86A-2V1 MR-413-X44-86A150$010.mif
86A
R2-08
Vdiag No.: 64
1. SCOPE OF THIS DOCUMENT
This document presents the fault finding method applicable to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING
Documentation type
Fault finding procedures (this document):
–Assisted fault finding (integrated into the diagnostic tool), Dialogys.
Wiring Diagrams:
–Visu - Schéma.
Type of diagnostic tools
–CLIP
Special tooling required
3. REMINDERS
Fault finding procedure
To run fault finding on the vehicle computers, switch on the ignition.
Depending on the type of vehicle equipment, proceed as follows:Vehicle(s): Clio III / New TwingoComputer name: R2-08
Function concerned: RadioVDIAG No.: 64
Special tooling required
Diagnostic tool
Multimeter
Elé. 1681 Universal bornier
For vehicles with key-operated/radio frequency remote control, use the key to switch on the ignition.
For vehicles with Renault cards,
–with the vehicle card in the card reader,
–press and hold the start button (longer than 5 seconds) with start-up conditions not fulfilled,
connect the diagnostic tool and perform the required operations.
R208_V64_PRELI
RADIO
Fault finding – Introduction
86A-104
AFTER REPAIRCarry out another fault finding check on the system.
Deal with any faults.
V1 MR-413-X44-86A150$190.mif
RADIO
Fault finding – Fault Finding Chart86A
R01-08
Vdiag No.: 64
ALP 17 Problem pairing my telephone to the radio
NOTESUse the Wiring Diagrams Technical Note for Clio III or New Twingo.
Consult the list of compatible phones on
Renault.net.
Is the customer's phone in the list of compatible
phones authorised by Renault?Explain to the customer that the phone is not
compatible with this radio.
Is it possible to pair another compatible phone
to this radio?Contact the Techline.
Is it possible to pair the customer's phone to
this radio when outside?The problem disappears.
Is the customer's phone working properly?Explain to the customer that the phone must
be replaced.
Contact the Techline.
NO
YES
NO
YES
YES
NO
NO
YES
R208_V64_ALP17
