Page 7 of 42
86A-7
MR-413-X44-86A000$378_eng.mif
V1
86A
RADIO
General Information
For repairs or fault finding, the receiver is fitted with a test menu (see radio self-test procedure).
The radio will operate for approximately 20 minutes without the ignition being switched to the accessories position.
The radio bleeps then switches off.
Notes:
●All radios are designed to control a CD changer.
●There is a special procedure for replacing the CD changer located in the dashboard front panel.
RADIO FUNCTION
The tuner has three selection modes displayed on the screen and accessible from the radio front panel:
–manual mode (MANU),
–preset mode (PRESET),
–alphabetical mode (LIST).
CD FUNCTION
The CD player can play conventional discs and any audio tracks on a CD-ROM.
CDs can be played in order or tracks can be chosen at random.
If a CD changer is being used, random play is possible on only one of the possible 6 compact discs.
THERMAL PROTECTION
If the radio temperature is too high for it to function properly, the volume is automatically reduced (without changing
the volume shown in the display).
Should one of the speaker tracks short circuit, the supply to the amplifier will be cut off.
VOLUME CONTROL
The volume can be increased according to the vehicle speed. To activate the function, select the desired volume
adjustment curve in expert mode (press and hold the source button until you hear a bleep): SPEED 5 for maximum
increase, 0 to switch off the increase function.
*RDS: Radio Data System
MR-413-X44-86A000$378_eng.mif
Page 38 of 42
86A-38
MR-413-X44-86A000$945_eng.mif
V1
RADIO
Recovering a jammed CD86A
REMOVAL
Remove the two bolts (A).
Turn the CD changer over a nd remove the 6 screws (B).
Turn the CD changer over and remove the cover.
Remove the mechanism from its housing.
CHANGER IN THE DASHBOARD
Page 39 of 42
86A-39
MR-413-X44-86A000$945_eng.mif
V1
RADIO
Recovering a jammed CD86A
Remove the two bolts (C).
Take out the CD guide arm and disconnect the
connector (D).Remove the eight bolts (E),
Remove both clips from the two connectors.
CHANGER IN THE DASHBOARD
Page 40 of 42
86A-40
MR-413-X44-86A000$945_eng.mif
V1
RADIO
Recovering a jammed CD86A
Remove both ribbon cables.
Remove the upper section of mechanism.Turn the guides and push the mechanism as shown in
the diagram in order to raise or lower the CDs.
The CDs can now be accessed.
CHANGER IN THE DASHBOARD
IMPORTANT
Never refit the changer mechanism once it has been
removed.
