2009 Ram 1500 heater

STARTING AND OPERATING
CONTENTS
Starting Procedures .................... 309
▫ Normal Starting ..................... 309
▫ Automatic Transmission ............... 309
▫ If Engine Fails To Start ................ 310
▫ After Starting ....................... 311
 Engine Block Heater — If Equipped ........ 311
 Automatic Transmission ................. 312
▫ Key Ignition Park Interlock ............. 312
▫ Brake/Transmission Shift Interlock System . . 313 ▫
Brake/Transmission Interlock Manual
Override .......................... 313
▫ Four–Speed Automatic Transmission —
If Equipped ........................ 315
▫ Five–Speed Automatic Transmission —
If Equipped ........................ 320
 Four-Wheel Drive Operation — If Equipped . . 326
▫ Electronically Shifted Transfer Case
(Four-Position Switch) — If Equipped ...... 327
▫ Shifting Procedure ................... 331
5

If the engine has been flooded, it may start to run, but not
have enough power to continue running when the key is
released. If this occurs, continue cranking with the accel-
erator pedal pushed all the way to the floor. Release the
accelerator pedal and the key once the engine is running
smoothly.
If the engine shows no sign of starting after two 15-
second periods of cranking with the accelerator pedal
held to the floor, the “Normal Starting” procedure should
be repeated.
After Starting
The idle speed is automatically controlled and will de-
crease as the engine warms up.
ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms the engine and permits
quicker starts in cold weather. Connect the cord to a
standard 110-115 Volt AC electrical outlet with a
grounded, three-wire extension cord.The engine block heater cord is routed under the hood on
the passenger side of the vehicle near the right head lamp
assembly. It is located between the front grill and the
radiator, but underneath the black upper seal.
It includes a removable cap that is secured by a tethered
strap. It also has a c-clip that is used for storage when not
in use for the winter months. During winter months,
remove the heater cord wiring assembly from itself on
the c-clip.
WARNING!
Remember to disconnect the cord before driving.
Damage to the 110-115 Volt electrical cord could cause
electrocution.
5
STARTING AND OPERATING 311

•Some additives used in regular gasoline are not fully
compatible with E–85 and may form deposits in your
engine. To eliminate driveability issues that may be
caused by these deposits, a supplemental gasoline
additive, such as MOPARInjector Cleanup or
Techron may be used.
Selection Of Engine Oil For Flexible Fuel Vehicles
(E-85) and Gasoline Vehicles
FFV vehicles operated on E-85 require specially formu-
lated engine oils. These special requirements are included
in MOPAR engine oils, and in equivalent oils meeting
Chrysler Specification MS-6395. The manufacturer only
recommends engine oils that are API Certified and meet
the requirements of Material Standard MS-6395. MS-6395
contains additional requirements, developed during ex-
tensive fleet testing, to provide additional protection to
Chrysler LLC engines. Use MOPAR or an equivalent oil
meeting the specification MS-6395.
Starting
The characteristics of E-85 fuel make it unsuitable for use
when ambient temperatures fall below 0°F (-18°C). In the
range of 0°F (-18°C) to 32°F (0°C), you may experience an
increase in the time it takes for your engine to start, and
a deterioration in driveability (sags and/or hesitations)
until the engine is fully warmed up.
NOTE: Use of the engine block heater (if equipped) is
beneficial for E-85 startability when the ambient tempera-
ture is less than 32°F (0°C).
Cruising Range
Because E-85 fuel contains less energy per gallon/liter
than gasoline, you will experience an increase in fuel
consumption. You can expect your miles per gallon
(mpg)/miles per liter and your driving range to decrease
by about 30%, compared to gasoline operation.
5
STARTING AND OPERATING 393

1. Remove all metal jewelry such as watch bands or
bracelets which might make an unintended electrical
contact.
2. Park the booster vehicle within cable reach but with-
out letting the vehicles touch. Set the parking brake on
both vehicles, place the automatic transmission in PARK
and turn the ignition OFF.
3. Turn off the heater, radio, and all unnecessary electri-
cal loads.
4. Connect one end of a jumper cable to the positive
terminal of the booster battery. Connect the other end of
the same cable to the positive terminal of the discharged
battery.WARNING!
Do not permit vehicles to touch each other as this
could establish a ground connection and personal
injury could result.
5. Connect the other cable; first to the negative terminal
of the booster battery, and then to the engine of the
vehicle with the discharged battery. Make sure you have
a good contact on the engine.
WARNING!
•You should not try to start your vehicle by pushing
or towing.
•Do not connect the cable to the negative post of the
discharge battery. The resulting electrical spark
could cause the battery to explode. (Continued)
434 WHAT TO DO IN EMERGENCIES

Electronic Speed Control (Cruise Control)...... 160
Electronic Stability Program (ESP) ............ 356
Electronic Vehicle Information Center
(EVIC) ............................. 168,244
Electronically Shifted Transfer Case ........327,333
Emergency Brake ........................ 346
Emergency, In Case of Freeing Vehicle When Stuck ............... 436
Hazard Warning Flasher ................. 420
Jump Starting ......................... 433
Tow Hooks .......................... 437
Towing ............................. 437
Emission Control System Maintenance ......445,492
Engine .......................... 441,442,443
Air Cleaner .......................... 450
Block Heater ......................... 311
Break-In Recommendations ................ 81
Compartment Identification .........441,442,443
Coolant (Antifreeze) .................... 489 Exhaust Gas Caution
.................. 83,390
Flooded, Starting ...................... 310
Fuel Requirements ..................... 488
Multi-Displacement .................... 349
Oil ........................... 448,488,489
Oil Filler Cap ......................... 449
Oil Selection ....................... 449,488
Oil Synthetic ......................... 450
Temperature Gauge .................... 227
Enhanced Accident Response Feature .......... 64
Event Data Recorder ...................... 67
Exhaust Gas Caution ................83,390,456
Exhaust System ....................... 83,455
Exterior Lighting ........................ 147
Exterior Lights .......................... 85
Filters Air Cleaner .......................... 450
Engine Oil ........................ 450,489
526 INDEX

Heated Mirrors....................... 97,199
Heated Seats ........................... 138
Heater ............................... 293
Heater, Engine Block ..................... 311
High Beam/Low Beam Select (Dimmer) Switch . . 153
Hitches Trailer Towing ........................ 403
Hoisting .............................. 433
HomeLink (Garage Door Opener) Transmitter . . . 174
Hood Release .......................... 145
Ignition ............................... 14
Key ............................... 12,14
Ignition Key Removal ..................... 14
Illuminated Entry ........................ 19
Immobilizer (Sentry Key) ................... 15
Infant Restraint .......................... 69
Inflation Pressure Tires .................... 377
Information Center, Vehicle ................. 244 Inside Rearview Mirror
.................... 93
Instrument Cluster ................. 223,225,227
Instrument Panel and Controls .............. 222
Instrument Panel Lens Cleaning ............. 474
Integrated Power Module (Fuses) ............ 475
Interior Appearance Care .................. 472
Interior Lights .......................... 149
Intermittent Wipers (Delay Wipers) ........... 154
Introduction ............................. 4
Inverter Outlet (115V) ..................... 188
Jack Location ........................... 420
Jump Starting .......................... 433
Key, Programming ........................ 17
Key, Replacement ........................ 16
Key, Sentry (Immobilizer) ................... 15
Key-In Reminder ......................... 15
Keyless Entry System ...................... 20
10
INDEX 529