2009 RENAULT TWINGO climate control

61A-70
HEATING
Recirculation motor: Removal - Refitting
RIGHT-HAND DRIVE, and CLIMATE CONTROL
61A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aLock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 413, 88C, Airbags and seat belt pretensioners).
aDisconnect the battery (see Battery: Removal - Re-
fitting) (MR 411, 80A, Battery).
aRemove:
-the passenger's front airbag (see Passenger's
frontal airbag: Removal - Refitting) (MR 411,
88C, Airbag and pretensioners),
-the front side air duct (see 61A, Heating, Front
side air distribution duct: Removal - Refitting,
page 61A-7) .
II - REMOVAL OPERATION FOR PART
CONCERNED
aDisconnect the connector (1) from the recirculation
motor.aRemove:
-the bolts (2) from the recirculation motor,
-the recirculation motor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
aRefit:
-the recirculation motor,
-the recirculation motor bolts.
aConnect the recirculation motor connector.
II - FINAL OPERATION.
aRefit the front side air duct (see 61A, Heating, Front
side air distribution duct: Removal - Refitting,
page 61A-7) .
aRefit the passenger's front airbag (see Passenger's
frontal airbag: Removal - Refitting) (MR 411, 88C,
Airbag and pretensioners).
aConnect the battery (see Battery: Removal - Refit-
ting) (MR 411, 80A, Battery).
aUnlock the airbag computer using the Diagnostic
tool (see Fault finding - Replacement of compo-
nents) (MR 413, 88C, Airbags and seat belt preten-
sioners). Equipment required
Diagnostic tool
124366
124370

61A-71
HEATING
Mixing motor: Removal - Refitting
LEFT-HAND DRIVE, and CLIMATE CONTROL
61A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aRemove the centre console (see Centre console:
Removal - Refitting) (MR 412, 57A, Interior equip-
ment).
aRemove the radio (see Radio: Removal - Refitting)
(MR 411, 86A, Radio).
aUnclip the glovebox.
aRemove the dashboard lower trim (see Centre front
panel: Removal - Refitting) (MR 412, 57A, Interior
equipment).
aUnclip:
-the fuse access flap (1) ,-the dashboard lower trim.
aDisconnect the connectors from the lower trim on
the dashboard (2) .
aRemove:
-the steering wheel lower cover bolts (3) ,
-the steering wheel lower cover.
aRemove:
-the bolts (4) from the strut,
-the strut. Tightening torquesm
strut bolts21 Nm
RADIO NO. 01 or RADIO NO. 03
WITH 2 SPEAKERS, WITHOUT RADIO or VEHI-
CLE WITHOUT RADIO
119506
119711
119713

61A-72
HEATING
Mixing motor: Removal - Refitting
LEFT-HAND DRIVE, and CLIMATE CONTROL
61A
II - OPERATION FOR REMOVAL OF PART
CONCERNED
aDisconnect the connector (5) from the mixer motor.
aRemove:
-the bolts (6) from the air mixing motor,
-the air mixing motor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
aRefit:
-the air mixing motor,
-the air mixing motor bolts.
aConnect the air mixing motor connector.
II - FINAL OPERATION.
aRefit:
-the strut,
-the strut bolt.
aTorque tighten the strut bolts (21 Nm).aRefit:
-the steering wheel lower cover,
-the steering wheel lower cover bolt.
aConnect the connectors to the lower trim on the
dashboard.
aClip on:
-the dashboard lower trim,
-the fuse access flap.
aRefit the dashboard lower trim (see Centre front
panel: Removal - Refitting) (MR 412, 57A, Interior
equipment).
aClip the glovebox in position.
aRefit the radio (see Radio: Removal - Refitting)
(MR 411, 86A, Radio).
aRefit the centre console (see Centre console: Re-
moval - Refitting) (MR 412, 57A, Interior equip-
ment).
aCheck that the air mixing function is operating cor-
rectly.
121173
Note:
When refitting the mixer motor, make sure that
the drive system notches are correctly posi-
tioned.
WITH 2 SPEAKERS, WITHOUT RADIO or VEHI-
CLE WITHOUT RADIO
RADIO NO. 01 or RADIO NO. 03

61A-73
HEATING
Mixing motor: Removal - Refitting
RIGHT-HAND DRIVE, and CLIMATE CONTROL
61A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aDisconnect the battery (see ) (MR 411, 80A, Bat-
tery).
aRemove the radio (see Radio: Removal - Refitting)
(MR 411, 86A, Radio).
aDisconnect the connectors (1) from the dashboard
lower trim.
aRemove the dashboard lower trim.
aRemove:
-the centre console (see Centre console: Removal
- Refitting) (MR 412, 57A, Interior equipment),
-the centre front panel (see Centre front panel: Re-
moval - Refitting) (MR 412, 57A, Interior equip-
ment).
aRemove the tweeter speakers (see Tweeter: Re-
moval - Refitting) (MR 411, 86A, Radio).aRemove the radio (see Radio: Removal - Refitting)
(MR 411, 86A, Radio).
aRemove the glovebox.
II - REMOVAL OPERATION FOR PART
CONCERNED
aDisconnect the connector (2) from the mixer motor.
aRemove the air mixing motor bolts (3) .
aMove the air mixing motor aside. RADIO NO. 01 or RADIO NO. 03
124103
WITH 2 SPEAKERS, WITHOUT RADIO or RADIO
NO. 01 or RADIO NO. 03
RADIO NO. 01 or RADIO NO. 03
WITH 2 SPEAKERS, WITHOUT RADIO or VEHI-
CLE WITHOUT RADIO
124369

