2009 TOYOTA CAMRY engine

316
4-3. Do-it-yourself maintenance
Engine compartment
2.4 L 4-cylinder (2AZ-FE) engine
Power steering fluid
reservoir (→P. 328)
Engine oil filler cap (→ P. 320)
Engine oil level dipstick (→ P. 319)
Brake fluid reservoir (→ P. 327)Fuse box ( →P. 357)
Battery ( →P. 330)
Radiator ( →P. 326)
Electric cooling fans
Condenser ( →P. 326)
Washer fluid tank ( →P. 333)
Engine coolant reservoir (→ P. 325)

317
4-3. Do-it-yourself maintenance
4
Maintenance and care
3.5 L V6 (2GR-FE) engine
Power steering fluid
reservoir (
→P. 328)
Engine oil filler cap (→ P. 320)
Engine oil level dipstick (→ P. 319)
Brake fluid reservoir (→ P. 327)Fuse box ( →P. 357)
Battery ( →P. 330)
Radiator ( →P. 326)
Electric cooling fans
Condenser ( →P. 326)
Washer fluid tank ( →P. 333)
Engine coolant reservoir (→ P. 325)

318 4-3. Do-it-yourself maintenance
Engine compartment cover (3.5 L V6 [2GR-FE] engine only)
■ Removing the engine compartment cover
■ Installing the clips

319
4-3. Do-it-yourself maintenance
4
Maintenance and care
Engine oil
With the engine at operating temperature and turned off, check the oil
level on the dipstick.
■ Checking the engine oil
Park the vehicle on level ground. After turning off the engine,
wait a few minutes for the oil to drain back into the bottom of
the engine.
Hold a rag under the end and
pull the dipstick out.
Wipe the dipstick clean.
Reinsert the dipstick fully.
Holding a rag under the end, pull the dipstick out and check
the oil level.
Wipe the dipstick and reinsert it fully.
2.4 L 4-cylinder (2AZ-FE) engine
Low
Full
STEP1
STEP2
STEP3
STEP4
STEP5
STEP6

320 4-3. Do-it-yourself maintenance
3.5 L V6 (2GR-FE) engineLow
Full
■ Adding engine oil
If the oil level is below or near
the low level mark, add engine
oil of the same type as already in
the engine.
Make sure to check the oil type and prepare the items needed before
adding oil. Remove the oil filler cap.
Add engine oil slowly, checking the dipstick.
Oil grade ILSAC multigrade engine oil
Items Clean funnel
STEP1
STEP2

321
4-3. Do-it-yourself maintenance
4
Maintenance and care
Install the filler cap,
turning it clockwise.
The approximate quantity of oil needed to raise the level between low and
full on the dipstick is indicated as follows:
2.4 L 4-cylinder (2AZ-FE) engine
1.2 qt. (1.1 L, 1.0 lmp. qt.)
3.5 L V6 (2GR-FE) engine
1.6 qt. (1.5 L, 1.3 lmp. qt.)
■ Recommended viscosity
2.4 L 4-cylinder (2AZ-FE) engine
5W-20 or 0W-20
SAE 5W-20 or 0W-20 engine oil
may be used. However, SAE 0W-
20 is the best choice for good fuel
economy and good starting in
cold weather.
3.5 L V6 (2GR-FE) engineSAE 5W-30 is the best choice for
good fuel economy, and good
starting in cold weather.
If SAE 5W-30 oil is not available,
SAE 10W-30 oil may be used.
However, it should be replaced
with SAE 5W-30 at the next oil
change.
STEP3
Outside temperature
Outside temperature

323
4-3. Do-it-yourself maintenance
4
Maintenance and care
■
Engine oil consumption
●The amount of engine oil consumed depends on the oil viscosity, the
quality of the oil and the way the vehicle is driven.
● More oil is consumed under driving conditions such as high speeds and
frequent acceleration and deceleration.
● A new engine consumes more oil.
● When judging the amount of oil consumption, keep in mind that the oil
may have become diluted, making it difficult to judge the true level accu-
rately.
● Oil consumption: Max. 1.1 qt./600 miles, 0.9 lmp.qt./600 miles (1.0 L per
1000 km)
● If you consume more than 1.1 qt. (1.0 L, 0.9 lmp.qt.) every 600 miles
(1000 km), contact your Toyota dealer.
■ After changing the engine oil (U.S.A. only)
To reset the oil change system, follow the procedure below:
Turn the “ENGINE START STOP” switch or engine switch OFF with
the trip meter A reading shown. ( →P. 149)
While pressing the trip meter reset button ( →P. 141), turn the
“ENGINE START STOP” switch or engine switch ON.
Without multi-information display
Continue to press and hold the knob until the trip meter displays
000000.
With multi-information display Continue to press and hold the knob until “COMPLETE” appears on
the multi-information display.
STEP1
STEP2
STEP3
STEP3

324 4-3. Do-it-yourself maintenance
CAUTION
■Used engine oil
●Used engine oil contains potentially harmful contaminants which may
cause skin disorders such as inflammation or skin cancer, so care should
be taken to avoid prolonged and repeated contact. To remove used engine
oil from your skin, wash thoroughly with soap and water.
● Dispose of used oil and filters only in a safe and acceptable manner. Do
not dispose of used oil and filters in household trash, in sewers or onto the
ground. Call your Toyota dealer, service station or auto parts store for
information concerning recycling or disposal.
● Do not leave used engine oil within the reach of children.
NOTICE
■To prevent serious engine damage
Check the oil level on a regular basis.
■ When replacing the engine oil
●Be careful not to spill engine oil on the vehicle components.
● Avoid overfilling, as the engine could be damaged.
● Check the oil level on the dipstick every time you refill the vehicle.
● Be sure the engine oil filler cap is properly tightened.