2009 SKODA OCTAVIA width

Seats and Stowage
80
Removing and installing a head restraint – Pull the head restraint up out of the seat backrest as far as the stop (on
the rear head restraints fold forward the seat backrest).
– Press the locking button in the direction of arrow
⇒
page 79, fig. 78

and pull the head restraint out.
– To re-insert the head restraint, push it down into the seat backrest far
enough until you hear the locking button engage.
The position of the front and rear outer head restraints is adjustable in height. The middle rear head restraint is adjustable in two positions. The head restraints must be adjusted to
match the size of the seat occupant.
Correctly adjusted head restraints togeth
er with the seat belts offer effective
protection for the occupants
⇒page 164, “Correct seated position”.
WARNING
•
The head restraints must be correctly adjusted in order to offer effective
protection for the occupants in the event of an accident.•
Do not drive under any circumstance with removed head restraints - risk
of injury!•
If the rear seats are occupied, the rear head restraint must not be in the
lower position.
Middle rear head restraintIIn certain countries national legal pr
ovisions also require the equipment
of the rear seat with fixing eyes for
child seat using the “Top Tether” system
⇒
page 191. For vehicles, which are eq
uipped with such fixing eyes, a
deviating sequence for removing th
e middle head restraint must be
observed. Removing and installing the rear middle head restraint – Pull the head restraint out of the
seat backrest as far as the stop.
– Press the locking button in the direction of arrow , press simultane-
ously the locking button into the opening using a flat screwdriver with a width of maximum 5 mm and pull out the head restraint.
– To re-insert the head restraint, push it down into the seat backrest far
enough until you hear the locking button engage.
WARNING
•
The head restraints must be correctly adjusted in order to offer effective
protection for the occupants in the event of an accident.•
Do not drive under any circumstance with removed head restraints - risk
of injury!
Fig. 79 Rear seats: middle head restraint
AA
AB
se0.1.book Page 80 Friday, April 10, 2009 3:19 PM

Wheels and Tyres
240
WARNING
•
You must have your tyres replaced with new ones at the latest when the
wear indicators have been worn do
wn. The legally permissible minimum
tread depth should be observed.•
Worn tyres do not provide the necessary adhesion to the road surface at
high speeds on wet roads. One could experience “aquaplaning” (uncon- trolled movements of the vehicle - “swimming” on a wet road surface).Changing wheels aroundIf significantly greater wear is present on
the front tyres, we recommend changing
the front wheels around with the rear wheels as shown in the diagram
⇒fig. 220
.
You will then obtain approximately the same life for all the tyres. It may be advantageous to swap the tyre
s over “crosswise” when certain types of
wear characteristic ar
ise on the running surface of the tyres (but not in the case of
unidirectional tyres). The co-workers of the authorised Škoda Service Partners are extensively familiar with the combination possibilites. We recommend that you change the wheels around every 10 000 km in order to achieve even wear on all wheels and to obtain optimal tyre life.
New tyres and wheelsTyres and wheel rims are important design elements. One should therefore use the tyres and wheel rims which have been re
leased for use by Škoda Auto. They are
exactly matched to the vehicle type and therefore contribute significantly to good road holding and safe driving characteristics
⇒
.
Only fit radial tyres of the same type on
all 4 wheels, size (rolling circumference)
and, if possible, the same tread pattern on one axle. The authorised Škoda Service Partners have access to the most current information about which tyres we have rele
ased for use on your vehicle.
We recommend that you have any work rela
ting to tyres or wheels carried out by
an authorised Škoda Service Partner
. The authorised Škoda Service Partners
have all of the nece
ssary special tools and replacem
ent parts available plus the
required specialist knowledge and are also in a position to properly dispose of the old tyres. A large number of authorised Škoda Service Partners also have an attrac- tive range of tyres and wheels available. The tyre/wheel combinations which are appr
oved for your vehicle are indicated in
your vehicle documents. Approval and lice
nsing may differ according to the legis-
lation prevailing in individual countries. Proper knowledge of the tyre data makes it easier for you to select the correct type of tyre. Tyres do, for exam
ple, have the following
inscription
on their walls:
195 / 65 R 15 91 T
What this means is: The following
speed restrictions
apply to tyres.
Fig. 220 Changing wheels around
195
Tyre w idt h in mm
65
Height/width ratio in %
R
Code letter for the type of tyre -
R adial
15
Diameter of wheel in inches
91
Load index
T
Speed symbol
se0.1.book Page 240 Frida
y, April 10, 2009 3:19 PM

