Page 356 of 516
356 4-3. Do-it-yourself maintenance
3.5 L V6 (2GR-FE) engineLow
Full
■ Adding engine oil
If the oil level is below or near
the low level mark, add engine
oil of the same type as already in
the engine.
Make sure to check the oil type and prepare the items needed before
adding oil. Remove the oil filler cap by turning it counterclockwise.
Add engine oil slowly, checking the dipstick.
Install the oil filler cap by turning it clockwise.
The approximate quantity of oil needed to raise the level from low to full on
the dipstick is indicated as follows:
1.6 qt. (1.5 L, 1.3 lmp. qt.)
Oil grade ILSAC multi-grade engine oil
Items Clean funnel
STEP 1
STEP 2
STEP 3
Page 470 of 516
470 6-1. Specifications
Fuel
Lubrication system
Fuel typeUnleaded gasoline only
Octane rating 87 (Research Octane Number 91) or higher
Fuel tank capacity
(Reference) 15.9 gal. (60 L, 13.2 lmp.gal.)
Oil capacity
Drain and refill (Refer-
ence)
Without filter
With filter 2.5 L 4-cylinder (2AR-FE) engine
4.2 qt. (4.0 L, 3.5 Imp.qt.)
3.5 L V6 (2GR-FE) engine
6.0 qt. (5.7 L, 5.0 Imp.qt.)
2.5 L 4-cylinder (2AR-FE) engine
4.7 qt. (4.4 L, 3.9 Imp.qt.)
3.5 L V6 (2GR-FE) engine
6.4 qt. (6.1 L, 5.4 Imp.qt.)
Oil grade
ILSAC multi-grade engine oil
Page 473 of 516
473
6-1. Specifications
6
Vehicle specifications
Electrical system
Rear differential (4WD models)
Automatic transaxle
Battery
Open voltage* at
68
F (20 C): 12.6 12.8 V Fully charged
12.2 12.4 V Half charged
11 . 8
12.0 V Discharged
(*: Voltage is checked 20 minutes
after the engine and all the lights are
turned off)
Charging rates 5 A max.
Oil capacity0.5 qt. (0.5 L, 0.4 Imp. qt.)
Oil typeHypoid gear oil API GL-5
Recommended oil viscosityAbove 0
F (-18 C): SAE 90
Below 0 F (-18 C): SAE 80W or SAE
80W-90
Fluid capacity 4-speed models
8.6 qt. (8.1 L, 7.1 Imp. qt.) 5-speed models
9.3 qt. (8.8 L, 7.7 Imp. qt.)
Fluid type Toyota Genuine ATF WS
NOTICE
■Automatic transmission fluid type
Using automatic transmission fluid other than “Toyota Genuine ATF WS”
may cause deterioration in shift quality, locking up of your transmission
accompanied by vibration, and ultimately damage the automatic transmis-
sion of your vehicle.
Page 474 of 516
474 6-1. Specifications
Transfer (4WD models)
Brakes
*1: Minimum pedal clearance when depressed with a force of 110 lbf (490 N,50 kgf) while the engine is running
*
2: Parking brake pedal travel when depressed with a force of 45 lbf (200 N, 21 kgf)
Steering
Oil capacity 0.48 qt. (0.45 L, 0.40 Imp.qt.)
Oil typeHypoid gear oil API GL-5
Recommended oil viscosityAbove 0
F (-18 C): SAE 90
Below 0 F (-18 C): SAE 80W or SAE
80W-90
Pedal clearance*1Without third seats
3.7 in. (95 mm)
With third seats
4.7 in. (120 mm)
Pedal free play 0.04 0.24 in. (1 6 mm)
Brake pad wear limit 0.04 in. (1.0 mm)
Parking brake lining wear limit 0.04 in. (1.0 mm)
Parking brake pedal travel*26 8 clicks
Fluid type SAE J1703 or FMVSS No. 116 DOT 3
Free playLess than 1.2 in. (30 mm)
Page 516 of 516
516
GAS STATION INFORMATION
Auxiliary catch leverP. 348Fuel filler doorP. 8 8
Hood release lever P. 3 4 8Fuel filler door opener P. 8 8Tire inflation pressure
P. 475
Fuel tank capacity (Reference) 15.9 gal. (60 L, 13.2 lmp.gal.)
Fuel type Unleaded gasoline with an Octane Rating
of 87 (Research Octane Number 91)
Cold tire inflation
pressure
P. 4 7 5
Engine oil capacity
Drain and refill
(Reference) P. 470
Engine oil typeToyota Genuine Motor Oil or equivalent
Oil grade: P. 470
ILSAC multigrade engine oil
Recommended oil viscosity: SAE 5W-20 or 0W-20 (2.5 L 4-cylinder
[2AR-FE] engine) SAE 5W-30 (3.5 L V6
[2GR-FE] engine)