38C-14
MR-413-X44-38C000$423_eng.mif
V1
38C
ANTI-LOCK BRAKING SYSTEM
Fault finding - Fault summary table
Tool fault Associated DTC Diagnostic tool title
DF00150 Short circuit Computer supply
DF0065015 Front left-hand wheel speed sensor circuit
DF0075035 Rear left-hand wheel speed sensor circuit
DF008501F Front left-hand wheel speed sensor signal
DF009503F Rear left-hand wheel speed sensor signal
DF01050D3 Pump motor circuit
DF01750C3 Computer
DF0205140 Tachometric index programming
DF0265005 Front right-hand wheel speed sensor circuit
DF0275025 Rear right-hand wheel speed sensor circuit
DF028500F Front right-hand wheel speed sensor signal
DF029502F Rear right-hand wheel speed sensor signal
DF0555143 Vehicle parameter programming
DF06650E2 No injection multiplex signal
DF0905041 Front right-hand wheel target
DF0915042 Front left-hand wheel target
DF0925043 Rear right-hand wheel target
DF0935044 Rear left-hand wheel target
DF0965148 Computer internal electronic irregularity
DF09850E4 No UCH multiplex signal
DF1195150 Gearbox type configuration
DF121D11D Torque requested not available
DF15250E6 Multiplex network
DF18850C6 Brake light switch circuit
DF219D132 ABS multiplex signal consistency
DF2295002 Front right-hand wheel speed
DF2305011 Front left-hand wheel speed
DF2315021 Rear right-hand wheel speed
DF2325031 Rear left-hand wheel speed
DF250D117 Engine speed multiplex signal
DF251D118 Effective average torque multiplex signal
DF252D119 Torque request multiplex feedback signal
DF253D120 Recalculated torque multiplex signal
DF254D12F Resisting torque multiplex signal
DF31150E3 No BVR multiplex signal
MK70 ABS
Vdiag No: 04
MR-413-X44-38C000$423_eng.mif
38C-44
MR-413-X44-38C000$517_eng.mif
V1
ANTI-LOCK BRAKING SYSTEM
Fault finding - Interpretation of faults
MK70 ABS
Vdiag No: 04
38C
DF219
PRESENT
OR
STOREDABS MULTIPLEX SIGNAL CONSISTENCY
NOTESSpecial notes:
Although it is stored in the computer, the ABS system is not faulty.
Perform fault finding on the injection system using the diagnostic tool.
Note:
The injection computer does not always store these transient faults as quickly as the
ABS computer.
If no fault is stored in the injection computer, start the engine; if there is no fault
present, contact the Techline. After solving the injection system problem, erase
the faults from the ABS computer memory.
Conditions for applying the fault finding procedure to stored faults:
The fault is declared present when the engine is started up.
Carry out fault finding on the injection system (see MR413 Fault Finding, 13B, Diesel injection or 17B,
Petrol injection).
If the fault is still present, contact the Techline.
AFTER REPAIRClear the computer fault memory.
Carry out a road test followed by another check with the diagnostic tool.
ABS_V04_DF219
