86A-61V1 MR-413-X44-86A150$130.mif
RADIO
Fault finding – Conformity check86A
R2-08
Vdiag No.: 64
FUNCTION: MULTIMEDIA
SUB-FUNCTION: AUDIO
NOTESOnly carry out this conformity check after a complete check with the diagnostic tool.
The values shown in this conformity check are given as a guide.
Application condition: engine off, ignition on.
FunctionParameter or status checked
or actionDisplay and notes Fault finding
Audio testAC004:Test right front
speaker line
This command is used to
successively activate
each speaker.In the event of an
inconsistency, consult the
interpretation of fault DF001
Front right-hand speaker.
AC005:Test left front
speaker lineIn the event of an
inconsistency, consult the
interpretation of fault DF002
Front left-hand speaker.
AC006:Test right rear
speaker lineIn the event of an
inconsistency, consult the
interpretation of fault DF003
Rear right-hand speaker.
AC007:Test left rear
speaker lineIn the event of an
inconsistency, consult the
interpretation of fault DF004
Rear left-hand speaker.
Microphone testAC010:Microphone testThis command is for
testing microphone
operation.
NOTE:
Test in a quiet place.
Command AC010 is
inactive if the auxiliary
source is selected.
Example: presence of
a USB key.In the event of an
inconsistency, consult the
interpretation of fault DF056
Microphone.
86A-69V1 MR-413-X44-86A150$170.mif
86A
R2-08
Vdiag No.: 64
Tool
commandDiagnostic tool title Description
RZ003:Fault memoryThis command is used for clearing the stored
faults from the computer.
AC004:Test right front speaker line
These commands are used to carry out
a listening test for each speaker.
NOTE:
These commands are not usable if the
anti- theft code is not entered. AC005:Front left-hand speaker lines test
AC006:Rear right-hand speaker lines test
AC007:Test left rear speaker line
AC010:Microphone testThis command is for testing microphone
operation.
NOTE:
Command AC010 is inactive if the auxiliary
source is selected.
Start by setting the radio to CD or radio
mode and run command AC010.
This command is not usable if the anti-theft
code is not entered.
AC013:CD ejectionThis command is used for testing CD ejection
from the CD player.
Set the radio to CD mode and run command
AC013.
SC002:Computer configuration See Configuration and Programming.
RADIO
Fault finding – Command summary table