61A-74
HEATING
Mixing motor: Removal - Refitting
RIGHT-HAND DRIVE, and CLIMATE CONTROL
61A
aUnclip the rod (4) from the air mixing motor by tilting
the motor downwards.
aRemove the air mixing motor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
aClip the rod onto the air mixing motor.
aFit the air mixing motor.
aRefit:
-the air mixing motor,
-the air mixing motor bolts.
aConnect the air mixing motor connector.
II - FINAL OPERATION.
aRefit the glovebox.aRefit the radio (see Radio: Removal - Refitting)
(MR 411, 86A, Radio).
aRefit the tweeter speakers (see Tweeter: Removal
- Refitting) (MR 411, 86A, Radio).
aRefit:
-the centre front panel (see Centre front panel: Re-
moval - Refitting) (MR 412, 57A, Interior equip-
ment).
-the centre console (see Centre console: Removal
- Refitting) (MR 412, 57A, Interior equipment),
aConnect the connectors to the lower trim on the
dashboard.
aRefit the dashboard lower trim.
aRefit the radio (see Radio: Removal - Refitting)
(MR 411, 86A, Radio).
aConnect the battery (see ) (MR 411, 80A, Battery).
124369
Note:
When refitting the mixer motor, make sure that
the drive system notches are correctly posi-
tioned.
WITH 2 SPEAKERS, WITHOUT RADIO or VEHI-
CLE WITHOUT RADIO
RADIO NO. 01 or RADIO NO. 03
WITH 2 SPEAKERS, WITHOUT RADIO or RADIO
NO. 01 or RADIO NO. 03
RADIO NO. 01 or RADIO NO. 03

61A-75
HEATING
Distribution motor: Removal - Refitting
LEFT-HAND DRIVE, and CLIMATE CONTROL
61A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aRemove the centre console (see Centre console:
Removal - Refitting) (MR 412, 57A, Interior equip-
ment).
aRemove the radio (see Radio: Removal - Refitting)
(MR 411, 86A, Radio).
aUnclip the glovebox.
aRemove the dashboard lower trim (see Centre front
panel: Removal - Refitting) (MR 412, 57A, Interior
equipment).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
aUnclip the distribution motor control rod (1) .
aRemove the distribution motor bolts (2) .
aDisconnect the distribution motor connector (3) .
aRemove the distribution motor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
aRefit:
-the distribution motor,
-the distribution motor bolts.
aConnect the distribution motor connector.
aClip on the distribution motor control rod.
II - FINAL OPERATION.
aRefit the dashboard lower trim (see Centre front
panel: Removal - Refitting) (MR 412, 57A, Interior
equipment).
aClip the glovebox in position.
aRefit the radio (see Radio: Removal - Refitting)
(MR 411, 86A, Radio).
aRefit the centre console (see Centre console: Re-
moval - Refitting) (MR 412, 57A, Interior equip-
ment).
aCheck that the air distribution function is operating
correctly. RADIO NO. 01 or RADIO NO. 03
WITH 2 SPEAKERS, WITHOUT RADIO or VEHI-
CLE WITHOUT RADIO
121177
Note:
When refi tting the distribution motor, make sure
that the drive system notches are correctly posi-
tioned.
WITH 2 SPEAKERS, WITHOUT RADIO or VEHI-
CLE WITHOUT RADIO
RADIO NO. 01 or RADIO NO. 03

61A-76
HEATING
Distribution motor: Removal - Refitting
RIGHT-HAND DRIVE, and CLIMATE CONTROL
61A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aRemove the centre console (see Centre console:
Removal - Refitting) (57A, Interior equipment).
aRemove the radio (see Radio: Removal - Refitting)
(86A, Radio).
aUnclip the storage compartment.
aRemove:
-the dashboard lower trim (see Centre front panel:
Removal - Refitting) (57A, Interior equipment),
-the centre front panel (see Centre front panel: Re-
moval - Refitting) (57A, Interior equipment).aRemove the upper bolts (1) from the dashboard
cross member reinforcement.
aRemove the floor carpet on the driver's side.
aRemove the lower bolts (2) from the dashboard
cross member reinforcement. Tightening torquesm
dashboard cross mem-
ber reinforcement bolts21 Nm
RADIO NO. 01 or RADIO NO. 03
WITH 2 SPEAKERS, WITHOUT RADIO or VEHI-
CLE WITHOUT RADIO
141233
141234

61A-77
HEATING
Distribution motor: Removal - Refitting
RIGHT-HAND DRIVE, and CLIMATE CONTROL
61A
II - OPERATION FOR REMOVAL OF PART
CONCERNED
aDisconnect the connector (3) from the distribution
motor.
aRemove:
-the bolts (4) from the distribution motor,
-the distribution motor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
aRefit:
-the distribution motor,
-the distribution motor bolts.
aConnect the distribution motor connector.
II - FINAL OPERATION
aRefit the dashboard cross member reinforcement.
aTorque tighten the dashboard cross member rein-
forcement bolts (21 Nm).aRefit:
-the centre front panel (see Centre front panel: Re-
moval - Refitting) (57A, Interior equipment),
-the dashboard lower trim (see Centre front panel:
Removal - Refitting) (57A, Interior equipment).
aClip the storage compartment in position.
aRefit the radio (see Radio: Removal - Refitting)
(86A, Radio).
aRefit the centre console (see Centre console: Re-
moval - Refitting) (57A, Interior equipment).
aCheck the air distribution system is operating cor-
rectly.
141232
Note:
When refitting the distribution motor, make sure
that the drive system notches are correctly posi-
tioned.
WITH 2 SPEAKERS, WITHOUT RADIO or VEHI-
CLE WITHOUT RADIO
RADIO NO. 01 or RADIO NO. 03