88C-10
AIR BAG AND PRETENSIONERS
Passenger's frontal airbag: Removal - Refitting
88C
REFITTING
I - REFITTING PREPARATION OPERATION
aAlways replace the passenger's airbag nuts.
II - REFITTING OPERATION FOR PART
CONCERNED
aFit the passenger front airbag into its housing.
aRefit new nuts of the passenger's front airbag.
aTorque tighten the passenger front airbag nuts
(21 Nm).
aClip the passenger front airbag onto the dashboard.
aConnect the passenger front airbag connector.
aLock the passenger front airbag connector.
aFit the wiring in the position that was marked when
dismantling the passenger's front airbag.aRefit the tie rod between the bulkhead and the dash-
board cross member.
aTorque tighten the nuts of the tie rod side on the
bulkhead side (8 Nm ).
aClip the flap of the dashboard glovebox.
III - FINAL OPERATION.
aConnect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-2) .
aUnlock the airbag computer using the Diagnostic
tool (see Fault finding - Replacement of compo-
nents) (88C, Airbags and pretensioners).
(see 88C, Air bag and Pretensioners, Airbags
and pretensioners: Recycling - Destruction,
page 88C-2) . IMPORTANT
After a seat belt pyrotechnic component is trigge-
red, it is essential to replace certain parts.
(see 88C, Air bag and Pretensioners, Airbag
and pretensioners: Precautions for the repair,
page 88C-1) .
IMPORTANT
When the passenger front airbag is triggered, the
consequent damage caused to the mountings
always requires the dashboard to be replaced.
Affix the label warning against fitting a rear-facing
child seat on the front passenger seat to the pas-
senger side of the dashboard.
Note:
Check that the passenger's front airbag is braced
against the dashboard cross member.
WARNING
To prevent damage to the wiring har ness when
refitting, observe the original routing.
K9K – D4F, and 780
IMPORTANT
To avoid a fault with or even triggering of pyro-
technic components (airbags or pretensioners),
check the airbag computer using the diagnostic
tool.
IMPORTANT
To eliminate the risk of any accident, do not
reuse pyrotechnic components.
It is essential to destroy pretensioners or airbags
before scrapping a vehicle or the single part.
