Page 187 of 310
Mobile Roofs
185
Opening side flaps “F”
1. Remove ignition key.
2. Use the screwdriver to remove plastic lid E
from the lining from behind. 3. Insert Allen key B into the drive axle for the left
side flap F.
Turn Allen key counterclockwise (in direction of
arrow) until the side flap F is fully open (percep-
tible stop).
4. Repeat procedure with the right side flap.
Remove the Allen key.
Warning!
The Allen key can rotate or fly out and there-
by cause serious personal injury if the con-
vertible top is actuated.
fAlways remove the Allen key B from the drive
axle of the side flap before operating the con-vertible top.
fWhen you have opened the side flaps, try to
close the convertible top using the switch.
If the convertible top cannot be closed, contin-
ue with emergency operation.
Page 188 of 310
186
Mobile Roofs Closing convertible top
1. Insert Allen key B through hole G and into the
hydraulic valve.
Turn Allen key B counterclockwise by approx.
1 revolution.
Always remove Allen key B. 2. Get behind the front seats and grasp the con-
vertible top in the middle. 3. Close the convertible top until it reaches its
highest position.
Page 189 of 310
Mobile Roofs
187
The convertible top lock with the locking hook is
fitted on the convertible top.
Perform the work on the convertible top lock when
standing on the right-hand side of the vehicle. Extending the locking hook “H”
1. Pull the plastic lid J down on the front corners.
Push the lid carefully to the rear and take it off.2. Take the Allen key K out of the oddments tray
between the front seats.
3. Insert the Allen key K into the opening L and
turn in the direction of arrow “open” until
marked resistance can be felt.
The locking hook H is now extended.
4. Pull out the Allen key K.
Page 190 of 310
188
Mobile Roofs 5. Pull the convertible top all the way forward to
the windshield.
Locking the locking hook “H” in the
windshield frame
fWhen locking the convertible top, make sure
that the locking hook engages in the
windshield frame. Pull the convertible top to
the windshield frame if necessary.
The centering journals M must be retracted
into the mounting in the windshield frame.1. Insert the Allen key again.
Turn in the direction of arrow “close” until you
can feel marked resistance and the convertible
top is completely locked.
2. Remove the Allen key.Mounting the plastic lid
fPush the plastic lid over the convertible top
locking mechanism from behind.
The lid must engage centred in the guide N.
Push the lid upwards at its front edge and
engage.
Warning!
Risk of injury in an accident.
fDo not drive without the plastic lid mounted.
Page 191 of 310
Mobile Roofs
189
Closing the convertible-top compartment lid
Warning!
Risk of pinching when closing the
convertible-top compartment lid.
fPlace your hands on the convertible-top compartment lid when pushing.
1. Stand behind the vehicle.
2. Grasp the convertible-top compartment lid
above the brake light and push forward against
resistance which can be felt until it is
completely closed.
Caution!
Risk of damage to the convertible top.
fAfter emergency operation, do not operate the
convertible top using the switch.
fDrive slowly to an authorized Porsche dealer in order to have the fault remedied.
Page 196 of 310
194
Mobile Roofs
Hardtop Your authorized Porsche dealer will be glad to give
advice about correct hardtop storage.
Since the convertible top stays open for a long
time, it must be absolutely dry and clean before
being opened to install the hardtop.
This prevents damp stains and abrasion damage.
fMake sure that the hardtop is placed on a
clean, soft surface.
Removing the hardtop 1. Open all four side windows.
2. Pull off plastic cover of the front hardtop lock
(arrow).
3. Press red locking button A of the front locking
lever.
Fully open locking lever B.
Page 198 of 310
196
Mobile Roofs 11.Carefully remove both protection covers J to
the rear.
12.Fit both plastic covers C into the trim panel.
The marking point must point to the rear.
These covers are also used with the hardtop.
13.Close front locking lever.
Push on plastic cover of the front hardtop lock.
Putting on the hardtop
Caution!
Risk of damage to the windstop and hardtop.
fAlways remove the windstop before fitting the
hardtop.
Please see the chapter “WINDSTOP” on Page 190.1. Open all four side windows and convertible
top.
2. Take unlocking handle D from the storage tray
between the front seats.
Position unlocking D on the point marking.
Carefully remove both plastic covers C on both
sides of the hardtop.
3. Carefully fit both protective covers J into the
trim panel from behind.
Page 200 of 310
198
Mobile Roofs 6.Check whether the rear screw connections on
the hardtop are loosened (turn it 2 turns clock-
wise).
7. Together with a second person on the other
side, grasp the hardtop at points E and F.
8. Carefully lift the hardtop up and over the vehi-
cle from behind.
Warning!
Danger of pinching fingers or hands at the
points “F”.
fEvenly lower the hardtop at both sides.
9. First push the hardtop completely into the
guides on the windshield frame.
Then carefully lower the hardtop into the lock-
ing elements at the rear.
Caution!
Danger of damage due to inadvertent opera-
tion of the convertible top with the hardtop
fitted.
fMake sure that the front locking lever G is al-
ways correctly locked.This disables the convertible top drive.