2009 YAMAHA GRIZZLY 450 ignition

[x] Cancel search: ignition

Page 29 of 164

YAMAHA GRIZZLY 450 2009  Owners Manual 4-6
4
EBU18080Engine stop switch“/” 
Set this switch to“” before starting the engine.
The engine stop switch controls the ignition and
stops the engine when it is running. Use this switch
to s

Page 140 of 164

YAMAHA GRIZZLY 450 2009  Owners Manual 8-53
8
If a fuse is blown, replace it as follows.
1. Turn the key to “OFF” and turn off all electrical
circuits.
NOTICEECB00640To prevent accidental short-circuiting, turn off
the main switch when

Page 141 of 164

YAMAHA GRIZZLY 450 2009  Owners Manual 8-54
8 2. Remove the blown fuse, and then install a
new fuse of the specified amperage.
WARNING
EWB02171Always use a fuse of the specified rating, and
never use a substitute object in place of the
pro

Page 147 of 164

YAMAHA GRIZZLY 450 2009  Owners Manual 8-60
8
EBU25740Troubleshooting Although Yamaha ATVs receive a thorough in-
spection before shipment from the factory, trouble
may occur during operation. Any problem in the fu-
el, compression, or ign

Page 148 of 164

YAMAHA GRIZZLY 450 2009  Owners Manual 8-61
8
EBU25782Troubleshooting charts Starting problems or poor engine performance
Check the fuel level in
the fuel tank.1. Fuel
There is enough fuel.
There is no fuel.
Check the compression.
Supply f

Page 156 of 164

YAMAHA GRIZZLY 450 2009  Owners Manual 10-4
10
Minimum:
Front:
22.0 kPa (0.220 kgf/cm², 3.2 psi)
Rear:
22.0 kPa (0.220 kgf/cm², 3.2 psi)Front wheel:Wheel type:
Panel wheel
Rim size:
12 x 6.0ATRear wheel:Wheel type:
Panel wheel
Rim size:

Page 157 of 164

YAMAHA GRIZZLY 450 2009  Owners Manual 10-5
10
Reverse indicator light:
LED
Coolant temperature warning light:
LED
Park indicator light:
LED
On-Command four-wheel-drive/differential gear lock 
indicator:
LCD
High-range indicator light:
LED