2010.5 Citroen C3 PICASSO bulb
[x] Cancel search: bulbPage 19 of 222
!
22
MONITORING
Warning lamps
When the engine is running or the vehicle is being driven, the switching on of one of the fol-lowing warning lamps indicates a fault which
requires action on the part of the driver.
Any fault resulting in the switching on of a warning lamp must be investigated
further by reading the associated message on the multifunction screen.
If you encounter any problems, do not hesitate to contact a CITROËN dealer.
Warning lamp is on Cause Action/Observations
STOP fi x e d , a s s o c i a t e d
with another
warning lamp,
accompanied by
an audible signal and a message on the screen.
It is associated with the braking system, the power steering,
the engine oil pressure or the
engine coolant temperature. Stop as soon as it is safe to do so.
Park, switch off the ignition and call a CITROËN
dealer.
Service temporarily,
accompanied
by an audible signal and a
message on the multifunction screen. A minor fault has occurred
f o r w h i c h t h e r e i s n o s p e c i fi c
warning lamp. Identify the fault by reading the message shown
on the screen, such as, for example:
- engine oil level,
- screenwash level,
- remote control battery,
- state of the bulbs,
- s a t u r a t i o n o f t h e p a r t i c l e e m i s s i o n fi l t e r ( D i e
s e l ) .
For any other faults, contact a CITROËN dealer.
fi x e d , a c c o m p a n i e d
by an audible signal
and a message on the multifunction screen. A major fault has occurred
f o r w h i c h t h e r e i s n o s p e c i fi c
warning lamp. Identify the fault by reading the message shown
on the screen and contact a CITROËN dealer.
Braking fi x e d , a s s o c i a t e d
with the STOP warning lamp. T h e b r a k i n g s y s t e m fl u i d
level is too low. You must stop as soon as it is safe to do so.
T o p u p w i t h b r a k e fl u i d r e c o m m e n d e d b y C I T R O Ë N .
If the problem persists, have the system checked
by a CITROËN dealer.
+ fi x e d , a s s o c i a t e d
with the STOP and
ABS warning lamp. The electronic brake force
distribution (EBFD) system
has a fault.
You must stop as soon as it is safe to do so.
Have it checked by a CITROËN dealer.
Page 142 of 222
!
!
1 2 7
PRACTICAL INFORMATION
CHANGING A BULB
Procedure for replacing a faulty bulb
with a new bulb.
1. Direction indicators
(H21W amber).
2. Dipped
beam
headlamps
(H7-55W).
3. Main beam headlamps (H1-55W).
4. Sidelamps
(W5W).
5. Foglamps
(PSX24W).
T h e h e a d l a m p s a r e fi t t e d w i t h p o l y -
carbonate glass with a protective
coating:
do not clean them using a dry
or abrasive cloth, nor with a
detergent or solvent product,
use a sponge and soapy water,
when using a high pressure
washer on persistent marks, do
not direct at the lamps or their
outlines for too long, so as not
to damage their protective coat-
ing and seals. Front lamps
Do not touch the bulb directly
w i t h y o u r fi n g e r s , u s e l i n t - f r e e
cloths.
Changing a bulb should only be
done after the headlamp has been
switched off for a few minutes (risk
o f s e r i o u s b u r n s ) .
It is imperative to use only anti-
u l t r a v i o l e t ( U V ) t y p e b u l b s i n o r d e r
not to damage the headlamp.
Always replace a failed bulb with a
new bulb with the same type and
s p e c i fi c a t i o n .
Page 143 of 222
i
!
i
128
PRACTICAL INFORMATION
Changing direction indicator bulbs
Amber coloured bulbs, such as
the direction indicators, must be
replaced with bulbs of identical
s p e c i fi c a t i o n s a n d c o l o u r .
Remove the plastic protective cover.
Pull the bulb-holder and replace the
bulb.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order.
W h e n r e fi t t i n g , c l o s e t h e p l a s t i c
cover carefully to ensure the sealing
of the headlamp. If either of the direction indicator
w a r n i n g l a m p s i s fl a s h i n g q u i c k l y ,
one of the bulbs is faulty.
Changing main beam headlamp
bulbs
Remove the protective plastic cover
by pulling on the tab.
Disconnect the bulb connector.
Move the springs to release the bulb.
Remove the bulb and change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order.
Changing sidelamp bulbs
Remove the protective plastic cover
by pulling on the tab.
Pull the bulb-holder.
Remove the bulb and replace it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order.
Changing dipped headlamp bulbs
Remove the protective plastic cover
by pulling on the tab.
T u r n t h e b u l b - h o l d e r b y a q u a r t e r
turn.
Remove the bulb and change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order.
Page 144 of 222
i
i
129
PRACTICAL INFORMATION
Changing integrated direction
indicator side repeaters
Contact a CITROËN dealer to obtain
replacement repeaters.
Insert a screwdriver on the edge of
the repeater.
T i l t t h e s c r e w d r i v e r t o e x t r a c t t h e
repeater and remove it.
Disconnect the repeater connector.
When removing:
- be careful not to damage the paintwork of your vehicle with the screwdriver,
- do not allow the wire and the con- nector to slide inside the wing.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n r e -
verse order.
