2009 RENAULT TWINGO CD changer

86A-39
MR-413-X44-86A000$945_eng.mif
V1
RADIO
Recovering a jammed CD86A
Remove the two bolts (C).
Take out the CD guide arm and disconnect the
connector (D).Remove the eight bolts (E),
Remove both clips from the two connectors.
CHANGER IN THE DASHBOARD

86A-40
MR-413-X44-86A000$945_eng.mif
V1
RADIO
Recovering a jammed CD86A
Remove both ribbon cables.
Remove the upper section of mechanism.Turn the guides and push the mechanism as shown in
the diagram in order to raise or lower the CDs.
The CDs can now be accessed.
CHANGER IN THE DASHBOARD
IMPORTANT
Never refit the changer mechanism once it has been
removed.

86A-41
MR-413-X44-86A000$945_eng.mif
V1
RADIO
Recovering a jammed CD86A
Remove:
–the three bolts (1) located underneath the unit,
–the two springs (2) after moving them to the top
position.Remove the electronic module from the support and fit
it to the side.
First solution
If the electric motors are operating:
1. Reinsert the CD and its drawer into the changer (4)
using a 4.5 V battery to supply the electric motor (3),
(attach the + wire to contact (1) and the - wire to
contact (2)).
2. Eject the changer by moving lever (4).
CHANGER IN THE BOOT

86A-42
MR-413-X44-86A000$945_eng.mif
V1
RADIO
Recovering a jammed CD86A
Second solution
If the electric motors are not operational:
1. To reinsert the CD and its drawer into changer (5),
remove the pinion mounting (6) using its bolt.
Turn the toothed wheel (7) anti-clockwise by hand until
the drawer is turned completely upside down in the
changer (5).2. Eject the CD changer by moving the lever (8).
Before replacing the radio:
●refit the module in its unit, replace the four
dampers and the two springs,
●attach the module to the unit using the three bolts,
●close the changer, reattach its cover and refit the
rear section.
CHANGER IN THE BOOT