not allow the re-application of your parking brake.
Take no action, either on the control lever A , or stopping star ting the engine while the release device is engaged. Take care not to allow moisture or dust
in the proximity of the protective cover.
- The operation of the parking brake reinitialises when the ignition is switched off then on again. If the reinitialisation of the parking brake proves impossible, contact a CITROËN dealer or a qualified workshop. - The subsequent time required for application may be longer than during normal operation.

Temporary puncture repair kit
and a sealant car tridge which permits temporar y repair of a tyre so that you can pairdrive to the nearest garage. It is designed to repair most punctures which
could affect the tyre, located on the tyre tread or shoulder.
Access to the kit
The speed limit sticker I must be affixed to the vehicle's steering wheel to remind you that a wheel is in temporary use. Do not exceed a speed of 50 mph (80 km/h) when driving with a tyre repaired using this type of kit.
Description of the kit
A. "Sealant" or "Air" position selector. B. On "I" /off "O" switch. C. Deflation button. D. Pressure gauge (in bar or p.s.i.). E. Compar tment housing: - a cable with adaptor for 12 V socket, - various inflation adaptors for accessories, such as balls, bicycle tyres...
F. Sealant car tridge. G. White pipe with cap for repair. H. Black pipe for inflation. I. Speed limit sticker.
This kit is installed in the storage box, under the boot floor.

243Practical information
Changing a wheel
Procedure for changing a faulty wheel for the spare w heel using the tools provided with the vehicle.
The tools are installed in the boot under the floor. To gain access to them:  open the boot,  raise the floor,  secure it by hooking its cord on the hook on the rear shelf suppor t,  with a standard size spare wheel, unclip and remove the box in the middle of the wheel containing the tools,
or  with a "space-saver" spare wheel; lift the wheel at the rear towards you for access to the storage box containing the tools.
Access to the tools
List of tools
All of these tools are specific to your vehicle. Do not use them for other purposes.
Wheel with trim
When removing the wheel , detach the trim first using the wheelbrace 1 pulling at the valve passage hole. When refitting the wheel , refit the trim star ting by placing its notch facing the valve and press around its edge with the palm of your hand.
3. "Bolt cover" tool.
For removing the bolt protectors (covers) on alloy wheels. 4. Socket for the security bolts (located in the glove box).
For adapting the wheelbrace to the special "security" bolts.
1. Wheelbrace.
For removing the wheel trim and the wheel fixing bolts. 2. Jack with integral handle. For raising the vehicle.