I f y o u e x p e r i e n c e a n y d i f fi c u l t y
in replacing bulbs, contact your
CITROËN dealer. Changing front foglamp bulbs
To obtain them, contact your CITROËN
dealer.
Remove the grille located under the
foglamp.
Disconnect the bulb holder connector,
by pressing on the tab.
Remove the bulb-holber by pressing on
t h e 2 c l i p s ( a t t h e t o p a n d t h e b o t t o m ) .
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order.
I f y o u e x p e r i e n c e a n y d i f fi c u l t y
in replacing bulbs, contact your
CITROËN dealer.
Page 145 of 222
PRACTICAL INFORMATION
Rear lamps
1. Brake
lamps/sidelamps
(12VP21/5W).
2. Foglamp, right-hand side
(PR21W)
Reversing lamp, left-hand side
(P21W).
3. Direction indicators (P21W) Changing brake lamp/sidelamp and
direction indicator bulbs
u n s c r e w t h e t w o l a m p fi x i n g b o l t s ,
e x t r a c t t h e l i g h t c a r e f u l l y p u l l i n g i t
straight out,
t u r n t h e b u l b h o l d e r a q u a r t e r t u r n ,
remove the faulty bulb and replace it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order.
Page 146 of 222
131
PRACTICAL INFORMATION
Changing foglamp/reversing lamp
bulbs
open the boot,
press on the tabs using 2 screwdrivers,
disconnect the lamp connector,
t u r n t h e b u l b h o l d e r b y a q u a r t e r t u r n ,
remove the bulb and replace it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n r e -
verse order. Changing the third brake lamp bulbs
(4 W5W bulbs)
open the boot,
remove the two plugs located on the
boot inner panel,
press on the body of the lamp with
2 screwdrivers to remove it from its
housing,
turn the corresponding bulb-holder
a q u a r t e r t u r n ,
pull the bulb and replace it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n r e -
verse order. Changing the number plate lamp
bulbs (W5W)
insert a thin screwdriver into one of
t h e l e n s ’ e x t e r i o r h o l e s ,
push it outwards to unclip,
remove the lens,
pull the bulb and replace it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n r e -
verse order.
Page 147 of 222
132
PRACTICAL INFORMATION
Interior lighting
Interior lamps (1/W5W)
Detach the cover of the interior lamp 1 with
a thin screwdriver, close to the button, to
access the faulty bulb.
Map reading lamps (2/W5W)
Detach the cover of the interior lamp. To
access the faulty bulb, detach the parti-
tion for the reading lamp 2 concerned,
as necessary. Footwell lamps (W5W)
Unclip the cover using a thin screw-
driver to access the faulty bulb.
Boot lamps (W5W)
Detach the unit by pushing it rear-
wards. Torch (Krypton 3.6V)
Open the tab.
P u s h w i t h a fl a t s c r e w d r i v e r i n t h e
hole under the tab and recover the
bulb unit.
Open the bulb unit fully to change
the bulb.
Door mirror lamps (W5W)
Unclip the cover using a thin screw-
driver to access the faulty bulb.
Page 162 of 222
i!i
i
1 4 6
PRACTICAL INFORMATION
"Multimedia":
semi-integral navigation systems,
Bluetooth ®
hands free kit, audio sys-
t e m s , s p e a k e r s , D V D p l a y e r , U S B b o x ,
portable navigation systems, mapping
update CD, Hi-Fi module, speed camera
warning, Wi-Fi on board...
Depending on the legislation in
force in the country, it may be com-
pulsory to have a high visibility
safety vest, warning triangle and
spare bulbs and fuses available in
the vehicle. T h e fi t t i n g o f e l e c t r i c a l e q u i p m e n t
or accessories which are not rec-
ommended by CITROËN may
r e s u l t i n a f a i l u r e o f y o u r v e h i c l e ' s
e l e c t r o n i c s y s t e m a n d e x c e s s i v e
electrical consumption.
Please note this precaution. You
are advised to contact a CITROËN
representative to be shown the
r a n g e o f r e c o m m e n d e d e q u i p m e n t
and accessories.
Installation of radio
communication transmitters
Before installing any after-market ra-
dio communication transmitter, you
can contact a CITROËN dealer for
t h e s p e c i fi c a t i o n o f t r a n s m i t t e r s w h i c h
c a n b e fi t t e d ( f r e q u e n c y , m a x i m u m
p o w e r , a e r i a l p o s i t i o n , s p e c i fi c i n s t a l -
l a t i o n r e q u i r e m e n t s ) , i n l i n e w i t h t h e
Vehicle Electromagnetic Compatibility
D i r e c t i v e ( 2 0 0 4 / 1 0 4 / E C ) . By visiting a CITROËN dealer, you
can also obtain cleaning and main-
tenance products (interior and
e x t e r i o r ) , i n c l u d i n g t h e e c o l o g i c a l
products in the "TECHNATURE"
range, products for topping up
( s c r e e n w a s h fl u i d . . . ) , t o u c h - u p
p e n s a n d p a i n t a e r o s o l s t h e e x a c t
colour of your vehicle, recharges
(cartridge for the temporary punc-
t u r e r e p a i r k i t . . . ) .