2009 Ram 1500 seats

then allow the belt to retract into the retractor. For
additional information on ALR, refer to “Automatic
Locking Mode” in this section.
To install a child restraint, first, pull enough of the seat
belt webbing from the retractor to route it through the
belt path of the child restraint and slide the latch plate
into the buckle. Next, extract all the seat belt webbing out
of the retractor and then allow the belt to retract into the
retractor. Finally, pull on any excess webbing to tighten
the lap portion around the child restraint. Any seat belt
system will loosen with time, so check the belt occasion-
ally, and pull it tight if necessary.
Child Restraint Tether Anchor
Child restraints having tether straps and hooks for con-
nection to tether anchors have been available for some
time. In fact, many child restraint manufacturers will
provide add-on tether strap kits for their older products.
Regular Cab models have two tether anchorages, oneeach behind the front center and right seats. Quad Cab
and Crew Cab models have three anchorages, one behind
each of the rear seats.
WARNING!
An incorrectly anchored tether strap could lead to
seat failure and injury to the child. In a collision, the
seat could come loose and allow the child to crash
into the inside of the vehicle or other passengers, or
even be thrown from the vehicle. Use only the anchor
positions directly behind the child seat to secure a
child restraint top tether strap. Follow the instruc-
tions below. See your authorized dealer for help if
necessary.
76 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Tether Anchorage Points at the Right and Center
Front Seat (Regular Cab - All Seats)
1. Place the child restraint on the seat and adjust the
tether strap so that it will reach over the seat back under
the head restraint to the tether anchor directly behind the
seat.
2. Lift the cover (if so equipped), and attach the hook to
the square opening in the sheet metal.
3. Install the child restraint and remove the slack in the
tether strap according to the manufacturer’s instructions.
Regular Cab Tether Strap Mounting
1 — Tether Strap Hook
2 — Tether Strap to Child Restraint
3 — Tether Anchor
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 77

Multiple Child Restraint Installation Sequence
(Quad Cab/Crew Cab - Rear Seats)
1. Obtain tether straps by raising the head restraints and
reaching between the rear glass and rear seat. The tether
strap may be retained with an elastic band. Accessibility
to the tether strap is greatly improved by raising the seat
cushion to the “up” position. Remove the elastic before
use.
78 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Children Too Large for Booster Seats
Children who are large enough to wear the shoulder belt
comfortably, and whose legs are long enough to bend
over the front of the seat when their back is against the
seat back should use the lap/shoulder belt in a rear seat.
•Make sure that the child is upright in the seat.
•The lap portion should be low on the hips and as snug
as possible.
•Check belt fit periodically. A child’s squirming or
slouching can move the belt out of position.
If the shoulder belt contacts the face or neck, move the
child closer to the center of the vehicle. Never allow a
child to put the shoulder belt under an arm or behind
their back.
Transporting Pets
Airbags deploying in the front seat could harm your pet.
An unrestrained pet will be thrown about and possibly injured, or injure a passenger during panic braking or in
a collision. Pets should be restrained in the rear seat in
pet harnesses or pet carriers that are secured by seat belts.
ENGINE BREAK-IN RECOMMENDATIONS
A long break-in period is not required for the engine in
your vehicle.
Drive moderately during the first 300 miles (500 km).
After the initial 60 miles (100 km), speeds up to 50 or
55 mph (80 or 90 km/h) are desirable.
While cruising, brief full-throttle acceleration within the
limits of local traffic laws, contributes to a good break-in.
Wide-open throttle acceleration in low gear can be detri-
mental and should be avoided.
The engine oil installed in the engine at the factory is a
high-quality energy conserving type lubricant. Oil
changes should be consistent with anticipated climate
conditions under which vehicle operations will occur.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 81

