Downloaded from www.Manualslib.com manuals search engine Instruments 
CClJ Introduction 
This chapter  contains  information on the following 
subjects : 
I nst
rument  overview  . . . . . . .  . .  . . .  . . . .  . . .  . . 20 
D isplays  . . . . . .  . . .  . .  . . . .  . . . .  . . . . .  . . . .  . . .  21 
S ervice  interval  disp lay  . . . . . . .  . . .  . . .  . . 
.  . . .  24 
Additional information and warnings: 
• W arning  and indicato r la mps ::;. page 16 
• V olkswage n inf orm ation  system :::;. page  26 
• lnfota inment s ys tem ~page 31 
Instrument overview 
Fig.  12 Instrument  clus ter in the  das h pane l 
• Se lec ted  gear  displa y (for veh icles w ith an  au
tomatic  gearbox) ::;.page 169 
• Informat ion  on  service  intervals ~Booklet Serv
ice schedule 
·A WARNING 
Accidents and  injuries  can occur if the driver 
is d is tracted . 
• Never press the buttons on  the  instrument 
cluster while  the vehicle  is in motion. 
rn First read  and observe  the introductory information  and safety  warnings & on page 20. 
D escriptions 
of the  instr uments ~Fig. 12: 
G) Rev. counter (runn ing engine speed in revo lutio n s x 1, 00 0 per  minute). 
The  start of the red  zone  on th e d ia l ind icates  th e  max im um e ng ine  sp eed  that may  be used  in each 
gear  when  the eng ine 
is warm  and after  it  has been  run in proper ly . You should  change  up a gear  or 
move  the selector  lever  to 
0 (or lift your  foot  off  th e a ccele ra tor ) be fore  the  need le  reaches  the red 
zone 
~CD. 
0 Coolant temperature  display ~page 28 6. 
G) Displays ~page 21. 
@ Reset , set and display button ~page 21. 
® Speedometer 
® Fuel gauge ~page 269. 
Overv iew 
of the vehicle   
Downloaded from www.Manualslib.com manuals search engine 0 N ,....: 0 .C) 
Service 
If a service is due, an acoustic signal will sound 
and the spanner symbol _.c with the message 
Service now! will appear for a few seconds in 
the instrument cluster display when the ignition  is 
switched on. ==>Fig. 14 B. 
Accessing a service message 
You can access the current service message when 
the ignition is switched on, the engine is not  run
ning , 
and the vehicle is stationary: 
• Press and hold button ==>Fig . 12 @ until the 
word Service appears in the display. 
• 
Release the button . The current  service mes
sage will be shown in the display. 
Service information ==>Fig. 15 can also be dis
played in the infotainment system by pressing  the 
@ill button and the ~ and [Serv ice ) function  buttons 
==>page 31. 
Resetting the service interval display 
If the service was not performed by a Volkswagen 
workshop, the display can be reset as follows:  • 
Switch 
off the  ignition and press and hold but
ton ==>Fig. 12 @. 
•  Switch on the  ignition . 
• Release button @ and then press it again to 
reset  the service 
interval  display. 
m The service message will disappear after a 
W few seconds, when the engine is running , or 
when the OK/RESET button on the windscreen wiper 
lever or the OK button on the multifunction steering 
wheel is pressed. 
m If the vehicle battery was disconnected for 
W long periods  in vehicles with flexible service, 
the  system  cannot 
calculate the time at which the 
next  service  is due. The  information  shown in the 
service interval  display may therefore  be incorrect. 
If this  is the  case, please heed  the maximum per
missible service intervals  listed in the ==>Book-
let Service  Schedule. 
I --