2009 Ram 1500 spare tire location

Tire Loading and Tire Pressure
Tire Placard Location
NOTE:The proper cold tire inflation pressure is listed
on the driver’s side B-Pillar.
Tire and Loading Information Placard
This placard tells you important information about
the:
1) number of people that can be carried in the vehicle
2) total weight your vehicle can carry
3) tire size designed for your vehicle
4) cold tire inflation pressures for the front, rear, and
spare tires.
Loading
The vehicle maximum load on the tire must not exceed
the load carrying capacity of the tire on your vehicle. You
will not exceed the tire’s load carrying capacity if you
adhere to the loading conditions, tire size, and cold tire
inflation pressures specified on the Tire and Loading
Information placard and in the “Vehicle Loading” section
of this manual.
Tire and Loading Information Placard
5
STARTING AND OPERATING 367

WHAT TO DO IN EMERGENCIES
CONTENTS
Hazard Warning Flasher ................ 420
 Jacking And Tire Changing ............... 420
▫ Jack Location ....................... 421
▫ Removing The Spare Tire ............... 426
▫ Preparations ........................ 427
▫ Instructions ........................ 428
 Hoisting ............................ 433 
Jump-Starting Procedures ................ 433
▫ With Portable Starting Unit ............. 435
 Freeing A Stuck Vehicle ................. 436
 Emergency Tow Hooks — If Equipped ...... 437
 Towing A Disabled Vehicle ............... 437
▫ 4-Wheel Drive Vehicles ................ 438
▫ 2-Wheel Drive Vehicles ................ 438
6

•For all trucks, when changing a rear wheel, as-
semble the jack drive tube to the jack and connect
the drive tube to the extension tube. Place the jack
under the axle between the wheel and the shock
bracket with the drive tubes extending to the rear.•Connect the jack tube extension and wheel wrench.
Before raising the wheel off the ground, make sure
that the jack will not damage surrounding truck
parts and adjust the jack position as required.
4. Raise the vehicle until the wheel just clears the surface,
by rotating the wheel wrench clockwise
WARNING!
Raising the vehicle higher than necessary can make
the vehicle unstable and cause an accident. It could
slip off the jack and hurt someone near it. Raise the
vehicle only enough to remove the tire.
5. Remove the wheel nuts and pull the wheel off. Install
the spare wheel and wheel nuts with the cone shaped end
of the wheel nuts toward the wheel. Lightly tighten the
Rear Jacking Location (All)
430 WHAT TO DO IN EMERGENCIES