Wheels and Tyres
242
•
The wheel bolts must be clean and must
turn easily. However, they must
never be treated with grease or oil.•
If the wheel bolts are tightened to a too low tightening torque, the rim
can lossen when the car is moving - risk of accident! A tightening torque which is too high can damage the bolts and threads and this can result in permanent deformation of the contact surfaces on the rims.
Caution
The prescribed tightening torque of the wheel bolts for steel and light alloy wheels is 120 Nm.Winter tyresThe handling of your vehicle will be signi
ficantly improved when driving on wintry
roads if you fit winter tyres. Summer tyres do not offer the same grip on ice, snow and at temperatures below 7 °C because of
their construction (width, rubber blend,
tread pattern). This particularly applie
s to vehicles which
are equipped with
low-
profile tyres
or high-speed tyres
(code index H or V on wall of tyre).
Winter tyres must be mounted on all four
wheels to obtain the
best handling char-
acteristics. You must only fit those types of winter tyre
which are approved for your vehicle. The
permissible
sizes of winter tyres
are stated in your vehicle documents. Approvals
may differ because of
national legislation.
Please remember that the tyres should be in
flated to 20 kPa (0.2 bar) more than is
the case for summer tyres
⇒page 238.
Winter tyres no longer offer the
same winter performance once the
tyre tread
has
worn down to a depth of about 4 mm. Ageing
a l s o c a u s e s w i n t e r t y re s t o l o s e m o s t
of their winter performance properties
- even in cases where the remaining tread depth is still clearly more than 4 mm. Speed restrictions
apply to winter tyres as
well as to summer tyres
⇒page 240,
⇒
.
You can fit winter tyres of a lower speed ca
tegory to your vehicle provided that you
also do not drive faster than the permissible maximum speed for such tyres, even if the possible maximum speed of your ve
hicle is higher. The
corresponding tyre
category can damage the tyres when ex
ceeding the permissible maximum speed.
Please pay attention to the notes if
you decide to fit winter tyres
⇒page 238.
You can also fit so-called “all-year tyres” instead of winter tyres.Please contact your specialist garage if there are any points which are not clear who will be able to provide you with information regarding the maximum speed for your tyres.
WARNING
You must on no account drive your car at more than the permissible maximum speed for your winter tyres -
risk of an accident resulting from
tyre damage and loss of control over your car.
For the sake of the environment
Fit your summer tyres on again in good time since summer tyres offer you better grip and handling on roads which are free of snow and ice as well as ar tempera- tures below 7 °C - the braking distance is shorter, there is less tyre noise, tyre wear is reduced and fuel consumption is reduced.
Note
Please observe the various differing legal requirements regarding tyres.Unidirectional tyres*The direction of rotation of the tyres is marked by
arrows on the wall of the tyre
.
This indicates the direction of
rotation of the tyre, and it is essential that the tyres
are fitted on to run in this direction. On
ly then are the tyres able to provide the
optimal properties in terms of grip, lo
w noise, wear-and-tear and aquaplaning.
Should it be necessary to fit on a spare
wheel in exceptional cases with a tyre not
dedicated to the running direction or in o
pposite running direct
ion, please adopt a
WARNING (continued)
se0.1.book Page 242 Frida
y, April 10, 2009 3:19 PM

Technical Data
273
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
DimensionsDimensions (mm)
OCTAVIA
OCTAVIA RS
COMBI
CO M B I R S
COMBI 4x4
SCOUT
Length
4569
4597
4569
4599
4569
4584
Width
1769
1769
1769
1769
1769
1784
Width including
exterior mirror
2018
2018
2018
2018
2018
2018
Height
1462 1485
a)
1449
b)
a)The value corresponds to the status with rough road package.b)The value corresponds to the status with SPORT package.
1447
14681490
a)
1455
b)
1451
14951520
a)
1533
Clearance
140/164
a)/125
b)
127
140/164
a)/125
b)
128
138/163
a)
179
Wheel base
2578
2578
2578
2578
2578
2578
Tr a c k g a u g e f r o n t / r e a r
1541/1514
1528/1508
1541/1514
1528/1508
1541/1514
1531/1500
se0.1.book Page 273 Frida
y, April 10, 2009 3:19 PM