Page 116 of 164
!
i
Checks
114
Bonnet Protects the components in the front compartment and provides access for checking levels, recharging the 12 V ancillaries battery, changing fuses, ...
)Push the exterior safety catch Bto the left and raise the bonnet.
)
Open the bonnet fully and on the right,unclip the stay Cfrom its holder. )
Fit the stay Cin one of the two notchesto hold the bonnet open.
)Open the front right door. )Pull the interior release lever A
, located at
the bottom of the door aper ture.
Opening
Closing
)Take the stay out of the support notch. )Clip the stay in its housing. )Lower the bonnet and release it at the end of its travel. )Pull on the bonnet to check that it is fully latched.
Do not press down on the middle of the bonnet if it does not fully close, as there is a risk of deforming it. Open the bonnet fully and close it again.
The location of the interior release lever prevents opening of the bonnet while the front right door is closed.
Page 117 of 164
9
!
Checks
115
Screenwash fluid reservoir. 2.Heater fluid reservoir.3.Brake fluid reservoir.4.
Ancillaries battery.
5. Fusebox.
Front compartment
To avoid damaging electricalcomponents, the use of a high pressure jet washer in the front compartment is strictly prohibited.
Page 120 of 164
!
i
Checks
118
The coolant level should be between
the MIN "L" and MA X "F" marks.
Coolant level
Avoid prolonged contact of used fluids with the skin.
Most of these fluids are harmful tohealth and some are very corrosive.
Do not discard used fluids into sewers or onto the ground.
Take used fluids to a CITROËN dealer or a qualified workshop (France) or toan authorised waste disposal site.
Used products
Rear compartment
Changing the coolant
The coolant does not have to be changed.
Coolant specifi cation
The coolant must conform to the
manufacturer's recommendations.
As the coolin
g system is pressurised, wait at least one hour after switching off the motor and/
or the end of the charge cycle before carryingout any work.
To a v o i d a ny risk of scalding, unscrew the cap by two turns to allow the pressure to drop.
When the pressure has dropped, remove the cap and top up the level.
Ancillaries battery
electrolyte level
Remove the battery protective cover to check
this level
(see § "ancillaries battery").The electrolyte level should be between theMIN "LOWER LEVEL" and MA X "UPPER LEVEL".
If necessary, top up using distilled water byremoving the individual battery caps.
Check the electrolyte level at least onceper month.
Page 122 of 164
Technical data
120
MODEL:MOTOR AND MAIN BATTERY
Model type code:1 N ZK Z Z
Electric motorY4F1
Technology Synchronous with neodymium permanent magnets
Max. power: EU standard
(kW)
49
Max. power speed
(rpm)
2 500 to 8 000
Max. torque: EU standard (Nm)
18 0
Max. torque speed (rpm)
0 to 2 500
Main batteryLithium-Ion
Ener
gy capacity (kWh)
16
Normal charge
Volt age (V)
220
Charging time (*)(**):
- 16 A
- 13 A
- 1
0 A
6 hours
7 hours
9 hours
Fast char
ge
Volt age (V) 330
Charging time (80 % charge) ** 30 minutes
*
Dependin
g on the power supply in the country.
**
Time measured for ambient temperatures between 20 and 25 °C. Range varies according to the exterior climatic conditions, the driver's style o
f driving, the use of electrical equipment, the frequency of normal or fast charges and ageing of the main battery.
Page 123 of 164
10
!
Technical data
121
WEIGHTS (in kg)
Electric motorY4 F1
Main batteryLithium-Ion
Model type code:1 N ZK Z Z
Unladen weight
1 120
Kerb weight 1 195
Gross vehicle weight (GV W) 1 450
Gross train wei
ght (GTW)1 450
Maximum load on the roo
f (including the roof bars)43
Your vehicle cannot be fitted with a towbar. It cannot tow a trailer.
Page 128 of 164
126
EMERGENCY OR ASSISTANCE CALL
CITROËN LOCALISED EMERGENCY CALL
In an emergency, press this button for more than2 seconds. Flashing of the green LED and a voice message confi rm that the call has been made tothe CITROËN Emergency team * .g
Pressing this button again immediately cancels the request. The green LED goes off.
