2009 VOLVO S60 lock

09 Maintenance and servicingReplacing bulbs
09200
(Halogen headlights)Removing the defective bulb:1. Switch off the headlights and turn the igni-
tion switch to position 0.
2. Remove the cover to access the bulb
assembly.
3. Turn the bulb counterclockwise and pull it
out.
4. Disconnect the wiring connector by press-
ing the lock tab out and pulling.
5. Twist the bulb counterclockwise, and pull
it out of the holder.Installing the new bulb:1. Connect the wiring connector to the new
bulb until it clicks into place.
2. Insert the bulb into the headlight housing
and turn it until it is securely in place.
3. Press the cover back into place.
Parking light
G022733
(Halogen headlights)Removing the defective bulb:1. Switch off the headlights and turn the igni-
tion switch to position 0.
2. Remove the plastic cover of the low beam
headlight assembly. Pull out the parking
light holder.
3. Pull the bulb out of the holder.Installing the new bulb:1. Press a new bulb into the holder
2. Reinsert the bulb and holder into place.
3. Reinstall the plastic cover.
Parking light
G027171
(Active Bi-Xenon headlights)Removing the defective bulb:1. Switch off the headlights and turn the igni-
tion switch to position 0.
2. Remove the plastic cover of the high beam
headlight assembly. Pull out the parking
light holder.
3. Pull the bulb out of the holder.Installing the new bulb:1. Press a new bulb into the holder
2. Reinsert the bulb and holder into place.
3. Reinstall the plastic cover.

09 Maintenance and servicing
Replacing bulbs
09``201 Turn signal, driver's side
G028438
Removing the defective bulb:1. Switch off the headlights and turn the igni-
tion switch to position 0.
2. Pull out the bulb holder by twisting it coun-
terclockwise.
3. Remove the bulb from the holder by press-
ing it in and turning it counterclockwise.Installing the new bulb:1. Insert the new bulb into the holder by
pressing it in and turning it clockwise.
2. Reinsert the bulb holder in the headlight
housing and twist it clockwise until it seats
properly.
Turn signal, passenger's side
G027283
1. Switch off the headlights and turn the igni-
tion switch to position 0.
2. Remove radiator pipe (1) from the box.
3. Remove filler pipe screw (2).
4. Pull the filler pipe (3) straight up.
5. Remove vent hose (4) from filler pipe.Installing the new bulb:1. Replace the bulb (same procedure as the
driver's side bulb).
2. Ensure that the seal between the washer
fluid reservoir and the filler pipe is correctly
positioned.3. Press the filler pipe (3) back into position.
4. Press the vent hose (4) into place on the
filler pipe.
5. Reinstall and tighten the filler pipe screw
(2).
6. Reinstall the radiator pipe to the box (1).
Side marker light
G028439
Side marker light1. Turn the lamp holder counterclockwise
and pull it out.
2. Pull out the defective bulb and insert a new
one.

09 Maintenance and servicingReplacing bulbs
09202
3. Reinsert the lamp holder and turn it clock-
wise until it seats properly.Front fog lights (option)
G027227
Front fog lightRemoving the defective bulb:1. Switch off the headlights and turn the igni-
tion switch to position 0.
2. Turn the bulb holder slightly counterclock-
wise.
3. Pull out and remove the bulb.Installing the new bulb:1. Insert the new bulb (it can only be inserted
in one position).2. Reinsert the bulb holder and turn it clock-
wise. "TOP" must be upward.

09 Maintenance and servicing
Replacing bulbs
09``203 Replacing bulbs in the taillight cluster
3501204m
G027277
Location of bulbs
Brake lightParking light (left side)Fog light (one side)Side marker lampTurn signalBack up light
All bulbs in the taillight cluster can be replaced
from inside the trunk.1. Switch off all lights and turn ignition key to
position0.
2. Unlock and fold down the side panel to
access the bulbs.
The bulbs are located in two separate bulb
holders, an upper and a lower. Each bulb
holder has a locking pin.
Replace bulbs in the upper and lower
bulb holders as follows:1. To ease the work: disconnect the cable
from the bulb holder.2. Press the catches together and pull out the
holder.
3. Replace the bulb.
4. Reconnect the cable.
5. Close and secure the side panel.
NOTE
If the message indicating a burned out bulb
remains in the information display after the
bulb has been replaced, consult a trained
and qualified Volvo service technician.

