62B - 34
CLIMATE CONTROL
Fault finding – Interpretation of parameters62B
V3 MR-372-J84-62B000$080.mif
Vdiag No.: 44
PR121
BLOWN AIR TEMPERATURE SETTING
NOTESNone.
This parameter is used to control the temperature inside the passenger compartment. This setting is calculated
by the climate control computer according to interior temperature, exterior temperature and coolant
temperature.
This setting is used to control the mixing motor and the request to operate the passenger compartment air
heating resistors (to reach the temperature requested by the user as quickly as possible in order to optimise
passenger compartment comfort quickly).
The following conditions must be satisfied to allow the UCH to control the passenger compartment air heating
resistors:
–Engine running,
–Passenger compartment blower running (minimum speed 1),
–User temperature setting above 20 ˚C (or automatic mode requested),
–Blown air temperature setting above 65 ˚C,
–Interior temperature below 10 ˚C,
–Exterior temperature below 5 ˚C,
–Engine coolant temperature below 65 ˚C,
–Injection authorisation (ET019 Number of RCHs authorised by injection system < at 1),
–Alternator authorisation (ET018 Number of RCHs authorised by alternator < at 1).
Note:
–Statuses ET017, ET018 and ET019 are indicated by the UCH (see conformity check of air conditioning
function: Section 62A).
–The values given below are average values. The UCH calculates the number of passenger compartment
heating resistors to trigger (ET017 number of RCH required).
AFTER REPAIRRepeat the conformity check from the start.
ACREG X84 1.1
Edition 2