A press
(at any time) of more than 8 seconds on this button, cancels
the request.
CITROËN LOCALISED ASSISTANCE CALL
When the ignition is switched on, thegreen LED comes on for 3 seconds
indicating that the system is operating correctly.
If the oran
ge LED fl ashes: there is
a system fault.
If the oran
ge LED is on continuously:the backup battery must be replaced.
In either case, contact a CITRO
ËN. Pressin
g this button again immediately cancels the request.
The cancellation is confi rmed b
y a voice message.
Press this button for more than 2 seconds to request
assistance if the vehicle breaks down.
A voice message confi rms that the call has been made *
.
OPERATION OF THE SYSTEM
The green LED remains on (without fl ashing) when communication is established. It goes off at the end of communication.
This call is dealt with b
y the CITROËN Emergency team which receiveslocating information from the vehicle and can send a detailed alert to theappropriate emergency services. In countries in which the team is not
operational, or when the locating service has been expressly declined,
the call is dealt with directl
y by the emergency services (11 2) without the
vehicle location.
If an impact is detected b
y the airbag ECU, and independentlyof the deployment of any airbags, an emergency call is made
automatically.
*
These services are subject to conditions and availability.
Consult a CITROËN dealer.If you purchased your vehicle outside the CITROËN dealer network,
we invite
you to have a dealer check the confi guration of these servicesand, if desired, modifi ed to suit your wishes. In a multi-lingual country, confi guration is possible in the offi cial national language of your choice.
For technical reasons, particularl
y to improve the quality of Telematic services services to customers, the manufacturer reserves the right tocarry out updates to the vehicle's on-board telematic system.
If you benefi t from the CITROËN eTouch offer, you also have available additional services in your MyCITROEN personal space, via the CITROËN y,y
Internet website www.citroen.co.uk.
Page 129 of 164
127
The system is coded in such a way that it will only
operate in your vehicle. If it is to be installed in another vehicle, contact your CITROËN dealer for confi guration py
of the system.
AUDIO SYSTEM/BLUETOOTH
01 First steps
For safety reasons, the driver must only carry out
operations which require prolonged attention while
the vehicle is stationary.
When the motor is switched off and to
prevent
discharging of the battery, the audio system may switch off after a few minutes.
CONTENTS
02 Radio
03 Audio
04 Using the telephone
05 Audio settings
06 Configuration
07 Screen menu map
Frequently asked questions p.
p.
p.
p.
p.
p.
p.
p. 128
129
132
138
144
145
146
147
After a battery disconnection, a code has to be enteredfor operation of the radio.
A maximum of fi ve attempts are possible. For the last
two attempts, a 15 minutes wait is imposed between each attempt.
R
efer to the end of this document to fi nd the label indicating this code:
Page 151 of 164
149
FREQUENTLY ASKED QUESTIONS
QUESTIONANSWER SOLUTION
The CD is ejected
automatically or is not played by the player. The CD is inserted upside down, is unpla
yable, does not contain any audio data or contains an audio format which the player cannot play.
The
CD is protected by an anti-pirating protection system which is not recognised by the audio equipment.
- Check that the CD is inserted in the pla
yer the
right way up.
-
Check the condition of the CD: the CD cannot
be played if it is too damaged.
-
Check the content in the case of a recordedCD: consult the advice in the "Audio" section.
- The audio equipment's
CD player does not
play DVDs.
- Due to their qualit
y level, certain writeableCDs will not be played by the audio system.
The
CD player sound ispoor.The CD used is scratched or of poor quality. Insert good quality CDs and store them in suitable conditions.
The audio settin
gs (bass, treble, ambience) are unsuitable. Set the treble or bass level to 0, without selectingan ambience.
The Bluetooth connectionis cut. The battery of the peripheral may not be suffi ciently charged. Recharge the battery of the peripheral device.
The messa
ge "USB
device error" is displayedon the screen.The U
SB memory stick is not recognised.
The memor
y stick may be corrupt. Re
format the memory stick.
A telephone connects
automatically,
disconnecting another
telephone.
Automatic connection overrides manual connection. Modify the telephone settings to remove automatic connection.