09 Maintenance and servicingReplacing bulbs
09204
High level brake lightThese bulbs are of a special type. We recom-
mend that you ask a trained and qualified Volvo
service technician to replace this bulb.License plate lights
G028442
1. Switch off the ignition.
2. Loosen the screws with a torx screwdriver.
3. Carefully pull out the lamp housing.
4. Turn the bulb holder counterclockwise and
pull it out.
5. Pull out the defective bulb and insert a new
one.6. Reinsert the bulb holder into the housing
and turn it clockwise.
7. Reinstall the housing and screw it in place.
Footwell lighting
G027287
The door step courtesy lights are located under
the dash on the driver's and passenger's sides.
To replace a bulb:
1. Carefully insert a screwdriver and pry out
the lens.
2. Replace the defective bulb.
3. Reinstall the lens.
Trunk lights
G028441
1. Carefully insert a screwdriver and pry out
the lens.
2. Pry out the bulb and replace it.
3. Press the lens back into place.

09 Maintenance and servicingFuses
09210
No.
A
17
Driver's side front foglight
(option)
7.5
18
Passenger's side front foglight
(option)
7.5
19
–
–
20
–
–
21
Transmission control module,
reverse gear block (M66)
10
22
Driver's side high beam
10
23
Passenger's side high beam
10
24
–
–
25
–
–
26
–
–
27
–
–
28
Power passenger's seat
(option), audio system
5
29
Fuel pump
7.5
30
-
-
31
–
–
No.
A
32
–
–
33
Vacuum pump
20
34
Windshield washer pump
15
35
–
–
36
–
–

09 Maintenance and servicing
Fuses
09
213
No.
A
17
Accessory audio
5
18
–
19
Folding head restraints
15
20
Trailer wiring (15-feed) - option
20
21
–
22
–
23
All Wheel Drive
7.5
24
Four-C chassis system
(option)
15
25
–
26
Park assist (option)
5
27
Main fuse: trailer wiring, Four-
C, park assist, All Wheel Drive
30
28
Central locking system
15
29
Driver's side trailer lighting:
parking lights, turn signal
(option)
25
30
Passenger's side trailer light-
ing: parking light, brake light,
fog light, turn signal (option)
25
No.
A
31
Main fuse: fuses 37 and 38
40
32
–
33
–
34
–
35
–
36
–
37
Heated rear window
20
38
Heated rear window
20

10 Audio
Radio functions HU-650/HU-850
10``219
Switch on/off
Press the knob to switch on or
turn off the radio.
Volume controlTurn the knob clockwise to increase volume.
Volume control is electronic and does not have
an end stop. If you have a key pad in the steer-
ing wheel, increase or decrease the volume
with the + or – buttons.Volume control - ALARMIf a CD is playing when the radio receives an
alarm bulletin (available in certain areas only),
the CD player enters pause mode. The bulletin
is broadcast at the volume selected for this
type of message.
G026678
Auxiliary (AUX) 3.5 mm connector portAfter the bulletin has been completed, the
audio system reverts to the originally selected
sound.AUX connector (option)The AUX (auxiliary) port can be used to connect
external devices such as an mp3 player.
Turn the SOURCE control (see the illustrations
on on page 217 or 218) to choose AUX.
If the player is being charged through a 12-volt
socket while it is connect to the AUX port,
sound quality may be impaired.
The volume of the external sound source AUX
may be different from the volume of the internalsound sources such as the CD player or the
radio.
To change the AUX volume level:
1. While playing the radio or a CD, lower the
audio volume to about one-quarter.
2. Switch to AUX mode on the audio system.
3. Connect the headphone output from your
music player to the AUX input using a cable
with a stereo 3.5mm miniplug at both ends.
4. Set your music player's headphone vol-
ume to three-quarters using the player's
volume controls.
5.
PressSOURCE, turn the SOURCE knob,
select
ADVANCED MENU
and press
SOURCE.
6.
Press the SOURCE knob, turn to AUDIO
SETTINGS and press SOURCE.
7.
Press the SOURCE knob, turn to
AUX
INPUT
and press SOURCE.
8. Turn the volume knob to raise or lower the
AUX Input Volume
until you hear music at
a comfortable level.
9. If there is distortion, lower your music play-
er's headphone volume until the distortion
goes away.
10. Finally, exit the menu and adjust the audio
volume to a comfortable level.