PARKING DISTANCE CONTROL
Fault finding - Introduction
87F
87F - 2V2 MR-413-X44-87F000$066_eng.mif
187F
Vdiag No.: 04 08PARKING DISTANCE CONTROL
Fault finding - Introduction
1. SCOPE OF THIS DOCUMENT
This document presents the fault finding procedure applicable to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING
Documentation type
Fault finding procedures (this manual):
–Assisted fault finding (integrated into the diagnostic tool), Dialogys.
Wiring Diagrams:
–Visu-Schéma (CD-ROM), paper.
Type of diagnostic tools
–CLIP + multiplex line sensor
Special tooling required
3. RECAP
To run fault finding on the vehicle computers, switch on the ignition.
Depending on the type of vehicle equipment, proceed as follows:
To cut off the + after ignition feed, proceed as follows:Vehicle(s): New Twingo
Function concerned: Parking distance controlComputer name: Parking proximity sensor
Vdiag No.: 04 08
Special tooling required
Multimeter
Elé. 1681 Universal bornier
For vehicles with radio frequency remote control/key,
switch on the ignition with the key.
For vehicles with key/radio frequency remote control,use the key to switch off the ignition.
AAP_V04_PRELI/AAP_V08_PRELI
MR-413-X44-87F000$066_eng.mif
