D
E
C
0
F
G
AUTOSTART
Turn the key/keyless drive start control to position III and release it. The engine will start automatically.
cOld START
n
OT e
After cold starts, your engine will idle at a higher speed for a short time.
key & RemOTe cOnTROl
l ocks the doors, fuel filler door, and tailgate, and arms the alarm.
Unlocks the doors, fuel filler door, and tailgateA, and disarms the alarm.
Unlocks the tailgate. (Does not open the tailgate).
Approach lighting (30 secondsB) illuminates lights in door mirrors, cabin, footwells, license plates. Turn signals and parking lights illuminate.
“Panic” alarm. Press and hold to sound the alarm. Turn off alarm with
U nl Ock.
A. Automatic relock occurs if no door/tailgate is opened within 2 minutes after unlock.
B. The time can be set to 30, 60, or 90 seconds.
wIPeRS And RAIn SenSOR (OPTIOn)
CSingle wiper sweep
0Off
DIntermittent wipers. Turn (2) to adjust interval.
Enormal speed
FHigh speed
Gw indshield and headlight washer
HTailgate washer
3Tailgate wiper interval/normal
1Activate rain sensor. Positions d-F deactivate the rain sensor.
2Turn to adjust rain sensor sensitivity.
Symbol in display (rain sensor on).
FOldIng THe ReAR SeAT bAckReSTS
Third row of seats (seven-seat model)
Move the second row of seats as far forward as possible.
A. Pull the handle up.
B. Push the seat cushion as far rearward as possible and fold in the load eyelets.
C. Fold down the backrest.
Second row of seats
Move the seats as far rearward as possible (ap-plies to seven-seat models only).
A. Pull the loop.
B. Fold down the head restraint.
C. Pull the handle to unlock the backrest.
D. Fold down the backrest and press to lock it in the folded position.
The front passenger’s seat backrest can also be folded down. See point 6 of “Adjusting the front seat.”emeRgency bRAke ASSIST (ebA)
TURn SIgnAlS
A. Lane-change sequence, three flashes. B. Full turn sequence.
w
AR nIng ! Never adjust the steering wheel while driving. STeeRIng wHeel AdjUSTmenT
blIS – blInd SPOT InFORmATIOn
SySTem (OPTIOn)
EBA is designed to provide full brake effect immediately in the event of sudden, hard braking. When EBA is activated, the brake pedal will go down more than usual. Press and hold the brake pedal for as long as necessar y. There will be no braking effect if the pedal is released.
If the BLIS indicator lights illuminate occasion-ally even when there are no other vehicles in the blind area, this may be caused by light re-flected from a wet road surface, the vehicle’s own shadow against a large, light, smooth surface, or sunlight directly in the camera when the sun is low on the horizon.
In the event of a fault, blind spot syst. ser-vice required will be displayed.