The recommended viscosity and quality grades are
shown in Section 7 of this manual. NON-DETERGENT
OR STRAIGHT MINERAL OILS MUST NEVER BE
USED.
A new engine may consume some oil during its first few
thousand miles (kilometers) of operation. This should be
considered a normal part of the break-in and not inter-
preted as an indication of difficulty.
SAFETY TIPS
Transporting Passengers
NEVER TRANSPORT PASSENGERS IN THE CARGO
AREA.
WARNING!
•It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision, people
riding in these areas are more likely to be seri-
ously injured or killed.
•Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat
belts.
•Be sure everyone in your vehicle is in a seat and
using a seat belt properly.
82 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

▫General Information .................. 127
 Voice Recognition (VR) System —
If Equipped .......................... 127
▫ Voice Recognition (VR) System Operation . . . 127
▫ Commands ........................ 129
▫ Voice Training ...................... 132
 Seats .............................. 132
▫ Manual Seat Adjuster — If Equipped ...... 133
▫ Manual Reclining Seats — If Equipped ..... 134
▫ Adjustable Head Restraints ............. 136
▫ Eight-Way Power Seats — If Equipped ..... 136
▫ Power Lumbar — If Equipped ........... 138
▫ Heated Seats — If Equipped ............ 138▫
Ventilated Seats — If Equipped .......... 140
▫ 40-20-40 Front Bench Seat — If Equipped . . . 140
 Driver Memory Seat — If Equipped ........ 141
▫ Setting Memory Positions And Linking RKE
Transmitter To Memory ................ 141
▫ Memory Position Recall ................ 142
▫ To Disable a RKE Transmitter Linked To
Memory ........................... 143
▫ Self-Limiting Control .................. 144
▫ Driver Easy Exit And Easy Entry Control . . . 144
 To Open And Close The Hood ............ 145
 Lights ............................. 146
▫ Headlights ......................... 147
▫ Automatic Headlights — If Equipped ...... 147
88 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

▫Venting Sunroof — Express ............. 182
▫ Sunshade Operation .................. 182
▫ Wind Buffeting ...................... 183
▫ Sunroof Maintenance ................. 183
▫ Sunroof Fully Closed .................. 183
 Electrical Power Outlets ................. 183
 Cigar Lighter And Ash Receiver —
If Equipped .......................... 187
 Power Inverter — If Equipped ............ 188
 Cupholders .......................... 189
▫ Front Instrument Panel Cupholders —
(40–20–40 Seats) ..................... 189
▫ Front Instrument Panel Cupholders — Floor
Mounted Shifter ..................... 190 ▫
Rear Cupholder — Quad Cab .......... 190
▫ Rear Cupholder — Crew Cab ........... 191
 Storage ............................. 191
▫ Glove Box Storage ................... 191
▫ Door Storage ....................... 193
▫ Center Storage Compartment —
If Equipped ........................ 194
▫ Second Row In-Floor Storage Bin —
If Equipped ........................ 196
▫ Seatback Storage ..................... 197
▫ Storage (Regular Cab) ................. 197
▫ Storage And Seats (Crew Cab) ........... 198
▫ Plastic Grocery Bag Retainers
(Regular Cab Models) ................. 198
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 91

NOTE:Keep in mind that you have to press the VR
button first and wait for the beep before speaking the
“Barge In” commands.
Voice Training
For users experiencing difficulty with the system recog-
nizing their voice commands or numbers, uconnect
phone Voice Training feature may be used.
1. Press the VR button, say “System Setup” and once you
are in that menu then say “Voice Training.” This will train
your own voice to the system and will improve recogni-
tion.
2. Repeat the words and phrases when prompted by
uconnect phone. For best results, the Voice Training
session should be completed when the vehicle is parked,
engine running, all windows closed, and the blower fan
switched off. This procedure may be repeated with a new
user. The system will adapt to the last trained voice only.
SEATS
Seats are a primary part of the Occupant Restraint System
of the vehicle. They need to be used properly for safe
operation of the vehicle.
WARNING!
•It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision, people
riding in these areas are more likely to be seri-
ously injured or killed.
•Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat
belts.
•Be sure everyone in your vehicle is in a seat and
using a seat belt properly.
132 UNDERSTANDING THE FEATURES OF YOUR VEHICLE